Which are the disadvantages of a closed-loop system 1. Complexity in hardware and software II. Inaccurate response III. More care on a maintenance IV. Expansive I, Il and III I, II, and IV I, II, and IV II, III, and IV

Q: 04:- An antenna has a field pattern given by E(0) = 2sin (0) for 0" s 0s 90. Find a) The haif-power…

A: The solution is given below

Q: 3.9. A 400-MVA, 240-kV/24-KV, three-phase Y-A transformer has an equivalent series impedance of 1.2…

A:

Q: Find the current flowing through z1 z2 z3 z4 z5 z6 and z7. Determine also the total ampere supplied…

A: The given circuit is indicated with the mesh currents and the assumed current directions in each…

Q: Complete the table. Solve the currents of the circuit using mesh analysis.Note: If there are no…

A: In this question,   We need to determine the loop currents as shown the circuit

Q: 1) A load of 20 + j35 ohms is connected across a 220 volts source. Determine the VARS.       2)…

A: The solution is given below

Q: A sampling process uses a sampling rate of fa. Determine which of the following input signal…

A: The solution is given below

Q: 28. A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 kſN. a.…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 2. A 3-ph, delta-connected alternator drives a balanced 3-ph, delta-connected load whose phase…

A:

Q: 10Ω iR iL + VR + Vc 2.5 μF VL 62.5 mH 1520° ric uming that the frequency of the voltage source is 10…

A:

Q: Give examples for the following: A.) 1 example of DC analysis of darlington pair solved problem.…

A: A Darlington pair is designed by using the combination of two BJTs connected in such a way that the…

Q: In the circuit shown, R1 = 3Ω, R2 = 2Ω, R3 = 5Ω, ε1 = 4V, ε2 = 10V and ε3 = 6V. Find the value of…

A: Given here a circuit and asked to determine the voltage Vaf .

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A:

Q: A series circuit consisting of 40ohm resistance and 20microfarad capacitance is connected to a 220V…

A: Voltage drop: This is the loss of voltage in the circuit. The loss occurs due to the circuit…

Q: What is the magnitude of the line-to-line voltage across the two loads? (The two loads have the same…

A: Let Z is the each impedence In delta connection, then after converting into star connection the new…

Q: If the full load current of a three-phase motor is 40 Amperes, the size of the circuit breaker is a.…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: A series circuit consisting of 20 ohm resistance and 20 mH inductance is connected across a 220…

A: The solution is given below

Q: Consider given choices. Solve the current flowing to silicon diode of the given circuit below.

A:

Q: Please write a long explanation so that we can report back to you Ideal Non-inverting Operational…

A: OPAMP with negative feedback works as amplifier. When supply is at positive terminal then its non…

Q: v(t)' +20V A1 12 6. 10 11 -5v

A:

Q: What is the  phase relationship    between    the  voltage    across     the resistor VR and the…

A: In this question we will write about series RC circuit voltage relationship...

Q: ers of the two-port network in Fig. 5 are o1 variable load for maximum power transfer. Find RL and…

A:

Q: 25. For the network of Fig. 170, sketch v, and determine Vde- 2 k V, = 120 V (rms) Ideal V, (Vac)…

A:

Q: System Determine the solution of the following differential equations using Laplace Transform y" -…

A:

Q: The break operation of the I.M. at speed less than synchronous speed is: OWhen rotor rotates in the…

A: In this question,   We need to choose the correct options The break operation of the induction motor…

Q: 2. Transistor in Saturation 1. Connect the circuit as shown in Figure 1. 2. Connect the base…

A: Given circuit is shown in below figure. When base is connected to ground

Q: (a) Calculate: (1) The slip and line current. (ii) The torque and mechanical power. (iii) The…

A:

Q: 2. Find out the VOC and the fill factors (FFs) for solar cells with an Io of 10-18 A/cm2 for the…

A: Given data, The given value of current I0=10-18A/cm2

Q: Q4. A 3-phase, 230 V, 1425 rev/min, inverter-fed wound rotor induction motor is VA scalar…

A: Given information about 3-phase delta-connected induction motor, Stator resistance Rs=0.02 Ω. Stator…

Q: One line voltage of a balanced Y-connected source is VAB 180/ – 20° V. If the source is connected to…

A: The solution is given below

Q: (B)- Indicate whether the following statements are true or false and correct the false statements 1-…

A: In this question we need to verify the given statement is true or false

Q: The C-S MOSFET amplifier has three low break frequencies in low frequency band at fLI =1 Hz (caused…

A: The given circuit is as shown below,

Q: 1) 1) Given that L{f(t)} = F(S) = s+2 s2+4s+5 Without taking the inverse Laplace transform, write…

A:

Q: 1. What is the necessity of the transformer in the recitifer circuit? 2. What are the applications…

A: As per bartleby guideline for more than one question asked only first is to be please upload the…

Q: 12) Simplify the following Boolean functions: (а)* F(A, В, С, D) П(1,3,5, 7, 13, 15) (b) F(A, В, С,…

A: We need to find out simplified Boolean expression of given function

Q: 1.2.3 3. Use nodal analysis. please do complete kvl kcl solution solving thankyou

A:

Q: We need to send data 2 bits at a time at a bit rate of 8 Mbps. The carrier frequency is 10 MHz.…

A: The solution is given below

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A:

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A:

Q: QI (a) Table Q1(a) shows a list of electrical appliances for a typical 3 bedroom house. As an M&E…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The signal with the am module is given below. what is modulation index 1.5 0.5 -0.5 -1 -1.5 -2 1.5…

A:

Q: Derive the transfer function of the following system using Mason's gain rule. G6 G7 G2 G3 G4 Gs GI…

A:

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A:

Q: Feedback and Control Systems Determine the solution of the following differential equations using…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Hiw 2 fint the RAB in fig. 2 kn A. 9kn 9kn 3kn 사

A:

Q: (B)- Indicate whether the following statements are true or false and correct the fals statementS. こに…

A: In this question we will write about dc motor related questions and about interpole winding....…

Q: Finally assume that the electrical circuit will be working through a PLC unit, state and justify how…

A: In this solution, the importance of industrial automation using PLC is discussed, which will improve…

Q: Two 33 ohm resistors are connected in parallel followed by two more 33 ohm resistors connected in…

A:

Q: 513) A PID controller (Kp=60, Ki=900, Kd=8) has a sinusoidal input signal: sin (10*t). Determine the…

A: Given A PID controller Kp=60, Ki=900, Kd=8 has a sinusoidal input signal: sin(10t) The controller…

Q: 3. Given: o+15 V a) the gm b) Input resistance of the amplifier c) Input resistance seen by the…

A: Given the circuit, as shown below: d) We need to find the output resistance including RL. e)We need…

Q: (B)- Indicate whether the following statements are true or false and correct the false statements…

A: In this question we will write speed control of dc shunt motor , core loss component of motor…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.