I. Observing pH Changes in Water and Buffer Solutions upon Addition of HCl and NaOH Solutions solution calculated pH measured pH theoretical (H30*] distilled water original buffer solution distilled water with added 6M HCI buffer solution with added 6M HCI distilled water with added 6M NaOH buffer solution with added 6M NAOH

I. Observing pH Changes in Water and Buffer Solutions upon Addition of HCl and NaOH Solutions solution calculated pH measured pH theoretical (H30*] distilled water original buffer solution distilled water with added 6M HCI buffer solution with added 6M HCI distilled water with added 6M NaOH buffer solution with added 6M NAOH

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter14: Principles Of Neutralization Titrations

Section: Chapter Questions

Problem 14.29QAP

See similar textbooks

Similar questions

A 0.3012g sample of an unknown monoprotic acid requires 24.13mL of 0.0944MNaOH for neutralization to a phenolphthalein end point. There are 0.32mL of 0.0997MHCl used for back titration. a. How many moles of OH are used? How many moles of H+ from HCl? _______moles OH ________moles H+ b. How many moles of H+ are there in the solid acid? Use Eq.5. ____________ moles H+ in solid c. What is the molar mass of the unknown acid? Use Eq.4. ____________ g/mol
In an acid-base titration, 21.16 mL of an NaOH solution are needed to neutralize 20.04 mL of a 0.0997 M HCl solution. To find the molarity of the NaOH solution, we can use the following procedure: First note the value of MH in the HCl solution. ____________M Find MOH- in the NaOH solution. Use Eq.3. ____________M Obtain MNaOH from MOH. ____________M
A diprotic acid, H2B(MM=126g/moL), is determined to be a hydrate, H2B xH2O. A 10.00-g sample of this hydrate is dissolved in enough water to make 150.0 mL of solution. Twenty-five milliliters of this solution requires 48.5 mL of 0.425 M NaOH to reach the equivalence point. What is x?
Which is the correct order of steps in the preparation of a hydrochoric acid standard solution with sodium bicarbonate standard solution. I. Dissolved sodium carbonate (13.25 g) in about 150 mL of distilled water in a beaker II. Solution of sodium carbonate was transferred into a volumetric flask and diluted to mark before mixing. III. Weigh the appropriate amount of the primary standard. IV. Titrate with enough volume of the acid to completely neutralize the base. V. Transfer 10.00 ml primary standard into an erlenmeyer flask and add indicator III, I, II, V, IV III, II, I, V, IV V, III, I, II, IV V, IV, III, I, II
2. A buffer solution is prepared by mixing 15.00 mL of 0.12 M CH3COOH with 9.00 mL of0.080 M NaOH.a. Calculate the moles of CH3COOH and NaOH before mixing. b. Assuming the reaction goes to completion, calculate the moles of CH3COOH andCH3COOpresent in the buffer solution. c. Calculate the concentration of CH3COOH and CH3COOin the buffer solution. d. Use the Henderson-Hasselbalch equation to calculate the expected pH of this buffersolution. CH3COOH Ka = 1.8 x 10-5
1. To prepare 1 L of 0.10 M acetate buffer at pH 5.20, I need to mix g of CH3COONa (MW: 82.03 g/mol) with mL of 6.0 M HCl and dilute the solution to the volume of 1 L. (pKa of acetic acid is 4.76.) 2. If Lisa adds 50.0 mL of 0.060 M CH3COONa to 100.0 mL of 0.020 M HNO3 , what is the pH of the resulting solution?
Approximately 6 mL of conc. perchloric acid ( 72% ) was transferred to a bottle and diluted with about 1 liter of water. A sample containing 251.5 mg of primary standard Na2B4O7.10H2O (Fwt= 382g/mol) required 27.41 mL of the HClO4 solution to reach the methyl red end point. What is the molar concentration of the HClO4 solution? Na2B4O7.10H2O + HClO4 ------------> NaClO4 H2B4O7.10H2O
What quantity (moles) of must be added to 1.0 L of 1.7 M to produce a solution buffered at pH = pKa?Ka = 1.8 x 10-5Quantity = _______ mol What quantity (moles) of must be added to 1.0 L of 1.7 M to produce a solution buffered at pH = 4.00? Ka = 1.8 x 10-5 Quantity = _______ mol 3. What quantity (moles) of must be added to 1.0 L of 1.7 M to produce a solution buffered at pH = 5.00 ? Ka = 1.8 x 10-5 Quantity = _______ mol
15.00ml of an ammonia sample (D=0.980 g/mL) is titrated to endpoint with 31.25mL of a 0.500M HCI solition. Caculate the Molarity and the mass/mass % concentration of the ammonia solution NH3+HCI=NH4CI
find Ka for acetic acid from following half equivalence data point of half equivalence : 5 mLhalf equivalence pH value: 0.88concentration of NaOH: 0.99/ mol L-1 Volume of NaOH at equivalence point: 10mLVolume of acetic acid/mL: 40 mL
A 0.1036-g sample that contains only BaCl2 and NaCl is dissolved in 50 mL of distilled water. Titrating with 0.07916 M AgNO3 requires 19.46 mL to reach the Fajans end point. Report the %w/w BaCl2 in the sample.
How many ml of 0.2 M HCl needs to be added to 100.0 ml of 0.2 M Sodium acetate (kb for acetate is 5.6x10-10 to achieve a pH of 4.5?