HW10 An aeroplane makes a complete half circle of 75 meters radius, towards the right, when flying at 350 km/h. The rotary engine and the plane's propeller have a mass of 400 kg and a radius of gyration of 0.3 m. The engine rotates at 3000 r.p.m. anticlockwise when viewed from the rear. Find the gyroscopic couple on the aeroplane and state its effect on it.

HW10 An aeroplane makes a complete half circle of 75 meters radius, towards the right, when flying at 350 km/h. The rotary engine and the plane's propeller have a mass of 400 kg and a radius of gyration of 0.3 m. The engine rotates at 3000 r.p.m. anticlockwise when viewed from the rear. Find the gyroscopic couple on the aeroplane and state its effect on it.

Name: HW10An aeroplane makes a complete half circle of 75 meters radius, to
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: HW10An aeroplane makes a complete half circle of 75 meters radius, towards the right,when flying at 350 km/h. The rotary engine and the plane's propeller have a massof 400 kg and a radius of gyration of 0.3 m. The engine rotates at 3000 r.p.m.anticl

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1) Three small spheres are rigidly mounted to a horizontal shaft with rotates with angularvelocity omega as shown. Neglect sphere radii, ignore gravity. Spheres have masses m1, m2andm3 as shown.a. What is the angular momentum HO about O the center of the coordinates shown?b. At this instant, what is Ax , the x component of the bearing force at A to offset the dynamicimbalance? Note that you are NOT asked to find any other forces (Ay, Ox, or Oy) in interestof time.
The connecting rod of a horizontal reciprocating engine is 400 mm and length of the stroke is 200mm. The mass of the reciprocating parts is 125 kg and that the connecting rod is 100 kg. The radius of gyration of the connecting rod about an axis through the centre of gravity is 120 mm and the distance of centre of gravity of the connecting rod from big end centre is 160 mm. The engine runs at750 r.p.m. Determine graphically the torque exerted on the crankshaft when the crank has turned 30° from the inner dead centre.
5) In ice figure skating, a couple execute a “top” (see picture). The centre of mass of the woman (58 kg) is situated 1.3 m from the axis of rotation which is vertical and passes through the centre of mass of the man (85 kg). They are spinning at a constant angular velocity equal to 3.1415 rad/s and the man and woman have moments of inertia, about their own centres of mass, equal to 1.6 and 2.5 kg.m2 respectively. Then the woman grabs the neck of the man. At this point, her moment of inertia decreases to 1.4 kg.m2 and her body centre of gravity is 0.9 m from the axis of rotation. Determine the new angular velocity. Hints: This is a conservation of angular momentum problem, and needs the parallel axis theorem to determine moments of inertia about the axis of rotation. The skaters are moving as one body with one angular velocity, but they each have their own moments of inertia given relative to their own CoMs. For the man, that’s fine…the axis they’re rotating about passes through his…
A cylinder with rotational inertia 0.050 kg m2 is spinning with angular velocity 25 rad/s, clockwise with negligible friction about a vertical axis. A second cylinder that is not spinning is centered above and dropped onto the spinning cylinder. Kinetic friction produces torque of amount 0.60 Nm that affects both objects until the two cylinders spin together at angular velocity 18 rad/s, clockwise. (a) Determine the amount of time it takes for friction to cause the two objects to spin together.(b) Determine the rotational inertia of the second cylinder that was dropped onto the first.(c) Determine the total amount of heat and sound energy resulting from the interaction of the cylinders.
The mass of flywheel of an engine is 8 tonnes and the radius of gyration is 1.8 metres. It is found from the turning moment diagram that the fluctuation of energy is 100 kN-m. If the mean speed of the engine is 150 r.p.m., find the maximum and minimum speeds.
Answer the question in full details, thank you very much: A spherically symmetric object, with radius R = 0.70 m and mass M = 1.5 kg, rolls without slippingacross a horizontal floor, with velocity V = 3.0 m/s. It then rolls up an incline with an angle of inclinationAngle = 44 deg and comes to rest a distance d = 0.92 m up the incline, before reversing direction and rollingback down. Find the moment of inertia of this object in kg-m^2 about an axis through its centre of mass.
Asubject of mass 65 kg has her gait analyzed. Suppose that the x componentof the force measured by a force plate takes the shape shown in Fig. (a) If the forward velocity of the walker is 2 m/s at heel strike, what is it0.4 s after heel strike?(b) Estimate the corresponding change in height for the subject’s center ofgravity (i.e., from heel strike to 0.4 s later).
A massive sphere, with 10,0cm radius and moment of inertia I=4,00 x 10-3 kg-m² in relation to a straight line passing through the center of mass, rolls without sliding, descending a surface with an inclination of 30º in relation to the horizontal. In a certain initial position the total kinetic energy of the sphere is 17.5j . a Sketch the physical situation by identifying all the forces acting on the sphere in the initial position. (b) How much of this initial kinetic energy is due to rotation? (c)
A solid spare, a solid disk, and a thin hoop are all released from rest at the top of the incline (ho = 20.0 cm). a) without doing any calculations, decide which object would be spinning the fastest when it gets to the bottom. (Explain) b) again, without doing any calculations, decide which object would get to the bottom first. (Which one has greater translational speed?) think CoE. c) assuming all objects are rolling without slipping, have a mass of 2.00 kg and a radius of 3.00 cm, find the rotational and translational speed at the bottom of the incline of any one of these three objects.
A drum of mass Ma and radius a rotates freely withinitial angular velocity ωa0. A second drum with mass Mb and radiusb > a is mounted on the same axis and is at rest, although it is free torotate. A thin layer of sand with mass Ms is distributed on the innersurface of the smaller drum. At t = 0, small holes in the inner drumare opened. The sand starts to fly out at a constant rate λ = dm/dtand sticks to the outer drum. (a) Explain, in detail, why the angularvelocity of the inner drum will remain constant. (b) Determine theangular velocity of the outer drum ωb(t). Ignore the transit time ofthe sand
A motorcycle and rider have a combined mass of 350kg. The each wheel has a mass of 20kg with the diameter of 500 mm. The rider accelerates from 5m/s to 25m/s over a distance of 100m, whilst climbing a hill of slope 1 in 20. Identify the magnitude and effect of gyroscopic reaction torque by calculating the angular velocity and power as the motorcycle ascends the incline when the motorcycle and rider travel at 80 km/h around a left-hand bend of road with the radius 30 m.Explain the effects of energy transfer in mechanical systems (e.g. gears, pulley or flywheel) with uniform acceleration present.
Two propellers of lengths and masses l, L and m, M rotate in the same direction, as shown in the figure. if the left propeller starts from rest, w1=0 and the right propeller starts with an angular velocity that the right propeller ends up with after both propellers have collided.