HVAC UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS.  please anwer all the subquestions. thank you.  3. Air at 22°C db & SATURATED Solve for the following: a. RH b. DPT c. V d. h e. RH

Q: A moist air is at a temperature of 21 deg.C (Psat = 2.4861 kPa) under a pressure of 75 kPa. The dew…

A: Given: The temperature of the moist air, T = 21 deg The saturation pressure of the air,  Psat =…

Q: . A system is needed to be designed as damped spring mass system. Calculate the amplitude of…

A:

Q: A piston-cylinder assembly contains 2 lb of water, initially at 100 lbf/in.2 and 350°F. The water…

A:

Q: 3. The blocks shown below slide together down the incline at the same acceleration. The coefficient…

A: Given Datamd=20kgmf=25kgθ=50°μd=0.5μf=0.1g=9.81 m/s2

Q: The bar has a constant width of 30 mm and a thickness of 10 mm. Determine the maximum normal stress…

A: Given: width of bar = 30 mm thickness of bar = 10 mm To determine: largest normal stress

Q: At room temperature (20°C), a 0.5-mm gap exists between the ends of the rods shown. The temperature…

A:

Q: Current Attempt in Progress A flywheel whose moment of inertia / = 200 lb-ft² is spinning at 190…

A:

Q: Given specifications for a product's length at 180 meters +/- 15 meters, which of the following…

A: Given data: Length=180-15+15 m Need to choose the False statement.

Q: What additional force must be added to the hook at A for it to be in static equilibrium? Express…

A:

Q: A piston-cylinder assembly contains 0.5 lb of propane. The propane expands from an initial state…

A: Given Data The mass of the propane is: m=0.5 lb The initial pressure is: p1=60 lbf/in2=8640 lbf/ft2…

Q: According to the National Wildlife Federation, the polar bear is the largest terrestrial carnivore…

A:

Q: write vector loop equation(s) theta2=57 also if a new length is constructed find its value.

A:

Q: The man pulls on the rope at C with a force of 80 lb which causes the forces FA and FC at B to have…

A: Given data: Force in cable BA=FA=80lbForce in cable BC=FB=80lb Need to determine the magnitude of…

Q: t Calculate the three lowest natural frequencies of a solid 20 cm radius steel shaft (G=80* 10'…

A: Given data :- Solid radius = 20 cm Shear modulus = 80 × 10^9 N/m^2 Density = 7500 kg/m^3 Length  =…

Q: 2. A pressure gagê registers 50 psi, in a region where there barometer is 14.25 psigtm. Find the…

A: Given:Pressure registered by pressure gauge, Pg=50 psigBarometric pressure, Patm=14.25 psi

Q: Lifting cable danger. Cranes are used to lift steel beams at construction sites (Figure a). Let's…

A:

Q: A thin rod 5 mm diameter is held between two chucks 0.8 m apart and deflects 0.5mm under its static…

A:

Q: A piston-cylinder assembly contains 0.5 lb of air initially at a pressure of 30 lb/in² and a…

A: Given data: m=0.5 lbP1=30 lbf/in2T1=200°Fk=1.4V2=2V1 Need to determine the work done and heat…

Q: 1.41 A new absolute temperature scale is proposed. On this scale the ice point of water is 150°S and…

A:

Q: A hollow shaft having 100 mm and 60 mm outside and inside diameter, respectively is subjected to a…

A: Given data: do=100 mmdi=60 mmT=6 kN.mM=2.5 kN.m Need to determine the maximum bending stress…

Q: A Texas rancher wants to fence off his four-sided plor of fiet land. He measures the find three…

A:

Q: The bracket which is fastened to a wall by anchor bolts at A and B is loaded by the forces P=120N…

A: Given data: P=120 N C=140 N-m

Q: The bar has a constant width of 30 mm and a thickness of 10 mm. Determine the maximum normal stress…

A: Given data- A bar is given subjected to force system shown in fig We have to find maximum normal…

Q: a=1850 I f=100 A b=750 C B O c=67 dimensions en mm d=990 X ✓e=594

A:

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A:

Q: 5 A cylindrical workpiece is forged in an open die. The workpiece is 60 mm in diameter and 30 mm…

A:

Q: (b) What is the spring's velocity when t=0?

A: Spring- Spring is a mechanical device which stores mechanical potential energy, when deformed by…

Q: The uniform beam is supported by two rods AB and CD that have cross-sectional areas 10 mm² and 15…

A:

Q: 0.2 m 0.7 m 0.6 m 0.9 m 0.4 m 0.3 m C 0.9 m B 0.6 m 0.35 m 0.4 m 0.6 m Fig. P3.59 and P3.60 3.60 The…

A: Given that: Force along CF is 33 N. It is required to determine the moment of the force along the…

Q: A helical compression spring has a scale of 400 lb/inch, an inside diameter of 2.5 inches, a free…

A: Given       Diameter, d = 2.5 in        Weight, W = 400 lb/in Working stress = 63 ksi      Free…

Q: A hot-water pipe (k = 50 W/m K) for house heating in winter season, made of 3/4-inch schedule 40…

A: The given information in the problem is represented in the following attached image:

Q: Due Feb If block A is moving up with speed of 1 m/s and has an acceleration equal to 2 m/s. find the…

A: given; speed of block A (VA)=1m/sacceleration of block A (aA)=2m/s2equation of motion for block…

Q: : 3 4500 m³ / hr of air at 45 ° C DBT and 10 % RH enters an evaporative air cooler . The air leaves…

A: Given-Information:- Volume Flow Rate, V = 4500 m3/hr Dry Bulb Temperature, T1 = 45°C Relative…

Q: A stone is dropped from a balloon which rises vertically at a constant rate for 4 seconds from the…

A: Given data: t1=4 sect2=10 sec Need to determine the velocity of the balloon when the stone is…

Q: A specimen has a yield strength of 1390 psi at room temperature (70 degrees F) and 910 psi when it…

A: Introduction: The yield strength of a material is the strength beyond which the material begins to…

Q: A wheel is mounted on a shaft (G= 80x10^9 N/m^2) of length 3 m and radius 1 cm. The wheel is rotated…

A:

Q: Determine the volume change, in ft3, when 1 lb of water, initially saturated liquid, is heated to…

A: Given:- Mass of water (m) = 1 lbsaturated liquid is being heated to saturated vapor at constant…

Q: Q4: Assuming f-0.020, determine the discharge in the pipes. Neglect minor losses. Pipe Diameter AB…

A:

Q: hat is the longitudinal stiffness of a steel bar (E = 200 x 109 N/m2) with a length of 2.3 m and a…

A: Given:Youngs modulus, E=200*109 N/m2Length, L=2.3 mRectangular cross-section, A=5 cm x 6 cm

Q: The annual fixed costs for insulating a certain steam pipe installation can be expressed as Cf = 30S…

A: GivenCf=30S+40     dollar /yearCp=100/s       dollar /year

Q: If the base of the triangles is below the surface of 20 degrees Celsius of water determine the…

A: Givenh=4mb=3m

Q: A hollow circular shaft has an outer diameter of 100 mm and a wall thickness of 25 mm. The allowable…

A: Introduction The generalized torsional…

Q: Two and one half pounds of air (R=53.3) follow a polytropic process. At initial conditions the…

A: Given Initial temperature, T1 = 470oF  Final temperature, T2 = 140oF Initial pressure, P1 = 85 psia…

Q: Kinematic Diagram of a Slider-Crank Mechanism (Figure 1-01) A. Draw the line diagram B. Compute the…

A:

Q: please anwer all the subquestions. thank you.  1. Air at 30°C db & 50% RH Solve for the following:…

A: Given: Dry bulb temperature of air: →DBT=30°C Relative humidity: →RH=50% At the above condition:…

Q: An epicyclic reduction gear shown in figure, has a shaft A fixed to arm. The arm has a pin fixed to…

A:

Q: 4. The inner wall of a thermos bottle is at 32°F while the outer at 102.0°F. The space between the…

A: Given data: Ti=32°F=273 KTo=102°F=312 Kε=0.1A=700 cm2=700×10-4 m2 Need to determine the energy…

Q: What is the deformation response factor for an undamped system with a stiffness of 59kN/m and a mass…

A:

Q: Mech Acceleration in one dimension TW-16 6. Carts A and B move along a horizontal track. The strobe…

A: Given: Cart A and Cart B with their distance over time schematic  To find: relation between VA and…

Q: Design the diameter of a steel pipe to carry water having kinematic viscosity v=10 m²/s with a mean…

A: