Answered: If anyone of the lamps is short…

Engineering

Electrical Engineering

If anyone of the lamps is short circuited in series circuit, the remaining lamps will not work. Select one: True False

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter3: Determining The Required Number Of Branch Circuits, Lighting Outlets, And Receptacle Outlets

Section: Chapter Questions

Problem 8R: How is the total load in volt-amperes for lighting purposes determined? See NEC 220.12 __________

See similar textbooks

Related questions

Q: Draw the circuit diagrams to differentiate between the series and parallel positive clippers and…

A: Series Clippers A series clippers can be used to clip off the entire positive or negative half…

Q: Which of the circuit types have the same value of voltage in the light bulbs? Circuit Types switch…

A: Which of the circuit types have the same value of voltage in the light bulbs None of these…

Q: In a parallel circuit, if any one lamp is short circuited, the other lamps are also stop working.…

A: Lamp will work only when some voltage is applied across lamp. Voltage is zero in short circuit.…

Q: one lamp is short circuited, the other lamps will wo

Q: Calculate the voltage and current values listed for each of the following series and parallel…

A: When the same current flows through all they resistors, they are said to be in series. In series…

Q: In parallel connection, if anyone lamp gets open circuited, the remaining lamps will light up.…

A: In a parallel circuit, the voltage across each element is the same, and a different current flow…

Q: What minimum number of 75 W lightbulbs must be connected in parallel to a single 20 V household…

A: 30 amp circuit breaker will trip at 30amp.. In practice less than that

Q: The Current rating of distribution box main switch is Select one: O 20A O 100A O 50A O6A

A: Assuming that the current rating of the distribution box main switch is asked for USA.

Q: Consider the following circuit, what is the maximum power that can be delivered to a load connected…

A: 3.125 Watt can be delivered. Detail solution in the image

Q: + Parallel-Series Connection

A: The cells are connected in series to increase the voltage rating of the system and connected in…

Q: 5. In a series circuit, if any one lamp is short circuited, the other lamps will work with less…

A: Choose the correct option The given statement is it true or false?

Q: 1- The low voltage winding is wound under the high voltage winding. Why.

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: If 2A, 4A, 9A, I current is entering into a node. What will be the value of 1?

A: According to Kirchhoff's Current Law, the total current at any node must be ZERO. i.e, the total…

Q: the power system can be improved by employing high speed circuit

A: In this question we will write , which component of power system can be improved by high speed…

Q: 15.For rangers of 8.75 kW or more in rating, the minimum branch circuit rating shall be:

A: Minimum branch current rating should be 40 amperes (A) for the rangers which has 8.75 KW rating or…

Q: There are many reasons why plenummed cabling is required above the ceiling tile:

A: Plenum-rated cable gets its name from a word in the HVAC industry that refers to "Plenum spaces." A…

Q: The maximum power during 7.prefault condition is lesser than maximum power under fault condition.…

A: Choose the correct option The given statement The maximum power during 7.prefault condition is…

Q: R

Q: In a series circuit, if any one lamp is short circuited, the other lamps will work with more…

Q: 3. Do batteries last longer in series or parallel

Q: Using your measured voltage values demonstrate kvl, clockwise from point A

A: Consider the given circuit,

Q: Series-Parallel Connection +

A: Cells are connected in series to increase the voltage rating of the system and connected in parallel…

Q: If anyone of the lamps is short circuited in series circuit, the remaining lamps still work. Select…

A: In series circuit if any lamps is short circuit the the current in remaining lamps is still flow…

Q: The type of connection selected to supply current for heavy loads using solar modules is a. None of…

A: When the solar modules is connected in series the voltage of the system increases. When the solar…

Q: Series Connection

A: The cells are connected in series to increase the voltage rating of the system and connected in…

Q: If anyone of the lamps gets open circuited In parallel circuit, the remaining lamps still work.…

Q: a) Three lamps A, B and C are connected in series to a 220Vsupply. If the lamps are rated 100W, 60W…

A: Power - It is defined as the ratio of work done into time. It is measure in Watt.…

Q: 31- Switching Overvoltage is an: a- Internal fault. b- External fault. C- Unbalance fault. d- All…

A: NOTE:- As per our company policy, experts are allowed to answer only 1 Question at a time, so only…

Q: Determine the current in the 1 ohm resistor using Source Transformation. *Round off the final…

Q: An SSO ring main current runs from both ends effectively make the amount of power needed to go…

A: given ring main

Q: overhead used for a DS 1 service

Q: how do i find the total current?

A: if two resistors are connected in series then total resistance is R1 + R2 if two resistors are…

Q: For the circuit shown below, what is the total current?

A: It is given that:

Q: A Da D

A: NOR Gate: A NOR gate (short for "not OR gate") is a logic gate that only generates a high output (1)…

Q: Calculate the voltage and current values listed for each of the following series and parallel…

A: Given circuit,

Q: The neutral current in a balanced star connected system is equal to

Q: X.a- The figure shows a fault condition in an ungrounded electrical system. Which of the following…

A: So in question we have the figure given and based on that we need to answer the condition that will…

Q: What is the resistance of the second lamp of this circuit?

A: If two resistors are connected in series then the equal distribution of the voltage occurs across…

Q: 4-_A fault is located somewhere on a 78 m line. Use the Varley loop test circuit as shown in the…

A: Given: For an earth-type fault in an underground cable, using the Varley loop test, the following…

Q: Since the voltages across each branch circuit in a residence are the same, these circuits are A.…

A: To select proper answer

Q: In parallel connection, if anyone lamp gets short circuited, the remaining lamps also will not light…

A: If the parallel connection If anyone lamp gets short circuit Then what will be effect on remaining…

Q: In star connected system, the voltage between any pair of terminal is voltage.

A: the three-phase system can be wound in two configurations, star, and delta

Q: Plenum cabling is necessary in the area above the ceiling tile for the following reasons:

A: In this case, the reason behind the necessity of plenum cabling in the area above the ceiling needs…

Q: Answers for calculated individual voltages Topic: the voltage divider circuit.

A: Voltage division rule is applied to the circuit which consists of the more than one series connected…

Q: Determine the power loss for the following circuit

A: In this question, Choose the correct option Determine the power loss for the following circuit? We…

Q: if a pure resistor is connected in parallel with the original impedance

Q: The type of cable used for a voltage of 25kV is called. Answer:

A: Need to find type of cable

Q: Label each connection point staring at B+ and working clockwise then record the total number of…

A: Correct wire connections and the use of wires is very sensitive work which must be done by an…

Q: Consider the following two diagrams of series circuits. For each diagram, use arrows to indicate the…

A: To give the comparison of voltage and current at different points asked

Question

If anyone of the lamps is short circuited in series
circuit, the remaining lamps will not work.
Select one:
True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What Is the opposite of redistance
True or False The resistor R characterizes alternating current circuits.
v Question Completion Status: A Moving to another question will save th Quèstion 5 A swing bus must be a Constant voltage bus None of the above Load bus PQ bus A Moving to another question will save this
Which of the following statements about the TRIAC is true: O A. None of the other choices are correct O B. TRIACS work in quadrants I and III only O C. TRIACS work in quadrants I, II, and III O D. TRIACS work in quadrants I and II O E. TRIACS work in all four quadrants
Break down simply how they got this diagram
AREF GND RESET 3.V SV GND GND Write a code to blink an LED connected to pin 3 five times with a delay of 500 ms each time using a for loop. There will be a pause of 3 seconds after each round DIGITAL (PWM-) OO UNO R ARDUINO POWER ANALOG IN
Coriolis flow meter is a type of -------- flow meter.
Which of the following statements is true of a shorted component in a series circuit? a. The resistance of the component will be higher than normal. b. The voltage drop across the component will be higher than normal. c. The current through the component will be lower than normal. d. The voltage drop across the component will be lower than normal.
What is the current through R1?
Will Upvote for solution
The maximum power during prefault condition is lesser than maximum power under fault condition.Select one:o TrueO False
Moving to another question will save this response. Quèstion 3 Which of the following is rotor fault of alternator? O Phase to earth O Over current Inter turn O Non of the option A Moving to another questioOn will save this response to search