Answered: Wind-turbine units are rated at 8 KW in…

Wind-turbine units are rated at 8 KW in a rated wind speed of 22 m/s. The stage efficiencies are Cp - 0.32, ngb = 0.85, ng - 0.92. What is the diameter? (p = 1.29 kg/m3 ) Diameter

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.21P: An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor...

See similar textbooks

Related questions

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 14 m/s. The stage efficiencies are Cp…

A: Find the diameter of the wine turbine Output power P= 8kW Wind speed 14m/s Find the turbine…

Q: The Upward wind and down wind velocity of a wind turbine are 12m/s and 5m/s respectively. What is…

A: Given: Downward wind velocity, Sd=5 m/s Upward wind velocity, Su=12 m/s

Q: A wind turbine gives maximum output put of 1MW at a wind speed of 15m/s. Refer to the above wind…

A: To find the swept area by the wind turbine (A)

Q: ^ what is 200121° Urm 2001-95° Urms 200 1145 Vrms 4 3 IL1 I. k 2a 26 Zc N 2a= 2b = 2c= (25+j5) e…

A: In this question, We need to determine the complex power, active power and reactive power?. We…

Q: By how much the velocity of wind turbine will be multiplied, if its wind power is tripled?

Q: The voltage applied to a coil having R-2002 ohm, L-638 mH is represented by e=20sin 100 pi t. Find a…

Q: A lighting load operates from a 208V, 60Hz supply and is rated 1 kW @ p.f. .707 lagging. What size…

A: The reactive power demand when the capacitor is not connected is, Substitute the values.

Q: A transformer connected to a120 V (rms) ac line is to supply 12.0 V (rms) to a portable electronic…

A: Given: Primary side voltage, V1=120V Secondary side voltage, V2=12V Load resistance, RL=5Ω

Q: What is the effective isotropic radiate power (EIRP) in W? (Use two decimal places for the final…

Q: Part 1: Computed Values For this part of the experiment, calculate the data needed in the table…

A: When frequency increases, the inductive reatance Increases because it is directly proportional to…

Q: An automotive alternator is rated 550 VA and 20 V. It delivers its rated voltamperes at a power…

A: Given data, The value of the Rate is 550 VA, The value of line voltage is 20V The given power factor…

Q: 4.1Calculate the energy capacity and the capacitance of a super capacitor consisting of X metal…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: Since nothing is given to answer which of the following question but I can find ink marked in Ques…

Q: cheggindia.com/#Form:Subject_test?User_Name=3709413000303192252&Number=6 If the rms values of…

A: Solution- Vrms = 120 VI = e-j30° ALet us assume a equation,Acoswt+ϕ⇒A∠0° (with peak value)…

Q: Calculate the blade length of a wind turbine rotor which produces a maximum power of 6 MW at a wind…

A: The solution to the given numerical on a wind turbine is given below.

Q: 1-Alternators can be overloaded by 10 percentage for 10-15 minutes, this a. Steady state voltage…

A: Need to find the correct statement for the given questions

Q: EXAMIANS.COM Power Systems If the inertia constant H = 10 MJ/MVA for a 50 MVA generator, the stored…

A: Given, Inertia constant, H = 10 MJMVA MVA rating of generator, S = 50 MVA

Q: We measure gas pressure at the gas valve in? ja. p.s.i.g. b. p.s.i.a. С. c. Inches of Mercury d.…

A: Measure gas pressure at gas valve in?

Q: The power consumption of an industry is 500 kVA, at 0.8 p.f lagging. A synchronous motor is added to…

A: Given that power consumption of industry (Load) is 500 kVA at 0.8 power factor lagging and…

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: The solution can be achieved as follows.

Q: Problem 2-A building uses 120 solar modules of Panasonic 300 Black Series in rows of 8. While the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: An Industrial load is taking 500kW at 0.6 lagging pf. It is desired to raise the pf to 0.866 lagging…

A: According to the question, it is given that Industrial Load=500 KW at 0.6 at lagging cosϕ1=0.6…

Q: Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

Q: Q.16(A). The inductance of moving iron ammeter in micro henry is given by expression: L=20+50-202…

A: Given: L=20+5θ-2θ2At I=5 A θ=30°=π6 radAt I=10 A θ=?

Q: A base load station having a capacity of 18 MW and a standby station having a capacity of 22 MW…

A: Given data: Annual standby station output 7.4×106 kWh Annual base load station output 100×106…

Q: if Pd exceeds Pg generation, what will be the effects on the frequency of the power systems

A: lf Pd exceeds Pg generation, The effects on the frequency of the power systems will be ?

Q: An Industrial load is taking 500kW at 0.6 lagging pf. It is desired to raise the pf to 0.866 lagging…

Q: reservoir is constructeo mountain at 5 neight from ground level. Water flows down at a rate velocity…

Q: An offshore wave energy device with a frontal width of 5 metres, an overall efficiency of 38% and a…

Q: Determine the annual module power output of a SANYO (HIP-215NHE5) module in Baghdad, if the monthly…

Q: A) A wind turbine is spaced out at the distance of 180m with other wind turbines and wind speed is…

A: We are authorized to answer three one question at a time. Since you have not mentioned which…

Q: Q3: For the following figure, select the generator rating as base to find the voltage at the…

Q: A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230V, 50 Hz supply…

A: Energy meter constant K = 200 rev/kWh Load current = 10A The relation between the energy consumed…

Q: In FACF formulae the constant 'A' represents with Average weight in kg-m/kWh for gross generation…

A: In FACF formulae the constant A represent with?

Q: Consider the AC voltage shown below. vz (t) = 2 * cos (50nt + Specify the period of the voltage in…

Q: Assuming a 60 hertz system, how much time in seconds is the maximum positive current behind the…

Q: Part 1: Computed Values For this part of the experiment, calculate the data needed in the table…

A: As frequency increases , Capacitive reactance decreases because it is inversely proportional to…

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves the same stage with…

Q: A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The…

Q: A wind turbine system has an average overall efficiency of 25%, what is the size of wind rotor is…

A: In this question, A wind turbine system average overall efficiency =25%, what is the size of wind…

Q: Wind-turbine units are rated at 6 KW in a rated wind speed of 8 m/s. The stage efficiencies are Cp =…

A: The efficiencies are cp = 0.32 ngb = 0.90 ng = 0.92 V = 8 m/s

Q: Calculate the blade length of a wind turbine rotor which produces a maximum power of 8 MW at a wind…

Q: Electrical load that draws current whose impedance varies throughout the cycle of the input ac…

A: Correct option is TRUE we know that Non linear loads draws non linear current whose impedance is…

Q: d) Write differences between stirling engine and solar power

A: Differences between Stirling Engine and Solar Power Generation System:

Q: The wind turbine gives the following data: Blade length, I = 39 m, Wind speed, V= 13.4 m/s, Air…

A: D option 4098985.34 W

Q: A 250 V, 10 kW, separately excited generated has an induced emf of 255 V at full load. If the brush…

Q: b. Let an emf of (Z + 25 rate of (Z+250) Am i. Inductance of t ii. Energy stored in

Q: HAWT type wind turbine has the following data, height of tower =100 m, diameter of rotor = 80 m,…

A: According to question:

Q: Sketch, how can electricity be produced by using Stirling engine, keeping the losses a minimum…

Question

Solve it quickly please

Wind-turbine units are rated at 8 KW in a rated wind speed of 22 m/s. The stage efficiencies are Cp = 0.32, ngb
= 0.85, ng - 0.92. What is the diameter? (p = 1.29 kg/m3 .)
Diameter=

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 400 kW, three-blade wind turbine is designed to deliver power at a wind speed of 15 m/s. The blades have a depth of 14 m, and the rated speed of the turbine is 48 rpm. The air density is 1.226 kg/m3. Calculate (a) area swept out by the turbine (b) wind power available to drive the turbine (c) capacity factor of the turbine
Give reason(s) for any difference between measured and nameplate values. Discuss the values obtained both from clockwise and counterclockwise rotation setups. Clockwise RPM Counterclockwise RPM Trial 1 1797 1781 Trial 2 1796 1787 Trial 3 1795 1791 Average 1796 1786.3
C. A small wind turbine of blade diameter 185 cm is subjected to upwind velocity of 11.7 m/s and downwind velocity of 9.3 m/s. Calculate the power and energy produced by the turbine per year. Density of wind is 1.25 Kg/m3.
Q 03: Briefly discuss, how the energy consumptions for operations of a fork lifter could be justified. Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
The theoretical maximum efficiency of wind turbines is limited by the velocity of air leaving the turbine preventing air from entering the turbine. TRUE OR FALSE?
Estimate the AEP for a 3-MW wind turbine in a wind regime that has a CF= 30%. For this turbine explain why the increase of wind speed to levels greater than 25 m/s generates less electrical power compared to wind speeds around 11 m/s
A wind turbine system has an average overall efficiency of 25%, what is the size of wind rotor is required if 100 watt DC generator will be driven? The average expected wind velocity at the rotor is 8 m/s.
A 100 MVA, four-pole, 60 Hz generator has a moment of inertia 25 X 103 Kg-m2. The angularmomentum in terms of mechanical radians is
Sketch, how can electricity be produced by using Stirling engine, keeping the losses a minimum level.
The wind turbine gives the following data: Blade length, l = 49 m, Wind speed, V= 32 Km/Hr, Air density, ρ = 1.23 kg/m3 , Power Coefficient, Cp = 0.4, Calculate the power available in the rotor in Watts. 60772464.72 W 394985.47 W 1302564.83 W 151931161.80 W
In 1980 wind turbines in Europe generated about 5 gigawatt-hours of energy. The amount of energy will increased by 59% per year. Estimate how many years it will take for 80 gigawatt-hours of energy to be generated?
The following data are given for a wind turbine: Blade length, l = 45 m Wind speed, U = 12 m/sec Air density, r = 1.25 kg/m3 Find the following: a) Total wind power in MW that can be extracted b) Maximum wind turbine power in MW that can be generated c) Actual wind turbine power in MW if the power coefficient is 0.38 d) Blade tip speed in m/s if the rotational speed is 7 rpm e) Tip speed ratio