Answered: I, 8 13 2- For the circuit shown in…

Engineering

Electrical Engineering

I, 8 13 2- For the circuit shown in figure, by using Kirchhoff's low's 12 equal to: lov 24v i 3 O i2 O 14 ww

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 9PP: In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.

See similar textbooks

Related questions

Q: Question No. 2 Determine the currents i, i2, iz and i, in the circuit shown below using Nodal…

A: Given, And C=2D=7

Q: H.W. In the network in Figure shown below, V, is known to be 8 45°V. Compute Vs: 13 2Ω -j2 Ω ΣΖΩ 1₂2…

A: given here a circuit and asked to find the Vs when the output voltage is V0 = 8∠45° V

Q: 26. In given network final V,? 1.6A( 1000 S00 0.02V, www

A: Given circuit is -

Q: 15. Determine the nodal voltages for the networks E = 50 VZ 120° € 1022 -10 Q2 4₁₁ Applying…

Q: 1. Using Thevenin's Theorem, solve for RTH, VTH and current to the load. 10 Ohm 8 Ohm = RL а. 3 A 6…

Q: 2. a. Find 11, 12, and Vs b. Find Va, Vb and Vc a 11 12v C + 1 ww 2002 ww 1502 Vs b 12 + 1 2 A www…

Q: For circuit shown below, assuming VBE = 0.7 V. Determine: (а) Іво (b) Vв (c) Ico

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Given the circuit shown in Figure 1, determine the load current when RL is set 50% of the maximum…

A: The circuit can be solved by Kirchhoff's Laws and also by theorems. We have to find at 50% of…

Q: I 8 s IL 2- For the circuit shown in figure, by using Kirchhoff's low's 12 equal to: lov 24v O i3 O…

A: Given circuit,

Q: 220°A 1220'v j20 ll I2 I3 62 -jio V,078

Q: Use wye to delta transformation to obtain the equivalent resistance in ohms, at the terminals a-b. *…

A: In this question we need to find a equivalent resistance between terminal a and b by using star to…

Q: Q1: Find the complex power for each branch and the total complex power for the circuit shown Figure…

A: Total Complex power across each Branch of the circuit Complex power given by mathematically S= VI*…

Q: ii) Two dc voltage sources with EMF of 130V and 135V are connected in parallel. The internal…

A: Two DC voltage sources with EMF of 130V and 135V are connected in parallel with internal resistances…

Q: @ In the circuit belo, by using Kirchoffi aus Find (1,,I, I,) the currents in all resistors 12V fig.…

A: Kirchhoff’s Current Law-The total current entering a junction or a node is equal to the charge…

Q: b. a 0.05 ohm 0.075 ohm 2 ohm V2 V1 =12V + =12V

Q: 10. Use KIRCHHOFF'S LAWS to determine the branch currents of the circuit shown below. 20n 12A…

A: Nodal analysis is used to analyse the electrical circuits. Kirchoff's current law (KCL) is used in…

Q: In figure below, the currents i1,i2,13 and i4 are respectively equal to ( Hint: Use Current ......…

Q: For the circuit in figure below, determinel_1,1_2 andl_3 (use Mesh method)

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed loop network,…

Q: Q1: Find the complex power for each branch and the total complex power for the circuit shown Figure…

A: Complex power in each branch Mathematics expression S= VI* In the network, 2 independent voltage…

Q: Q1: For the network of Figure below : a) Calculate ZT. b) Determine, IT, Ij and I2. c) Find V8a,…

Q: 1- Use mesh analysis to determine i, iz, and iz in figure below. Answer: i, = 3.474 A, iz = 0.4737…

Q: Use mesh analysis to determine currents Ij and Iz as in Figure Q1(a)(ii).

A: The solution can be achieved as follows.

Q: In the circuit below, calculate the value of the current I using the loop currents method, since I =…

Q: Measure the currents IL, IC, and the total current I. Using the value obtained in IL and the angle…

A: For the given circuit it is asked to determine IL, IC, Z, I, ILsinθ. We will analysis the circuit…

Q: 1. Using Wye-Delta Transformation, determine the equivalent resistance Rab for the given circuit and…

A: The solution is given below

Q: Two impedances Z, = 8+ j6 and Z, = 3- j4 are connected in parallel across 230V,50HZ supply.…

Q: 11.)Consider a PV Module with 4 solar PV cells with the Size of each 10cm x 10cm are connected in…

Q: Determine the following by using the Thevenin's Theorem for the circuit shown in Figure 3: -j20 10-…

Q: 10) Using nodal analysis, determine the nodal voltages for the circuit shown in Figure R2 = 5 N V1…

Q: 10. Use KIRCHHOFF'S LAWS to determine the branch currents of the circuit shown below. IOLGOʻV P. 202…

A: Step 1: Apply KCL at node b By KCL ,…

Q: Q1: Given the circuit shown in figure below, determine the mesh currents in the circuit. 8 0 120 ww…

A: According to question: The figure is drawn as As current 'I1' enters the dot terminal and current…

Q: Q1: For the network of Figure below : a) Calculate ZT. b) Determine, IT In and I2. c) Find Vsn, V122…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subparts for…

Q: 3. Write the loop equations for the circuit shown in the Figure below and calculate the branch…

A: Given circuit shown

Q: Compute for the value of İLOAD and VLOAD for the circuit given below after getting the set of…

Q: 2. Homework problem: Find the source voltage for the circuit shown in figure below, using current…

A: Circuit is given,

Q: ind the Rs br folr ulysis From the same figure 2, find the current through R4 using: a. DC Source…

Q: For the circuit shown in figure below, find the current IL, Is, I, In using KCL, II I=5 A, I = 10A…

A: According to KCL sum of currents entering the node is equal to sum of currents leaving the node. We…

Q: I. Find the open-circuit impedance parameters for the circuit shown in figure 1. v, V2 Figure 1 10

A: Given circuit,

Q: Consider the circuit shown below. Label current in branch ab as l, current in branch cd as l,,and…

A: To find the value of current I1, I2 and I3 we need to apply KVL and KCL: - According to KVL it…

Q: [Q3] Analyze the following electrical circuit with mesh analysis by finding the currents using…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: ER R Ry

A: Given V=24 VI=3 AR1=4 ΩR2=12 ΩR3=6 Ω For Thevenin's resistance, short circuit the voltage source and…

Q: 3. Write the loop equations for the circuit shown in the Figure below and calculate the branch…

A: In this question, Write the loop equations, And find the branch current ?

Q: a 22 2420°v A 520 A I1 j20 j10 I2-j10 b 5430°A 20 -jia2 Is

Q: > 1- Why dose the I-V characteristics pass through the origin 2-

A: Ohm's Law-Ohm’s law states that the voltage across a conductor is directly proportional to the…

Q: 3. Determine the currents I,, I2, and Ig in the figure below using Kirchhoff's rules. (r = 10) 120 V…

A: To find I1 I2 and I3

Q: Example These are all pul down networks, Sort from highest power dissipation to the least. Give your…

A: Redrawing the circuit by naming all of them individually:

Q: For the circuit shown, current I1 is: 12 V 52

A: Given : Brief description: In the above given question they have mentioned an electrical circuit…

Q: 3. For the circuit shown, Determine the following: (a) hie (b) Av (c) Ai (d) VL(p-p) if Rs connected…

A: According to guidelines, we are allowed to solve only the first 3 subparts. If any other solution is…

Q: Write equations and solve for the node voltages (V1 and V2) shown in figure below. Then, determine…

A: We will calculate node voltage at node V1 and V2 by nodel Analysis .

Q: 5. Determine the mesh currents i, , iz and iz in the circuit below. 12V 20523 A)6A

A: Apply KVL in super mesh and KCL at node , write the two equations relating currents I2 and I3. Solve…

Concept explainers

Electrical Energy

Energy is the ability to do work when energy is provided to an object. Everyone needs and uses energy every day, and energy is available in all forms. Electrical energy is stored in charged particles within an electric field. The electric field is just the area around the charged particles. In other words, the charged particles form powerful electric fields in other charged particles within the field. An electric field uses energy from charged particles, causing it to move - in other words, to perform a function.

Question

Find the current

O i3
5 bläi
I 8 s
2- For the circuit shown in figure, by
using Kirchhoff's low's 12 equal to:
lov
24v
i 3
i 2
14
5 blä

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.
For circuit shown ini the pic. below, assuming VBE = 0.7 V.Determine: (a) IBQ(b) VB(c) ICQ(d) VE(e) VC(f) VCEQ
Identify the equation that proves Kirchhoff's Voltage Law for the circuit below given the following:ES1 = 8 V, ES2 = 14 V, R1 = 12 Ω, R2= 10 Ω, R3 = 22 Ω, and IT = 0.5 A
In the circuit given in the figure | VBE | = 0.7V, R1 = 34.65Kohm, R2 = 118.04Kohm, RC = 1.32Kohm, RE = 3.97Kohm, VCC = -12.00V, Beta = 287.00, calculate IC current with full analysis.
A compound curve has the following characteristics: I1= 24° D1 = 6°I2= 36° D2 = 4°Stationing of P.C. = 10 + 420Compute the stationing of P.C.C.
1 Ia = ?? A 2.ib= ?? A 3 Vx = ?? 4 power at Rx = ?? 5 power at Rb = ??
2. (a) Define Biot-Savart’s law with the equation. (b) Define Lenz’s Law.
What load is required to achieve max power output in a Thevenin circuit if Rth = 5 ohms and Vth = 10∠0∘10∠0∘ Volts?
Determine the Thévenin and Norton equivalents of the circuit. Ans: -7.857 V, -3.235 mA, 2.429 k ohms.
In the circuit given above VS = 17,3V, R1 = 11202, R2 = 11k1,If RL = 17.4kN and Vzener-5.6, how many mW will P(zener) be?
4. A load rated at 115V, 60Hz, 10A and 1150W. A coil is to be wound with a ratio of XL to R of 5, such that when connected in series with the load on a 230V 60Hz line, the load may operate normally . Solve for R.
The AC Bridge shown below is used to measure an unknown inductance, Lx and its internal resistance, Rx. The Bridge parameters are R1 = 20,000 ohms, R2 = 50,000 ohms, C2 = 0.003 μf, ω= 105 radians per sec. C1 is adjustable from 10 pf to 150 pf, and R3 is adjustable from 0 to 10,000 ohms. At Balance,I. Derive expressions for Rx and Lx in terms of ω, R1, R2, R3, C1, and C2.II. Determine the largest values of Rx and Lx that are measurable with the given parameters.