IDm ALOO 100s2 Ikse

Q: Find the RMS value for a voltage defined as the following saw-tooth function over an interval [0,…

A: RMS value of voltage = 1T∫v(t)2dt First we will write expression for v(t) from given waveform and…

Q: What is the RMS value of 169sin 377t?   Answer: 119.5 volts

A:

Q: Calculate the average power supplied by the source as shown below. * find the averaged power…

A: Given parameters: The series-parallel circuit consisting of R, L, and C components s shown below,…

Q: An alternator is supplying a load of 300 kW at a power factor of 0.6 lagging. If the power factor is…

A: Given: PL=300 kWcosϕ=0.6

Q: a 260-tur automobile alternator, magnetic fiux in each turn Cos at, where 8 in webers, w Is the…

A:

Q: Compute the rms value of the voltage waveform shown v(t) (V) 4 4 2 4 6 8 t (s)

A: Rms value of signal = sqrt(integral(v(t)2)dt) Using above integral find the rms value of the signal.

Q: Consider the AC voltage shown below. (()v V ponif the frequency of the voltage in units of Hz. DO…

A: The given AC voltage is v1t=2cos50πt+π6 Volts. We need to determine the frequency of the voltage in…

Q: Given a load in which  V=10e^(jπ/3) and I=5e^(−j5π/6) calculate the power factor to a minimum of…

A: Power factor

Q: A generating station has Wvo 50 MW units each running for 8,500 hours in a year and one 30 MW unit…

A:

Q: Ix ZL 220° A rms 2 Ix

A: In this question,  Determine the maximum power transfer to the load impedance ZL   For maximum power…

Q: Find the power supplied and average power absorbed or supplied by each element. Identify if the…

A:

Q: Determine the wind energy per unit mass if the winds speed is 38 Km/Hr.

A: Wind energy is a form of renewable source of energy. This form of energy is very critical as it…

Q: Find the average power absorbed by each element j2 Q 2 2 20/0° V 10/00 V I2 +2

A: Applying KCL at node P

Q: In Figure shown The average power being absorbed by 4 N is: 4Ω 10Ω j5 2 -j52 T100/0° v 297.4 W O…

A:

Q: Determine the average power supplied by each source in the circuit jin jin 1020° V(:) (1) 2230° A

A:

Q: is the RMS value of output voltage of the step down chopper which is having 200 V as a input for a…

A: Given  Input Voltage, Vi= 200V Duty cycle, D= 70% =0.7 Duty cycle = output voltage/ input voltage

Q: cheggindia.com/#Form:Subject_test?User_Name=3709413000303192252&Number=6 If the rms values of…

A: Solution- Vrms = 120 VI = e-j30° ALet us assume a equation,Acoswt+ϕ⇒A∠0° (with peak value)…

Q: An ac generator with a maximum voltage of 24.0 V and a frequency of 60.0 Hz is connected to a…

A: Given data, The value of maximum voltage is Vmax = 24 V. The value of frequency is f = 60 Hz. The…

Q: A generating station has a demand of 25 MW, a load factor of 60%, then the average demand will be:

A: Given: A generating station has, Maximum demand = 25 MW Load factor = 60 % Average demand =?

Q: Determine the following: (a) The components present in the circuit.  (b) The rms value of the…

A: Note-  Same frequency of voltage produces same frequency of current.  Voltage leads current in…

Q: Determine the peak and average power delivered to RL. 2:1 115 V rms · 220 Ω elle lelll

A: Given circuit:    Given  circuit  is  a half‐wave rectifier circuitprimary  to secondary  turns  is…

Q: Compute the rms value of the voltage waveform shown v(1) (V) ? 4 6 8 t(s)

A: The signal is defined from time t=0 to t=4 sec. The definition of signal is as follows: v(t)=2t…

Q: Volts 12 t (sec) Find the RMS value of the voltage waveform, Find the average power if 8 2 resistor,…

A:

Q: Let the voltage passing through a resistance R = 1000 ± 20 ohm is 10.0 ± 0.1 Volt. The average power…

A:

Q: Calculate the maximum average power that Z_L can absorb. Z_L= 3.32+j1.07 Ohms -j4 2 j1Ω ll 5Ω ) 4A 8…

A: Thevenin's theorem states that any network containing linear and bidirectional elements and…

Q: Determine the complex power absorbed by the voltage source -j10 N j20 2 100/0° V rms 20 N 10 N

A:

Q: I, -j3 k2 j1 k. 500 2 ell 201, 4 k2 Ix 10 k2 0.2/0° V rms (t

A:

Q: Determine the peak and average power delivered to R in the following figure:

A: The given circuit is as shown below : RMS voltage in primary coil = 120 V ∴ Peak voltage in primary…

Q: average power dissipated in the resistor. Ai(t)

A:

Q: 2. Determine the average power absorbed by cach resistor, the total average power absorbed and the…

A: Given figure as- I1=12∠45°4I1=3∠45°I2=12∠45°2-j1Ω=12∠45°2.236∠-26.56°I2=5.366∠71.56° A

Q: The power input to a 3-phase induction motor is read by two wattmeters. The readings are 860 W and…

A:

Q: The current in a single-phase motor lags 50° behind the voltage. What is the power factor of the…

A: Power factor pf = cosin of angle between voltage and current.

Q: Three impedances 10-j30 are connected in star across 100 volts 60 HZ Line to Neutral, Calculate a.…

A: Given, Three impedance connected in star are, Z=10-j30 Ω Phase voltage, Vph=100 V Frequency, f=60 Hz…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 22 m/s. The stage efficiencies are Cp…

A:

Q: An AC voltage an RMS value and average value of 200 Volts and 150 Volts respectively. What is the…

A:

Q: RMS: 3.036V output, 3.606V input Calculate the average power delivered to the resistor in part 1d…

A: Given circuit is - Given values are -

Q: Compute the rms value of the voltage waveform show v(t) (V) 4 4 2 4 6 8 t (s)

A: In this question We need to determine the rms value of the given waveform.  We know rms value of…

Q: That is the RMS value of an AC voltage that has a 347 V peak? Pa. 245.3 Ob.490.6 Oc. 265.7 Od.469.3…

A: The relationship between rms and peak value is given by:    V(rms) = V(peak)÷√2 Simliraly ,V(peak) =…

Q: d.) Average power e.) f.) Power when t=1/480 sec, 1/240 sec, 1/90 sec. Draw voltage, current and…

A: In this question,  We need to calculate the average power, power at different different time and…

Q: vz = 150 sin 314.2t and vz 90 sin (314.2t – ) volts respectively. Determine a) the voltage of the…

A:

Q: Determine the value of Voltage Vs. 1:0.3 +, + 120 V 10 2 Vs 2) RMS

A: To find Vs the circuit can be modified as  The current I2 is given as

Q: cos (x) 2. Please calculate RMS of V(t)=V 2 cot (x) max

A:

Q: 5. Find the average power supplied by the source and average power absorbed by the resistor.

A: The solution can be achieved as follows.

Q: Calculate the average power dissipated

A:

Q: The number of cycles completed in one second is called as 000 а. DE Average value b. RMS value

A:

Q: f ?(?) = 160cos50? V and ?(?) = −20sin(50? − 30°)A. Calculate the instantaneous power and average…

A: Consider the equation. v(t)=160cos(50t) V The equation of the current is, i(t)=-20sin(50t-30°) A

Q: Determine the peak and average power delivered to R. 2:1 115 V ms 220 N rlll

A:

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.