If an 8086 running at 10MHz performs bus cycles with two wait states, what is the duration of the bus cycle?
Q: Discuss about the functional unit of 8085 microprocessor.
A: The 8085 microprocessor consists of the following functional units; Accumulator: This is the…
Q: Q. Description a) Interpret the following circuit and Reconstruct using NAND gates CLO 1 1 F
A: a) It is given a logical circuit, we need to construct this circuit by using NAND gates. b) It is…
Q: 10. Which of the following is true about microprocessors?
A: The correct option along with the explanation is provided in the following section.
Q: 5. Pass Transistors: Pass transistors are used as a switch to pass logic levels between nodes of a…
A: Given figure is shown below. Given transistor is PMOS pass transistors. Given Vss=0V. Thus all PMOS…
Q: How many MOSFETS are needed to implement the following function with a single CMOS gate (F=BC+AD):…
A: Mosfet required to implement F= BC + AD
Q: Q8. In single pulse width modulation of single phase inverter, if supply voltage is 200 V DC and…
A: Given Supply voltage Vs=200V DC Given pulse width 2d =60° Then value of third harmonic ?
Q: Quèstion 13 To design an AND logic gate using BJT, two transistors should be connected in series.…
A:
Q: Sketch a schematic for the two-input XOR function using only NAND gates. How few can you use?
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: For an NMOS device with velocity saturation. indicate whether Vdsat and idsm increase, decrease, or…
A:
Q: An 8bit PCM uses mu law companding with mu=100. Calculate the signal to quantization noise ratio?
A: Pulse code modulation(PCM) is used to represent the sampled version of an analog signal in binary…
Q: Quèstion 10 To design an AND logic gate using BJT, two transistors should be connected in series. O…
A: Circuit representation for an AND logic gate using BJT, Here, both transistors are connected in…
Q: You have been given two instructions, viz i) MOV DX, [12345 H] and ii) MOV AH, [12347 H). Suppose…
A: Given :Instructions :i) MOV DX, 12345 H ii) MOV AH, 12347 Hfrequency, f=10 MHzDuty Cycle=50 %
Q: Draw the circuit and explain the operation of electronic PID controller using operational amplifier
A:
Q: The output of a NAND gate is driving a 120pF capacitance. The switching probability of the NAND gate…
A: Dynamic power dissipation given by = @CV2f @ is activity factor or probability
Q: b) Answer the following questions. Be prolific in your answers. What is the purpose of the NPN BJT…
A: Ans1. The purpose of the NPN BJT transistor are that in the cut-off or saturation region it will…
Q: A high-speed microprocessor must drive a 64-bitdata bus in which each line has a capacitive loadC of…
A: It is given voltage applied across 64 capacitor bus is 2.5 Volt. Now, capacitor begins charging and…
Q: Draw and explain the circuit configuration and the timing diagram to have 4 wait pulse (Tw) using a…
A: Aim- To draw and explain the circuit configuration and the timing diagram to have 4 wait pulse (Tw)…
Q: 10. Using the timing diagram shown below, determine the Q output waveform for the…
A:
Q: Write the binary pattern for the following modulated signal if it was modulated using differential…
A:
Q: a) An interfacing diagram of 8251A with 8086 system is shown below. An important block is hidden in…
A: Answering the 1st question. a) The given figure shows the interfacing of the 8251A with 8086 system.…
Q: Write the shortest 8086 program which set AF, ZF, SF and reset CF, PF.
A:
Q: Q8. In single pulse width modulation of single phase inverter, if supply voltage is 220 V DC and…
A: Single pulse width modulation Rms fundamental output voltage?
Q: • How many states the PN sequence generator of DB20 have? • What is the length of PN sequence…
A: Dear student,you have posted multiple question in single request.we will solve only few question.If…
Q: Draw 8259A interfacing connections with 8086 at the address 0744H.
A: The 8259A interfacing connection with 8086 at address 0744h is shown below:
Q: 1. Design an asynchronous clocked MOD-13 counter and show its timing diagram. Consider the negative…
A: Negative edge triggered clock, asynchronous clocked MOD-13 counter:
Q: 18 initial state of the 10-bit ring counter is given as 1101000000. According to this, which of the…
A: Ring counter is nothing but a right shift register which shift the bits from left to right and msb…
Q: A- How many clock states are in a read bus cycle that has no wait states? What would be the duration…
A: According to the question, we need to explain the following
Q: Consider the transistor inverter driving a DC motor modelled as a 10mH inductor shown on the right.…
A: According to the question, for the circuit shown below we need to find iL(∞) and v0(∞), when input…
Q: Question 2 To design an AND logic gate using BJT, two transistors should be connected in series.…
A: Need to find true false
Q: 1. (a) Complete the following timing diagram for the NAND-based RS latch described the flowing…
A: The S and R latches are cross- coupled to form the NAND gate as shown below:
Q: Design an interfacing circuit for ADC 0804 and 8051 microcontroller with self-clocking. Also explain…
A:
Q: Q8. In single pulse width modulation of single phase inverter, if supply voltage is 220 V DC and…
A:
Q: If the waveforms (A & B) shown below are applied to the inputs of NOR gate and NAND gate, draw the…
A: Draw the output waveforms of NOR and NAND gates for the given input waves.
Q: How many OC signals are combined into a 40 Gbps SONET network
A: D) 516096 From table 39813.12 Mbps i.e 40 Gbps the number of OC signals/channels combined are 516096
Q: 8086 microprocessor IC with buffers
A: We will now focus on the 8086/88 hardware and pin functions – later we will review characteristics…
Q: Give the difference between VMOS and CMOS.
A: CMOS 1) CMOS (Complementary metal–oxide–semiconductor) is a class of integrated circuits. CMOS…
Q: The expression of output in the following CMOS circuit is
A:
Q: 3) What are the rise time, fall time, and average propagation delay of the NMOS gate in the below…
A:
Q: A circuit consists of forty picofarads capacitor, NAND gate and five hundred Ohm resistor.This…
A: CAPACITANCE OF CAPACITOR IS 40pF = 40X10-12 F SO, RESISTIVE VALUE = 12πfC = 12×3.14×f×40×10-12 OHM…
Q: You have been given two instructions, vizi) MOV DX, [22345 H] and ) MOV AL [34 HỊ. Suppose you have…
A: According to the question, we need to discuss (a) MOV DX, [2245 H] (b) MOV AL, [34 H] The 8086…
Q: For the 8085 microprocessor, the instruction (MVI B, 8-bit data) requires Fetch and Read machine…
A: The solution can be achieved as follows.
Q: Microprocessor Systems Question: A CMOS Schmitt inverter-based clock signal generator with 100 Ω…
A: The frequency and Duty cycle of the following CMOS Schmitt inverter-based clock signal generator is…
Q: Sketch a timing diagram of a 4-bit binary counter like the 74X163 showing the clock signal CLK and…
A: Sketch a timing diagram of a 4-bit binary counter like the 74X163 showing the clock signal CLK and…
Q: For the following state table, draw the sequential circuit. Show all the equations related to the…
A: Let us assume, we have two D flip-flops, with input D0 and D1. Construct the state diagram table for…
Q: Assume Vth = 1V and k = 50mA/V2. Given the schematic below, do the following: 1) Indicate and…
A: 1)
Q: Resistor Transistor Logic (RTL) circuits Explain( AND,NAND,NOR,OR AND NOT )
A:
Q: How can you measure the value of Vp or VGSoff and IDSS experimentally?
A: According to the question, we need to measure the value of Vp or VGSoff and IDSS experimentally.
If an 8086 running at 10MHz performs bus cycles with two wait states, what is the
duration of the bus cycle?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- Draw the bus cycle of 8086 mp?QB1.Explain the Minimum Model of 8086 With the Corresponding pin signals description. this is related to Microprocessor related question.A circuit consists of forty picofarads capacitor, NAND gate and five hundred Ohm resistor.This circuit generates clock pulses which are required to control a digital system. a)What is the frequency of the clock?(show working) b)What is the usefulfulness of the capacitor and the resistor in the drawing of the clock circuit?
- 1) Draw how an ASIC, SOC, MCU, MPU, DSP any TTL gates of the TTL circuits you have constructed or designed to use a transistor (BJT/MOS) to drive the current specification of a LOAD (ie RELAY, Motor, Light array of High powered LEDs)show how you can design high speed method of comparing two 24-bit wore with only two levels of device delay ?Microprocessor Systems Question: A CMOS Schmitt inverter-based clock signal generator with 100 Ω resistor and 20 nF capacitor, Assume that the Space is 0.8RC and the Mark is 0.5RC. Compute the frequency and duty cycle
- Discuss the features C8051F8xx series microcontroller. Draw the blockdiagram of the same and explain it in briefWrite a hierarchical gate-level HDL model of the multiplexer described in Problem 4.31 .IV (a) If R = 25 Kohm and C = 12 uF, find the frequency of the astable multivibrator using NAND gate? Draw the diagram and its output waveform for Vcc = + 15 V. (b) If C=9nF, the frequency F=72KHz of the Monostable multivibrator using NAND gate . Find the value of resistance ?