HW1- Use superposition theorem to find the voltage v in the circuitshown below.823 A6 V2- For the circuit shown below, find the value of i, usingsuperposition theorem.24 V8Ω4Ωwww42www12 V3ΩЗА

Given:- R1=8 ΩR2=4 ΩI=3AV=6 V Find:- The voltage V in 4-ohm resistance

Answered: HW 1- Use superposition theorem to find…

Science

Physics

HW 1- Use superposition theorem to find the voltage v in the circuit shown below. 8Ω 6 V 42 ЗА

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.21P: Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0...

See similar textbooks

Related questions

Q: How does Ohm's law help us? 3-5 sentences

A: We have to write How does Ohm's law help us.

Q: Construct Your Own Problem. Consider a battery used to supply energy to a cellular phone. Construct…

A: Generally the capacity of the battery of a smart phone is 3000 mAh. The voltage is 12 V. The energy…

Q: Do batteries in a circuit always supply power to a circuit, or can they absorb power in a circuit?…

A: An ideal voltage source can supply current at a fixed voltage, where the current is positive from…

Q: For the following circuit in the figure below. Determine Vp-Va ( in units of V) for ɛ = 38.6 V. a 5Ω…

A: The Modified ckt is shown in figure. To find Vb-Va We need to find the voltage drop across 5ohm…

Q: Ohms Law: You are designing a 3D printer lab. You will be equiping it with Dremel 3D45 printers.…

A: Given, For a printer, Average current, I =2.2 A AC source voltage, V=120V

Q: 2. Determine the equivalent resistance between A and B in the figure below. R,=42 R,=32 R,=42 R,-10

Q: MATERIALS AND EQUIPMENT: 22-ohm resistor, 10 watt 39-ohm resistor, 10 watt 47-ohm resistor, 10 watt…

Q: Power, Current, Voltage & Resistance The most basic Power relationship is: P = I x V However, using…

A: current (I) = 2.25 A V = 9 volts R each = 2 ohm R equivalent = 2+2 = 4 ohm Using , power = V2/R…

Q: A node from a circuit is shown below: hat is the correct magnitude and direction of Is? C. 4-2A d.…

A: The diagram of the node is shown below.

Q: Consider the circuit shown in the figure below, where R, = 7.00 Q, R, = 5.00 N, and Ɛ = 12.0 V. %3D

A: The equivalent resistance of the circuit can be calculated as follows:

Q: Simple routine measurements of voltage and current can help determine if there are problems in an…

A: When Voltage and current are measured over time, we can find faults in faulty wiring, electrical…

Q: The circuit below includes a battery, capacitor, light bulb, and switch. Describe what happens to…

A: Required :: What happens to the flow of charge through the bulb.

Q: What is the smallest capacitor needed in a computer power supply in order to produce at least 4.45 V…

A: Resistance= R= 6 Ohms Motherboard voltage= V= 5volts Time = t =0.21 sec

Q: The circuit shown in Figure contains two batteries and three resistors. Find the current I3.

A: By kvl we know that i1= i2 +i3 For 1st loop - By kcl - 12- 4i1-2i3 = 0 12 = 4i1 + 2i3…

Q: Give a simple example of how the potential difference would be measured in a circuit.

Q: Create a question about the charge stored in the battery of your cell phone or another device you…

Q: Question No. 1 Determine the voltage vo and current i, in the circuit shown below. (3 + C) A 2Ω V%…

A: Here given the circuit diagram with c = 2 and d= 8 We have to calculate the voltage v0 and current…

Q: For the following circuit in the figure below. Determine Vp-Va ( in units of V) for ɛ = 48.5 V. a 22…

Q: 2. Given a set of four 1.5-V cells. Show by means of a diagram how you would connect the four cells…

Q: Refer to the figure 2. Two electrolytic capacitors are connected in series across a 12-volt supply.…

A: Two capacitors are connected in series connection. So equivalent capacitance of them(Ceq)…

Q: If the potential across a circuit is 40V and the current is 5,000 mA, what is the equivalent…

Q: Charge flowing through this circuit is most energized at ____. Choose the one best answer. a. the +…

A: Charge is flowing through a circuit and it flows from positive terminal of the battery to the…

Q: A fully charged capacitor C is attached to the resistor R through a switch S. The voltmeter reading…

Q: If you determine that the resistance of a resistor is 33 Ω, what does that tell you about the…

A: According to the Ohm’s Law:Potential difference across the ends of a resistor is directly…

Q: What is the smallest capacitor needed in a computer power supply in order to produce at least 4.35 V…

A: Given:- VC=4.35 t=0.29 sec R=6 ohms the power supply of 5 volt means Vs=5 volt Find:- What is…

Q: For the following circuit in the figure below. Determine Vp-Va ( in units of V) for ɛ = 46.7 V. a 52

A: The solution can be given as follows :-

Q: The stockroom only has 20 ohms and 50 ohms resistors. You can use as many of each as you want. A.…

Q: It is often said that “circuit elements in parallel get the same voltage.” This sentence is not…

A: If two terminals of circuit elements are connected to same pair of nodes, they are said to be…

Q: For the following circuit in the figure below. Determine Vp-Va ( in units of V) for ɛ = 40.6 V. %3D

A: Let I1, I2 and I3 are the currents leaving from the junction. By Kirchoff's junction rule,…

Q: A student set up a simple circuit with an ohmic lightbulb, battery and switch. battery switch light…

Q: Complete the table below to describe how each magnitude (ignore + / - ) changes (increases/…

A: We have to know about capacitance.

Q: For the following circuit in the figure below. Determine Vp-Va ( in units of V) for & = 33.5 V. %3D

A: the answer is option b

Q: 3. For the circuit shown below, use Kirchhoff's voltage law to find the voltage in the circuit…

Q: What is the voltmeter reading when resistors are in parallel connecti

A: Introduction: A voltmeter is an electrical device which use to measure the potential difference…

Q: heater toaster grill A (b) If the circuit is protected with a 27.0-A circuit breaker, will the…

Q: What are non ohmic resistors? Give one example.

A: The conductors which do not obey Ohm's law are called the non-ohmic conductors or non-linear…

Q: Based on the circuit drawn below: (Please use your VIRP chart) R1 = 15 2 V = 120 V R2 20 2

Q: 12. How does the voltage supplied to the resistor compare with the voltage supplied by the battery…

A: 12) Transformers work on the principle of electromagnetic induction.This electromagnetic induction…

Q: In the circuit shown the switch S can be open or closed. Case 1: Switch is closed. (Capacitor is in…

A: The resistance and capacitor is connected as shown in figure, Voltage of battery (V) = 72 V. The…

Q: QUESTION 7 In order for electrons to flow through a wire, there must be.. a. an equal voltage…

A: Part (7): Introduction: The rate of flow of charge is known as electric current and this is because…

Q: List down 5 electrical devices in your home. Based from the devices you have listed, draw a circuit…

A: Electrical devices in our home are as follows : Light bulb Electric Heater. Hairdryer. Microwave…

Q: Answer the questions using the circuit shown. C2 Cs C4 C3 C. C1 (a) Capacitor C1 is in -select- v…

A: Series capacitor circuit :- When the capacitors are attached one by one in a line is known as series…

Question

HW
1- Use superposition theorem to find the voltage v in the circuit
shown below.
82
3 A
6 V
2- For the circuit shown below, find the value of i, using
superposition theorem.
24 V
8Ω
4Ω
www
42
www
12 V
3Ω
ЗА

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuits shown below, (a) What is the current through each resistor in part (a)? (b) What is the current through each resistor in part (b)? (c) What is the power dissipated or consumed by each circuit? (d) What is the power supplied to each circuit?
A person with body resistance between his hands of 1.00 k accidentally grasps the terminals of a 20.0-kV power supply. (Do NOT do this!) (a) Draw a circuit diagram to represent the situation. (b) If the internal resistance of the power supply is 2000 , what is the current through his body? (c) What is the power dissipated in his body? (d) If the power supply is to be made safe by increasing its internal resistance, what should the internal resistance be for the maximum current in this situation to be 1.00 mA or less? (e) Will this modification compromise the effectiveness of the power supply for driving low-re si stance devices? Explain your reasoning,
Consider the circuit shown in Figure P18.10. (a) Calculate the equivalent resistance of the 10.0- and 5.00- resistors connected in parallel. (b) Using the result of part (a), calculate the combined resistance of the 10.0-, 5.00-, and 4.00- resistors. (c) Calculate the equivalent resistance of the combined resistance found in part (b) and the parallel 3.00- resistor. (d) Combine the equivalent resistance found in part (c) with the 2.00- resistor. (e) Calculate the total current in the circuit. (f) What is the voltage drop across the 2.00- resistor? (g) Subtracting the result of part (f) from the battery voltage, find the voltage across the 3.00- resistor. (h) Calculate the current in the 3.00- resistor. Figure P18.10
Why is the following situation impossible? A technician is testing a circuit that contains a resistance R. He realizes that a better design for the circuit would include a resistance 73R rather than R. He has three additional resistors, each with resistance R. By combining these additional resistors in a certain combination that is then placed in series with the original resistor, he achieves the desired resistance.
Consider the circuit shown below. Each battery has an emf of 1.50 V and an internal resistance of 1.00 . (a) What is the current through the external resistor, which has a resistance of 10.00 ohms? (b) What is the terminal voltage of each battery?
Consider the circuit shown in the preceding problem. Write equations for the power supplied by the voltage sources and the power dissipated by the resistors in terms
An uncharged series RC circuit is to be connected across a battery. For each of the following changes, determine whether the time for the capacitor to reach 90% of its final charge would increase, decrease, or remain unchanged. Indicate your answers with I, D, or U, respectively. (a) The RC time constant is doubled. (b) The battery voltage is doubled. (c) A second resistor is added in series with the original resistor.
Unreasonable Results (a) Calculate the capacitance needed to get an RC time constant of 1,00x103 s with a 0.100- resistor, (b) What is unreasonable about this result? (c) Which assumptions are responsible?
Consider the circuit shown below. (a) What is the terminal voltage of the battery? (b) What is the potential drop across resistor R2?
(a) What is the terminal voltage of a large 1.54-V carbon-zinc dry cell used in a physics lab to supply 2.00 A to a circuit if the cell’s internal resistance is 0.100 ? (b) How much electrical power does the cell produce? (c) What power goes to its load?
(a) Digital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor (which has a= - 0.0600/°C ) when it is at the same temperature as the patient. What is a patient's temperature if the thermistor’s resistance at that temperature is 82.0% of its value at 37.0°C (normal body temperature)? (b) The negative value for a may not be maintained for very low temperatures. Discuss why and whether this is the case here. (Hint: Resistance can’t become negative.)
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.