If IR1 = 0.065 mA and IR2 = 0.098 mA in a two branch parallel circuit, IT = 0.163 mA. True False

Q: Consider the series R-L circuit shown in figure below. For obtaining transient free response, switch…

A: Given- R-L circuit, R=ωL,t=to,i=2sin 8t, To Find- The value of to.

Q: Find Ck for the sequence x(n) shown below px (n) 327 -2

A: Given: A discrete time sequence, To find: Complex Fourier series coefficient Ck

Q: How would u measure the amperage across a resistor with a multi-meter? a) Connect the multi-meter in…

A: Resistor: It is a property of the material that resists the flow of the current in it. Its unit is…

Q: 16V +1 Μ ΖΩ | 4Η

A: Given data, Circuit diagram is given as,

Q: The charge entering the upper terminal of the BOX in Figure shown below. How much energy is absorbed…

A: Given that: A black box and charge q(t) diagrams are shown in the question. Voltage is 12 V. Find…

Q: A 20kW, 4-pole induction motor is designed to operate from a 440V, 50Hz, three-phase supply, and…

A:

Q: If 5 V and 16 V power supplies are connected in series aiding, what is the total voltage? 16 V 80 V…

A: Given: Two power supplies are connected in series aiding. Vs1=5 V,Vs2=16 V.

Q: An energy meter makes 100 revolutions of its disc per unit of energy. The number of revolutions made…

A: Given, An energy meter makes 100 revolution with, Voltage, V=210 V. Current drawing, I=20 A. Power…

Q: Fig. shows the single line diagram of a 3-phase system. The percentage reactance of each alternator…

A:

Q: A 2H inductor has 500 turns. How many turn must be added to increase the inductance to 8H. O 500…

A: Given- 2H inductor, Number of turns, N=500, New inductance=8H. To Find- Number of turns to be added…

Q: The circuit shown in Fig. 21.32 uses variable resistor RE to change the fre- quency of pulses…

A: We have an circuit as shown in figure which uses resistor RE to change the frequency of pulses…

Q: Assume the following circuit has a silicon diode with a saturation current of 2.5nA at room…

A:

Q: Example 15.40. The power input to a 2000 V, 50 Hz, 3-phase motor running on full-load at an…

A: Given a 3-phase motor running on full load with, Readings of 1st wattmeter, W1=300 kW Readings of…

Q: 6. If the rms current through a 4.7 kn resistor is 4 mA, the peak voltage drop across the resistor…

A: The peak voltage is the maximum voltage of the input and the rms voltage is the average voltage of…

Q: input is; a) Unit impulse input: R(S) = 1 b) Unit step input: R(S) = 1/S c) Unit ramp input: R(S) =…

A: The circuit diagram given by:- Now Reference input is, a) Unit impulse input R(s) = 1 b) Unit step…

Q: [11] 5- A system with input matrix B= 0 1 has Lo 1 c- four inputs a- one input b- two inputs d-six…

A: As per the guidelines, we are supposed to answer only first question for multiple type questions.…

Q: 1-5. Minimize the function F = X+X+Y+XY

A:

Q: A balanced load of phase resistance 36 and capacitive reactance of 40 is connected in star…

A: Given data: Phase voltage at load: Vphase=255 VZphase=36-40j

Q: A piezoelectric crystal has a thickness of 2.5 mm and a voltage sensitivity of 0.05 Vm/N. The…

A: Given a piezoelectric crystal has, Thickness, t = 2.5 mm. Voltage sensitivity, s=0.05 VmN. External…

Q: A star-connected, 3-phase, 15 MVA, 3.3 kV alternator is protected by Merz Price circulating-current…

A: Given,For a 3-ϕ star connected alternator,S=15 MVAVL=3.3 kVR=8 ΩImin = 0.5 ACT ratio=10005

Q: Two identical coils X and Y of 500 turns each lie in parallel planes such that 80% of flux produced…

A: Given, Two identical coils X and Y with number of turns, Nx=Ny=500. Flux produced in X coil, φx=10…

Q: QUESTION 9 What is the function of the analog-to-digital (A/D) converter circuit used in analog…

A: There are two types of converter: 1. DAC(digital to analog converter): It is used to convert digital…

Q: Determine whether or not each of the following signals is periodic. If a signal is periodic,…

A:

Q: A CRO screen has 10 divisions on the horizontal scale. If a voltage signal 5 sin (314t +45°) is…

A:

Q: 1. Find vo. Note that is the voltage across the 4-ohm esistor. 192 40 V 5A 292 www 892 www 40 20 V

A:

Q: choose the correct expression for A + A B C : °A + Вс ОB+A C O B + AC C+ AB

A: Given logic expression, F=A+A.B.C

Q: Compute the convolution x[n] *h[n] for all n ≥ 0, by using Graphical or Tabular method.…

A:

Q: 3. CALCULATE Vout qua ป S V R3 I 2 K R₁ 5 K + R2 3K

A:

Q: A 60 MVA, 3 phase, 11 kV synchronous generator is protected by the Merz-Price protection using 1000/…

A:

Q: What are the benefitsof using CFLs over filament bulbs?

A: Given: Benefits of using CFLs over filament bulbs. Required: Advantages of using CFLs

Q: 4. x(t) = cost + sin √√2t

A:

Q: Identify at least five ways in which your life would be different without digital technology. Would…

A: Digital technology: The expression Digital technologies are electronic tools, systems, devices and…

Q: If a 68 Q2, 33 Q2, 100 Q and 47 Q resistor are connected in series across a 9 V battery, the current…

A: Given: The resistors connected in series are, R1=68 Ω,R2=33 Ω,R3=100 Ω,R4=47 Ω. Supply voltage, Vs=9…

Q: In the network below, find the power associated to the current source, for V1 = 7 V. 24 elect one:…

A: Given circuit: For, V1=7 V.

Q: The Pentium 4 Prescott processor, released in 2004, had a clock rate of 3.6 GHz and voltage of 1.25…

A: Given data for Pentium,  V=1.25 Vf=3.6 GHzPS=10 WPD=90 W Given data for core i5 Ivy bridge, V=0.9…

Q: The speed control of an AC motor can be achieved by using 2 common types of drive circuit, namely…

A:

Q: QUESTION 7 With reference to PLC discrete output modules: What types of fi eld output devices are…

A:

Q: Identify and realise the H(s) compensator with Operational amplifier. S+ 0.1\/S + 1 H(S) = (Sto…

A: Given data, Hs=s+0.1s+0.01s+1s+10

Q: 1. If the rms voltage drop across a 15 kn resistor is 16 V, t peak current through the resistor is…

A: Given data : R=15 kΩV=16 V

Q: Find V₁ V₂ V₂ > 30V + v. Apply KCL 1.5+ V₂ System J 3.A and KUL I, I2, I3 J + 162 Omh's law J and of…

A: A circuit diagram is shown ab below. Find V1, V2, V3, and I1,  I2, I3.

Q: image113

A: As per the honor code we can solve only one question at a time. Please repost your question to get…

Q: A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of…

A: Given: A DC generator with number of pole, P=8. Multiplexity of lap winding, m = 2 (duplex winding).…

Q: 3VKH *• 'N 3V 2k ww 2K the change with S Here V₁ and V₂ are two squaoce wares, and with time is as…

A: When a diode is forward biassed and operating as a perfect conductor with no voltage applied across…

Q: a.1) In a certain UJT, 'B1 = 2.5 KQ and r'B2 = 4 kQ. What is the intrinsic standoff ratio? a.2)…

A:

Q: 1.31 The current waveform as shown below, is applied in a pure resistor of 10 2. What is the power…

A: Given current waveform,

Q: MILL. 2. Could the input and the output impedance of this circuit be measured using an ohmmeter?…

A: ANSWER NO we can not measure INPUT and OUTPUT impedance of the circuit…

Q: Why do you think the gain of the amplifier is affected by the frequency of the input signal?

A: An amplifier is an electronic device that used to increase the power of a signal. They used increase…

Q: The Following Test to a lloku, 2300v, Foure pole, 60t 23 Inductio motor short circuit test V = 268 V…

A:

Q: 4. An LTI system is formed by connecting two LTI systems (system 1 and system 2) in parallel. Let…

A: Given data: An LTI system consists of, Two LTI sub-systems System 1 System 2 Connection type -…

Q: A. Determine whether or not the following signals are periodic. In case a signal is periodic,…

A: In the given questions we need to calculate the fundamental frequency of the given signal.

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.