Answered: If it is estimated that 75 percent of…

Name: If it is estimated that 75 percent of electricity consumed by the heat
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: If it is estimated that 75 percent of electricity consumed by the heater is transferred to the water as heat, determine the local atmospheric pressure in that location

Engineering

Mechanical Engineering

If it is estimated that 75 percent of electricity consumed by the heater is transferred to the water as heat, determine the local atmospheric pressure in that location

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
analyze the effect of the density of both liquids to the vertical height of the liquid B
Determine the atmospheric pressure at a location where the barometric reading is 720 mm Hg.
A vertical hydraulic cylinder has a piston with a diameter of 115 mm.If the ambient pressure is 100 kPa,determine the mass of the piston if the pressure inside is 950 kPa.
In a water distribution system, the temperature of water is observed to be as high as 30°C. Determine the minimum pressure allowed in the system to avoid cavitation.
Oxygen in a tank has an absolute pressure of 130 kPa. Determine the pressure head in mm of mercury.The atmospheric pressure is 102 kPa.
An open container is filled with water to a depth of three metres and then with oil with a density of 1600 kg/m3 to a depth of one metre. Calculate the pressure intensity at the interface of the two liquids and at the tank's bottom.
Nitrogen is contained in a 4 m^3 rigid vessel at a pressure of 4200 kPa. Determine the mass if the temperature is 30 C
The partition is now removed and the gas expands to fill the entire tank. Heat is now transferred to the gas until the pressure equals the initial pressure. Determine the final temperature of the gas.
Determine the pressure difference between the inside and outside of the 0.1 mm diameter air bublle in a liquid if the surface tension at the air-liquid interface is 0.075 N/m. Express your answer in 3 decimal places and in kPa. Kindly place a clear solution and the correct answer, following the required decimal places. :)
The 8.8-mm-diameter spherical balloon is filled with helium that is at a temperature of 28∘C and an absolute pressure of 106 kPa. The gas constant for helium is R = 2077 J/[kg⋅K]. Determine the weight of the helium contained in the balloon.
The initial pressures at A and B are the same at 103 kPa. If the pressure at the liquid at A (SG1 = 1.25) is increased to 148 kPa while keeping the pressure at B constant, determine the new position (Δh, in mm.) of the mercury meniscus inside the tube as shown. Assume no change in the liquid densities. The connecting tube is a 1-cm in diameter, Y1 = 0.51 cm, and the inclination of the tube is 18 degrees with respect to the horizontal. Assume unit weight of air to be negligible.