Identify statement below if its true or false. Statement I. An induction motor can be treated as a rotating generator i.e. one in which primary winding is stationary but the secondary is free to rotate. Statement II. As the load of an induction motor increases the speed decreases. Statement III. Induction motors are available only in three-phase system.

Identify statement below if its true or false. Statement I. An induction motor can be treated as a rotating generator i.e. one in which primary winding is stationary but the secondary is free to rotate. Statement II. As the load of an induction motor increases the speed decreases. Statement III. Induction motors are available only in three-phase system.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Similar questions

Name three factors that determine the torque produced by an induction motor.
A synchronous, three-phase motor, connected in Y, with a frequency of 60Hz, 2300V, has a synchronous reactance of 110 per phase. The synchronous motor is a smooth pole motor. When delivering 200HP, the efficiency is calculated to be 90%, neglecting losses in the magnetic field. The power factor angle is 15 electrical degrees. Also neglect the ohmic resistance of the windings and calculate: a) The induced excitation voltage per phase. b) The line current. c) The power factor of the synchronous motor.
(a) With neat diagram explain the rotor of slip ring induction motor (b) Draw the circuit diagram of DC series generator with the related equations and write any two applications
1.Show that if three phase currents, each of equal magnitude and differing in phase by 120degree, flow in a three phase winding that are 120 degree apart from each other then it willproduce a rotating magnetic field of a fixed magnitude. 2. A three phase, 5-hp, 60Hz, 115V, 4-pole induction motor is operating at rated voltage, rated frequency, and 125 percent rated load has an efficiency of 85.4 percent. The stator conductor loss, rotor copper loss and core loss are 223.2W, 153W, and 114.8W respectively.Sketch the power flow diagram, enter the given data, and determine i) shaft speed ii) shaft torque 3. Can single phase induction motor be self-started? Explain the operation of a split phase single phase induction motor?
A short shunt compound dc generator delivers a load current of 30 A and 200 V and has armature, series field and shunt field resistance of 0.05-ohm, 0.03 ohm and 200 ohms respectively. Calculate the generated voltage (allow 1 V for brush contact drop)
A delta connected 1185 V, 50 Hz three phase induction motor has a star-connected slip-ring rotor with a phase transformation ratio of 4. 2. The per phase rotor resistance and standstill leakage reactance are 0.0627 ohm and 0.049 ohm respectively. Assuming the stator impedance and magnetizing current are neglected. Calculate the the following iii) The rotor current at 3 % slip with slip-rings are short circuited. (iv) The rotor power factor at 3 % slip with slip-rings are shot (v) The external rotor resistance per phase required to obtain a starting current of 145 A in the stator supply lines.
electrical and mechanical properties of an induction motor at no load, nominal load, and breakdown
The maximum torque of 3-phase induction motor occurs at a slip of 11 percent. The motor has anequivalent secondary resistance of 0.08 ohm/phase. Calculate the equivalent load resistance RL theequivalent load voltage VL and the current at this slip if the gross power output is 8 kW.
Find the current in the bars and end rings of a cage rotor of a 6 pole 3 phase, induction motor having 72 stator slots with 15 conductors in each slot if the stator current per phase is 20 A and rotor slots are 55. Hence find the suitable size of the cage bars and end rings.
True or False: The rotation of a DC shunt motor will also interchange when the terminals of the supply interchanged.
Which of the following statements about three-phase squirrel-cage induction motor is false? (A) it has no external electrical connections to it's stator. (B) A three-phase supply is connected to it's stator. (C) A magnetic flux which requires little or no skilled maintenance.
3.An induction motor has a rotor resistance and reactance at standstill of 0.1 ohm and 3.5 ohm respectively. At standstill the voltage induced to the rotor is 60volts per phase. If the slip is 5%, determine the rotor current