If A = 20260° and B= 5230°, find the products AB and BB".

Q: Vhat is the CMRR of the circuit? 50v 50v 1 1500v 2000v 30v

A:

Q: / A- Turn the following active sentences into passive ones. (3 only) 1- I have sent my CV to you on ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Use k-map method to derive the simplified SOP expression for the function L(V,W,X,Y,Z)=summation of ...

A: Kamp-Kamp / Karnaugh maps are Boolean algebra simplification techniques. Using maps expressions can ...

Q: Given three impedance Z1=10 +j0 Z2 =3+j4 and z3=8-j6. Impedance z2 and Z3 are connected in parallel ...

A: If two impedances Z1,Z2 are connected in series than equivalent impedance is Z1 +Z2.  If two impedan...

Q: R, 1212 V= 40 mV V-7.68 V umptifier A 320

A:

Q: The power factor of a circuit is determined by: coso=P/ VI; where Pis the power in watt, V is the vo...

A:

Q: D. Given three impedance Z1=10 +j0 Z2 =3+j4 and z3=8-j6. Impedance z2 and Z3 are connected in parall...

A:

Q: Draw a sinusoidal voltage waveform with peak value of 200 volts and has an instantaneous value of 10...

A:

Q: 150kN, V1 = 3v, V2 = 6v, V3 = 9v, Rı = 500KN, R2 = 1MN, and R3 = 800kN. 4. Calculate the output volt...

A:

Q: 33.) Apply Kirchhoff's current law and voltage law to the circuit shown below to identify the branch...

A: Kirchhoff’s current law: In the circuit, the path is closed then at any point sum of current with th...

Q: 10 %3D r2 The potential equation is given by V =sin 0 cos p. (a) Find the electric flux density at (...

A:

Q: Design an operational-amplifier circuit (using two inverting configurations) with compensating resis...

A: GIVEN: the output of the operational amplifier              V0=-5v1+2v2-0.1v3+5v4 FIND: design an op...

Q: A transistor output noise voltage is measured at 15microvolts when the standardized noise source is ...

A:

Q: D2 V1 R1 T1 5kQ 220 Vrms 60 Hz 0° TS_POWER_10_TO_1 Fig.1 Half-wave rectifier test circuit 2. Connect...

A:

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

A:

Q: Examlpe: Assume that an analog signal is given by a) x(t) = 5 cos(4 x 10°nt) + 3 cos(6 x 10°nt),t > ...

A:

Q: Two units, connected in parallel, are energized by an a-c source. If the component currents are 15 a...

A:

Q: 5. Vo and In 1.2K2 Si IR +12 Vo 2.4KQ -5V

A: Brief description : Diode is a unidirectional device which will conduct the current only in one dire...

Q: Find the current i4 10A 100 200 300 2A 600

A: In this question,  We need to determine the current in the 60ohm resistance.  We are solving this pr...

Q: Design an adder for excess-3 decimal digits using a ROM. Add two excess-3 digits and give the excess...

A:

Q: 5. A generating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor...

A: 5) Given:  a generating station having  Maximum demand = 20 MW  Load factor = 60 %  Plant capacity f...

Q: What is forward bias and reverse bias in PN junction diode?

A: We need to tell about forward bias and reverse bias for a diode .

Q: Calculate the voltage VO of the diode circuit. Let the cut-in voltage of silicon diode, Vy(Si) = 0.7...

A: The solution is given below 

Q: Q1: A wire warped around the following ring with 100 turns. the diameter of ring is 10 cm.the curren...

A:

Q: A step in a space vehicle checkout depends on four sensors (A,B,C,D) . Every circuit is functioning ...

A: Given that 4 variables acts as sensor variable. Now i am writing the truth table of 4 variable ,in t...

Q: se-2t, le', t >0 t < 0° (b) Use the definition to find the Fourier transform of f(t) : [Do not simpl...

A: Note : For easy simplification we have considered f(t) = x(t). Brief description : Generally fourier...

Q: Transform the following sinusoids to phasors a. i(t) = 6cos (50t - 40') A b. v(t) = 12cos (377t - 30...

A: Since you have posted a question with multiple sub parts , we will solve first three sub parts for y...

Q: A 400 W, 5-A series motor is connected to a 110-V voltage source. (a) Find the motor's torque? (b) W...

A: Given a serie Motor with output power = 400 w and it takes a current of 5 A when it is connected to ...

Q: An engineer built the circult deplicted in the figure. Assuming E - 8.60 V and R- 5.30 0, find the f...

A:

Q: Determine the following: a. re b. Zi c. Zo where ro is infinite d. Av where ro is infinite

A:

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v 1 0.5 0.06 0.3

A:

Q: The

A:

Q: Question No. 1: Answer the following Questions: 1. Compute the polar coordinates of a) z1 = -1 - j b...

A: Cartesian and polar forms play an important role in Electrical engineering. especially in AC circuit...

Q: A Boolean function fk of two variables A and B is defined as follows: fk (0, 0) = fk (0, 1) = fk (1,...

A: NOR gate: This gate has 2 inputs and one output. It shows output 1 when both inputs are active low ‘...

Q: ) The two different types of semiconductors obtained when adding two different impurities represente...

A: Impurities are of two types  1) pentavalent and trivalent impurities Pentavalent impurities are from...

Q: Explain the design of renewable and non-renewable energy system principle (Other than water)

A: Solar power plant(Renewable energy): Photovoltaic power plants are another name for solar power plan...

Q: 1. Kirchhoff's Current Law is a restatement of conservation of charge & Kirchhoff's Voltage Law is a...

A: Given circuit shown 

Q: Design an op-amp circuit to yield the relationship shown in each equation. Vo = V1 + 10V2 – 3...

A: a) Assuming, Rmin=Rf=6kΩ Inverting input V1 and V2 using inverting amplifier: Taking Rin=Rf, The ou...

Q: 3. A resistor and a capacitor are connected in series across a supply of 250 Volts. When the supply ...

A:

Q: → XCF) = SCf - 2000 +56(f+200) + [6(F-300)+ S(F+30) > XE) = 2-56(F-2000) +2-5 6CF+2000) + 1-5 6(F -3...

A:

Q: When four identical resistors are connected to an ideal battery of voltage V= 10 V as shown in the f...

A:

Q: 1.8 The power delivered to an element is p = 12 sin 4t W and the voltage is v = 4 sin 2t V. Find the...

A: The solution is given below 

Q: A power transformer rated 8MVA, 34.5 kV/230 V is connected delta-delta.What is the current of the LV...

A: The solution is given below. 

Q: A sinusoidal source supplies 20 KVAR reactive power to load Z = 25075° Q. Determine the rms voltage....

A: First find the impedance in rectangular coirdinates.  Real part of impedance is resistance and imagi...

Q: 2. Calculate the power factor of the entire circuit of Fig. as seen by the source. What is the avera...

A: The detailed solution is provided below.

Q: A 4-kW, 110-Vrms load, as shown below, has a power factor of 0.82 lagging. Find the value of the par...

A:

Q: 18.) Determine the effective resistance between points A and B in the given network below. Express i...

A:

Q: Describe in your own words with proper diagram and characteristics curve : why the application of a ...

A: MOSFET- MOSFET is electronic device which mainly used as switch and amplifier. It has four port as m...

Q: Q2) A lossless transmission line is terminated with a 1002 load. If VSWR on the line is 1.5, fined t...

A: Given data, Load impedance, ZL=100 Ω VSWR=1.5  

Q: Modulation is the process of modifying a base signal with a carrier signal, and it is used mostly in...

A:   Given, In frequency modulation Carrier frequency (fc) = 570 kHz Amplitude of carrier signal (Ac) =...