I. Stability II. Steady-state error III. External disturbances IV. Transient response I, II, and II I, II, and IV I, III, and IV I, II, II, and IV

Q: One line voltage of a balanced Y-connected source is VAB 180/ - 20° V. If the source is connected to…

A:

Q: Find the value of ZL for maximum power transfer in the network and th maximum power that can be…

A: In this question,   We need to find the value of ZL  for the maximum power transfer to the load.…

Q: 4. Determine the currents in the unbalanced bridge circuit below. Also, determine the potential…

A:

Q: EXAMPLE 1 Determine the magnitude of gm for a JFET with Ipss = 8 mA and Vp = -4 Vat the following de…

A:

Q: The initial values of i, and iz in the circuit shown in Figure Q1(b) are +3A and -SA espectively.…

A:

Q: FIND (t), t>0 t=0. 120 36V 2H

A:

Q: (c) A discrete-time LTI system is characterised by the impulse response h(n) [64 32 16 8 4 2 1] (i)…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: Figure out the Resistance in Ω for the following lights connected to a 120 V source. Round your…

A: The solution is given below

Q: Given Figure Q2(b) is a second order circuit. Analyse the circuit and obtain the following: (i)…

A:

Q: If the insulation resistance of a cable of length 10 km is 1 M2, its insulation resistance for 50 km…

A: Given a cable having, Insulation resistance, R1=1 MΩ For length, L1=10 km Insulation resistance,…

Q: Q2 Ahmad was assigned by his lecturer to obtain the output equation, f(t) for the system given…

A: The solution is given below

Q: Determine the current, voltage and power dissipated by each of the 6 resisters in the following…

A:

Q: Question 4: What are the charge on and the potential difference across each capacitor in the figure…

A:

Q: Determine v, for each network of Fig. 179 for the input shown. 3 V +8 V I kQ 2.2 ka + Si -8V (a)…

A:

Q: Find the laplace transcom of the following. 1 A- 3t t.1

A:

Q: Given a Y-connected 12 MVA synchronous generator rated at 15 kV. The armature resistance is 0.08 2…

A: Given information about a Y-connected synchronous generator is written below. Rated output, S=12…

Q: Solve the voltage across 6.8-kohm resistor of the given circuit below. 32 V ID2 AGe Si o Vo 6.8…

A:

Q: Voltammetry is an analytical techniques that based on measurement of current as a function of…

A:

Q: R1 = 4 Q R4 = 10 WWW WWW 33 V R3 = 20 Q R3=10 2 R6 = 40 2 R2=10 Q WWW

A:

Q: The signal with the am module is given below. what is modulation index 1.5 0.5 -0.5 -1 -1.5 0.5 0…

A: Given here an am modulation graph and asked to determine the modulation index of the waveform.

Q: 9. Find R, of a unidirectional pattern of antenna with U=8Sin²0 Sin’o wsr", where 0< 0 <II & 0< q…

A: Brief description : Directivity and maximum directivity both are the same terms. U : Radiation…

Q: Rp C2 Vout C RL Vin RG Given: • VDD =18 V • RG =20 Mohms • RD = 462 ohms • RL = 19 kohms • pinch off…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: Find the rms and average value of the wave form shown below. a. Vaverage b. Vrms

A:

Q: a) An analogue system is shown in the block diagram of Figure Q3. Analogue x(t) y(t System Figure Q3…

A: An analogue system is one in which a physical value, such as voltage or current, is represented by…

Q: In a certain lossy nonmagnetic medium, a l GH2 wave travels 1 meters in 40 nanoseconds. The phase…

A: Given data :  frequency f=1GHz           distance =1m             time =40 ns

Q: What is the total three-phase real power drawn by the two loads? Express your answer in Megawatts

A: In this question,   We need to calculate the total real power of the three phase?

Q: Calculate I and 2 in the two-port of Fig. 4. 20 U9 = 2 12 =-j42 21 =-j42 Z22 = 82 2/30° V V2 %3D lo…

A:

Q: Implement the below logic function with an 8 :/ multiplexer. AzA2 A,ø+ A3A, +A,A,A,A, + A, A,4,A,t…

A: A logic expression is given in the question. We need to implement the logic expression by a 8:1…

Q: 10) If the magnetic field component of a plane wave in a lossless dielectric is H= 50 sin (2n x 10…

A: As per company guidelines we can solve only first question kindly post another question separately

Q: How are diodes tested for functionality? Write the necessary devices/materials needed to do the test…

A: A diode is a component that allows the flow of current in one direction and blocks in another…

Q: A) A magnetic flux Ø=2 Sin 377t +0.08 Sin 1885 mwb completely links a 500 turns coil. Find a) The…

A:

Q: Find the Inverse Laplace Transform of the following. Answers must be in a simplified form and…

A: The given transfer function is,  16s2+4s+13 The denominator of the above transfer function can be…

Q: 3. Given: o+15 V a) the gm b) Input resistance of the amplifier c) Input resistance seen by the…

A: Given the circuit, as shown below: d) We need to find the output resistance including RL. e)We need…

Q: Solve the following FIND CURRENT FLOWING THROUGH Z3 FIND CURRENT FLOWING THROUGH Z4

A: The given circuit is shown below with mesh currents and assumed current directions in each…

Q: Which are the disadvantages of a closed-loop system 1. Complexity in hardware and software II.…

A:

Q: shown below; find the currents of all Resistances using Kirchhoff's laws 10RI -19 y1 28A - IxR -27…

A:

Q: find the RAB in fig. A. Ikn 9kn 9kn 3k 3kn B.

A:

Q: Draw a diagram of both a cascade and cascode amplifier?

A:

Q: 4. An ordinary light bulb is marked “60 W, 220V “. a. What is the resistance of the bulb? b. What is…

A:

Q: The required rated voltage applied to a six leads out motor are a. 760-volts and 440-volts c.…

A: Given: 6 wire motor rated voltage

Q: riefly explain environmental issues in regard to thermal power plants

A: A thermal power station is a power plant with a steam-driven primary mover. Water is heated, then…

Q: Derive the transfer function of the following system using Mason's gain rule. ( G6 G7

A:

Q: Compose the mesh equations. 10 Q j10 O j10 O l i5 v sine 10 V [11] [12] :-10 O sine @mesh 1: Z111 +…

A:

Q: The break operation of the I.M. at speed less than synchronous speed is: OWhen rotor rotates in the…

A: In this question,   We need to choose the correct options The break operation of the induction motor…

Q: Explain on the AM Single Sideband Full Carrier (SSBFC) and compare to Double Side Band Full Carrier…

A:

Q: The Super Low Frequency band is from 30 to 300 Hz. For a DSBSC AM signal with a carrier frequency of…

A: The solution is given below

Q: Determine the forward voltage and forward current of a diode in a circuit. The circuit is composed…

A: The solution is given below

Q: A positive-sequence, balanced A-connected source supplies a balanced A-connected load. If the…

A:

Q: What is the CMRR of the op-amp in dB if the open-loop differential voltage gain of 200,000 and a…

A: We need to find out comman mode rejection ratio for opamp

Q: Calculate the power dissipation for the resistor R2. Where E 15 V, R1 = 8.2 K2, and R2 = 6.8 KN. %3D…

A: For the given circuit calculation of power dissipation for the Resistor R2. where E=15 VoltR1=8.2…

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.