Answered: If a car accelerates at the rate of a…

If a car accelerates at the rate of a in t seconds and decelerated at the rate of 0.5a for 2t seconds before it stops, determine the distance it has travelled if it started from rest. 3/2 at3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: For a disc-shaped particle of diameter 2.55 mm and length 1 mm, calculate the following diameters:…

A: The given data is as follows: Diameter of particle=2.55 mmLength of particle=1 mm

Q: Produce a flow diagram to explain the steps involved in the management of waste material.

Q: Determine the form factors for the timber beams of following shapes (b) Also, compare their load…

Q: A simple beam has a span of 5 m. The maximum moment in the beam is 69 kN- m. The allowable bending…

A: Given data : The value of maximum moment in beam M=69 KN×m The value of allowable bending stress…

Q: A closed water tank 80cm-high, 120cm long, and 50cm wide is to be transported. The acceleration is…

Q: drinking water refilling station

A: INTRODUCTION The business deals procedures of filtered water topping off stations seem to utilize…

Q: (in %, up to two decimal places) is, outer diameters of 100 mm and 106 mm. respectively. The area…

Q: A hinged-end column 5.00 m long is fabricated from a W310x62 section and a C250x45 channel arranged…

A: The given data is shown below: Length=5mW310×62C250×45

Q: A plate with width of 400mm and thickness of 12mm is to be connected as shown in the figure. The…

A: The given data is shown below: Width=400mmThickness=12mmA36 steelBolt diameter=34mm

Q: Calculate the chainage of the tangent points of the compound curve from the following: Stat.…

Q: A Yu highway difflicate by angle of 50° 40 Find: 1. The tangent and curve length, D=4° 2.…

Q: Please reply ASAP. Will rate immediately. Which of the following gives the horizontal reaction at…

Q: Please make your own question about horizontal and vertical angles (surverying) and solve it on your…

Q: 10 Identify the x1,x2,x3 y1,y2,y3. A1,A2,A3, At. Center of gravity for x and y. 3. 00

Q: K 37KN KrkN m 1om 7m

Q: 15’K 5K/FT 3 BA 4 + 3'→ 13'

Q: A cylindrical rod is designed of A36 steel (Ftall=Allowable tensile stress=24ksi). What is the…

A: To Determine Smallest reasonable sized rod that could support the 15,000 pounds, R

Q: triangular plate with base 5 ft and altitude 3 ft is submerged vertically in water. If the base is…

Q: eck the design of the following unreinforced masonry wall to see if it is adequate. A 14 ft simply…

Q: meter consists of 8-mm diameter cylinder of length 20cm nd the mass of the sphere is 12.80g. At what…

Q: 2. Let L = 9 m, a = 3 m, w = 5 kN/m and P = 12 kN/m. El is constant. The overhanging beam is loaded…

Q: %3D The water in an aquarium will be drained for cleaning. A flexible tube (D = 4mm) w be used to…

Q: 15'K 5K/FT 3 BA 4 D + 3'→ 13'

A: Find the maximum shear and moment in the beam with absolute values

Q: Example: A road way deflect by an angle of 50° 40. The two tangent intersection of station 20 +00.…

Q: What is the appropriate radius of the central curve if an 80-m spiral easement curve has a distance…

A: Given data, Spiral curve length = 80 m Distance along tangent at its third quarter point (Xs) =…

Q: Determine the angle of shear strength and cohesion of the sandstone for each of the two (a)…

A: As per company policy, we are supposed to answer only the first question of the multiple question…

Q: V (lb) 4- 900 -900

Q: 5. Draw a deflected shape, 40.0 kN 60.0 KN SFD, and BMD for the 200 kN/m adjacent beam. 2.00 m 8.00…

Q: building in Noida, U.P. The data are as follows: Consider an inner beam-column joint in the ground…

Q: The major and minor principal stresses at a point are 3Mpa and -3Mpa respectively. The maximum shear…

Q: If the tangent grades are-1.7% and +2.3% respectively, determine the maximum speed in kph that a car…

Q: Write the shear and moment equations for the beam shown.

A: We will find reaction first.

Q: onditional Obligation. (8-10 sente

A: These are the terms related to contracts and accounts in civil engineering field.

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

Q: Draw a rough line of influence at the main point 9tf Зт 6m Зт

A: Please mention the main point location. At where you want influence line diagram.

Q: mn supporting 4 additional floors

Q: 10.9 A consolidation test on a sample of clay produced the following data: o: (kPa) 8. 16 32 64 128…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A. Determine the service load P, that the connection can carry based on yielding of gross section…

Q: W

Q: Investigate the adequacy of a W310x62 to support an axial compressive load of 300 kN dead and 200 kN…

A: Solution-The given data is,The dead load =300kNThe live load=200kNThe span =5.5m

Q: Calculate the chainage of the tangent points of the compound curve from the following: Stat.…

A: Given:- The stationing of point P.I = 28+50 The radius of the curve 1 = R1 = 500 m The radius of…

Q: The force R is the resultant of the forces P1, P2, and P3 acting on the rectangular plate. Find P¡…

Q: Given the following cross-sections notes. It is required to determine the earthwork volume on a…

A: Area,…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

Q: A small cylindrical drum 32 cm in diameter and 52 cm high, weighing 27 N contains perfume (SG =…

Q: The waterline section of a 1500-kN barge is as shown. Its center of gravi etacentric height against…

Q: : Design a 9t single angle tension member to support dead tensile working load of 30 k and a live…

Q: Question 24 The following results were obtained from a direct shear test on a dry uncemented…

Q: The motion of a particle along a straight line is defined by s %=÷t3 – 36t. When the particle…

Q: Explain the significance of the minimum residual stability requirements in the damaged condition…

A: Intact Stability 1. Original GM or metacentric height should not be less than 0.15 m.2. The right…

Concept explainers

Control Survey and Geodetic reductions

Control surveys or survey controls are used to establish reference points as a basis for various construction activities. Vertical and horizontal control points are to be established in a control survey to increase accuracy. After establishing the control points, all other types of surveys such as topographic, right-of-way, aerial mapping, construction layout, boundary surveys, and utility mapping can be worked upon so that control networks can be formed. The place from which the observations are made is called a survey station.

Question

how solutions clearly and free body diagram.

If a car accelerates at the rate of a in t seconds and
decelerated at the rate of 0.5a for 2t seconds before it
stops, determine the distance it has travelled if it started
from rest.
3/2 at3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A car moves in a straight line with a velocity of v = (3t2-7t) m/s, and t is in seconds. Determine its acceleration in m/s2 at t = 5s if when t=0, x=0.
An Auto starts from rest and comes to a stop ½ mile away. If its acceleration and deceleration are limited to 30fps and 20fps respectively, what maximum speed does it reach if the elapsed time is to be as small as possible? In addition, what is the displacement when it reach the maximum speed?
At any instant, the horizontal position of the weather balloon is defined by x = (8+5)t ft, where t is in seconds. If the equation of the path is y = x2/10, determine the magnitude and direction of the velocity and acceleration when t = 2s
A car moves in a straight line with a velocity of v = (3t2-7t) m/s, and t is in seconds. Determine its position in meters at t = 5s if when t=0, x=0.
ASAP. THANK YOU! A man drives at a rate of 25 kph towards the foot of an 8-m tall monument. At what rate is he approaching the top when he is 42m from the foot of the monument? A. 21.45 kph B. 31.58 kph C. 24.56 kph D. 6.82 kph
DYNAMICS OF RIGID BODIES PROBLEM: A particle moves counterclockwise on a circular path of 400ft radius. It starts from a position, which is horizontally to the right of the center of the path and moves so that s-10t² + 20t where s is the arc distance in feet and t is in seconds. Compute the horizontal and vertical components of acceleration at the end of 5sec.
In traveling a distance of 3.3 km between points A and D, a car is driven at 86 km/h from A to B for t seconds and 42 km/h from C to D also for t seconds. If the brakes are applied for 4.8 seconds between B and C to give the car a uniform deceleration, calculate t and the distance s between A and B.
4. The box of negligible size is sliding down along a curved path defined by the parabola y = 0.38x ^ 2 When it is at A(x_{A} = 2m, y_{A} = 6m) , the speed is v_{B} = 30kph and the increase in speed is d*v_{B} / d * t = 14 m/s^ prime . Determine the magnitude of the acceleration of the box at this instant.
Problem#4: Calculate an object’s acceleration when ? = 100 ? and when ? = 175 ?. Refer to the v-s graph below. Problem#5: As a vehicle leaves the first point, it gains a speed at the rate of 4 ??/? 2 for 6 ? and then at the rate of 6 ??/? 2 until it has reached the speed of 48 ??/?. The vehicle maintains the same speed until it approaches the second point; brakes are then applied and the vehicle slows down constantly until it stops in 6 ?. The total running time from first point to second point is 40 ?. Plot the a−t, v−t, and x−t graphs, and calculate the distance between the first and second point.
While travelling at a constant speed a driver saw a road block 112 m away. He applied the brakes and the car decelerated uniformly at 6.4 m/s^2. It stopped 5 m from the block. Find the initial constant speed of the vehicles in kph, if the drivers perception reaction is 2.2 second. a. 91.86 b. 26.31 c. 25.52 d. 94.72
The brakes of a car are applied, causing it to slow down at a rate of 10 ft/s2. Knowing that the car stops 300 ft, determine (a) how fast the car was traveling immediately before brakes were applied, (b) the time required for the car to stop.
it takes about 3 s for a driver having 0.1% alcohol in his system to react to a situation to avoid a collision. if such drivers are traveling on a straight road at 40.11ft/s and their cars can decelerate at 2.714ft/s^2, determine the shortest stopping distance d (in feet) from the moment they see the pedestrians.