If 'N{ and 'N,' is the number of turns in the primary and secondary coils in an ideal transformer respectively, then the input resistance 'Rn' is Select one: 2 V2 \N2 V2 12 2 12 \N1 o V2 (N2 12 \N, 2.

If 'N{ and 'N,' is the number of turns in the primary and secondary coils in an ideal transformer respectively, then the input resistance 'Rn' is Select one: 2 V2 \N2 V2 12 2 12 \N1 o V2 (N2 12 \N, 2.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 49P: A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored...

See similar textbooks

Related questions

Q: Two long, parallel wires carry equal currents in opposite directions. The radius of each wire is a,…

A: To determine: The self-inductance of a length ‘l’ of pair of wires Introduction: Let us consider…

Q: Which particular part of a the motor can be used to identify an "AC motor? O a Split rings O b.…

A: Which particular part of the motor can be used to identify AC motor ?

Q: A 0.260 m radius, 570–turn coil is rotated one–fourth of a revolution in 4.73 ms, originally having…

A: Given data: Number of turns in the coil, n =570 turns Radius, r =0.26m time,∆t =4.73 m s=4.73×10-3s…

Q: Why does an iron core that extends inside and connects the primary and secondary coils intensify…

A: Magnetic materials are classified into different types based on their behavior in the external…

Q: How fast must a straight 0.25m wire move through a 5.5x10-³T magnetic field in order to induce a…

A: Let B denotes the magnetic field, L denotes the wire’s length, V denotes the motional emf, and v…

Q: One simple, though impractical, way to generate electrical power is shown below. A bar of metal with…

A: Given data: The magnetic field around the bar, B= 0.75T The velocity of the bar, v=0.4m/s The length…

Q: Two solenoids are part of the spark coil of an automobile. When the current in one solenoid falls…

A: The mutual inductance between two solenoids can be related to the self-inductance of the two…

Q: The magnetic potential P at a point on the axis of a circular coil is given by:- see the equation as…

A: Given, P =2πNIrk∫c∞1r2+x332dx where, N, I,r,k, and c are constants.

Q: If a solenoid is 10 cm long and has a radius of 1 cm, how many coils would be necessary to make an…

Q: Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance…

Q: State two factors on which the magnitude of induced emf in a coil depend.

A: induced emf in the coil depends on many factors,1) number of turns in the coil2) the magnetic flux…

Q: In a coil with radius of 6 cm and 400 turns, there is a magnetic field leaving in a direction…

Q: A non-magnetic ring having a mean circumference of 130 cm and a cross-sectional area of 7.5 cm2 is…

Q: A 10-V, 1.0-A dc current is run through a step-up transformer that has 10 turns on the input side…

A: Transformer is device which works in AC source

Q: A 20.9 turn conductive loop encloses an area of 0.57 m2. At what constant rate should the magnetic…

A: Given:- A 20.9 turn conductive loop encloses an area = 0.57 m2.…

Q: Calculate the inductance of a solenoid with 146 turns if the length of the solenoid is 18_cm and its…

Q: A generator consists of few turns of wire, and each turn has an area of 0.085 m2. If a maximum e mf…

A: Given Data : The area of each turn is given as A=0.085 m2 The maximum EMF generated in the generator…

Q: How does the induced magnetic field at the center of the solenoid change with the number of turns?

A: In this problem, it is asking how does the induced magnetic field at the center of the solenoid…

Q: How does the self-inductance per unit length near the center of a solenoid (away from the ends)…

A: The expression for the self inductance , L=μN2Al

Q: - A metal rod 0.95 m long moves with a speed of 2.4m/s perpen- dicular to a magnetic field. If the…

A: Emf induced between both ends of moving rod in magnetic field is, ε=vBl Given : Emf induced between…

Q: Two solenoids are close to each other as shown in the figure, with the switch S open. When the…

A: Initially, current in right solenoid is zero. As switch is closed, a current starts flowing in the…

Q: generate

A: If the strength of the magnetic field is also increased then the wire moves through a stronger…

Q: A 100-turn square wire coil of area 0.040 m2 rotates about a vertical axis at 1,450 rev/min, as…

A: Coil of area (A) = 0.040 m2 Number of turns (N) = 110 Angular frequency (ω) = 1450 rev/min = 1450…

Q: A 0.250 m radius, 500-turn coil is rotated one-fourth of a revolution in 4.17 ms, originally having…

Q: nagnet in the previous question is now plunged into a coil that has tu v, the induced current in the…

A: Thus emf induced is proportional to rate of change of magnetic flux.

Q: if two coils placed next to one I know there have a mutual inductance of 3.00 MH, what voltage (in…

Q: What is the peak emf generated by a 0.250 m radius, 500-turn coil is rotated one-fourth of a…

A: Given data: The radius of the coil is R=0.250 m. The number of the turns in the coil is n=500. The…

Q: 2. What is the self-inductance of a coil with 450 turns if a steady current of 4.0 A generates a…

Q: Two coils close to each other have a mutual inductance of 32 mH. If the current in one coildecays…

Q: What is the mutual inductance of two coils if an average electromotive force of 0.15 V was induced…

Q: Upon which one or more of the following does the magnetic energy of a coil that carries a current…

A: The strength or intensity of a coils magnetic field depends on the following factors. The number of…

Q: The current in a circuit containing a coil, a resistor, and a battery has reached a constant value.…

A: (a) In the L-R circuit, as the current increases in the coil, it opposes the change but after a…

Q: Which part of the D.C motor is used to change the direction of aurrent after a half cyc O a. Loop or…

A: Required : Which part of the DC motor is used to change the direction of the current after a half…

Q: ... .. In a transformer the mutual inductance of two coils is 0.3 H where as the self inductance of…

Q: An e.m.f of 30 volts is induced in a coil of inductance 60 H, then the rate of change of current is…

A: Given data: The e.m.f. induced in the coil is, e=30 V The inductance of the inductor is, L= 60 H…

Q: induced=-NAD, At В What will increase the Voltage produced by a moving magnet? OIncreasing the area…

A: The induced voltage is given by the expression : Vinduced = - N ×∆ϕB∆t where ϕB = magnetic flux =…

Q: An emf of 24.0 mV is induced in a 500-turn coil when the current is changing at a rate of 10.0 A/s.…

Q: A magnetic field of 0.200 T exists within a solenoid of 340 turns and a diameter of 10.0 cm. Within…

Q: The field outside the coils of the solenoid is nearly zero. Why?

A: Solenoids are long straight coil of wires used to generate nearly uniform magnetic fields similar to…

Q: The self-inductance of a coil of 500 turns is 0.25h. Y 60% of the flux of the last coil of its speed…

A: Given, No.of coil(N)=500 Self-inductance (L)=0.25h Current per second=100amp/sec

Q: 3.60 The transformer (as shown) must be lifted vertically out of the pit. Angle0 = 18°. Determine…

A: For the net force to be vertical, the horizontal components of the two forces must cancel each…

Question

If 'N{ and 'N,' is the number of turns in the primary and secondary coils in an ideal
transformer respectively, then the input resistance 'Rn' is
Select one:
I2 (N
V2 \N2
V2 (N,
V2 (Nz
12 \N1.
V2 (N2
I2 \N1
2.
2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored in the magnetic field of the inductor? (Hint: Use the value Lf= 334 J/g for ice.)
At the instant a current of 0.20 A is flowing through a coil of wire, the energy stored in its magnetic field is 6.0 × 10-3 J. What is the self-inductance of the coil?
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the current flowing through a rectangular toroid when the energy in its magnetic field is 2.0 × 10-6 J?
Is the work required to accelerate a rod from rest to a speed v in a magnetic field greater than the final kinetic energy of the rod? Why?
A bar magnet falls under the influence of gravity along the axis of a long copper tube. If air resistance is negligible, will there be a force to oppose the descent of the magnet? If so, will the magnet reach a terminal velocity?
Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance per meter of in infinite, but otherwise identical, solenoid?
The rod shown below moves to the right on essentially zero-resistance rails at a speed v=3.0m/s . If B = 0.75 T eveywhere in the region, what is the current through the 5.0 resistor? Does the current circulate clockwise or counterclockwise?
How would you position a flat loop of wire in a changing magnetic field so that there is no Induced emf in the loop?
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
Suppose you wish to produce 1.2-T magnetic field in a toroid with an iron core for which =4.0103 . The toroid has a mean radius of 15 cm and is wound with 500 turns. What current is required?