If the circuit is moved to position 2, find the current after 2 seconds. The circuit before disconnecting the RL circuit from the battery is 20 A. The resistance is equal to 5 ohms while the inductance is equal to 2 Henries. A. 19.865 A B. 0.135 A C. 11.013 A D. 8.987

If the circuit is moved to position 2, find the current after 2 seconds. The circuit before disconnecting the RL circuit from the battery is 20 A. The resistance is equal to 5 ohms while the inductance is equal to 2 Henries. A. 19.865 A B. 0.135 A C. 11.013 A D. 8.987

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter26: Three-phase Circuits

Section: Chapter Questions

Problem 3PA: You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a...

See similar textbooks

Related questions

Q: 7. A círcuit whose resistance is 20 ohms inductance of 10 H has a steady state voltage of 100 volts…

Q: aj= 2 cm &=7 Eg=50 kV/cm a;= 4 cm &;=4 Eg= 60 kV/cm a;= 2 cm &=6 Eg=20 kV/cm a;=1 cm &#2 Ex=120…

A: 500kV between the electrodes of the four-layer uniform field electrode system given in the figure…

Q: A single core cable for use on 11 kV, 50 Hz system has conductor area of 0.645 cm² and internal…

A: We have a single-core cable for use on system having, Voltage (V) = 11 KV frequency (f) = 50 Hz…

Q: 17.10 Figure 17.26 shows a thermal system involving two compartments, with one containing a heater.…

A: Given:

Q: COURSE: Electrical Engineering SUBJECT: Electrical Apparatus INSTRUCTIONS: • Write the GIVEN with…

Q: The resistance of the filed coils with copper conductors of a dynamo is 120 2 at 25°C. After working…

A: We known that resistance is changed as the temperature is changed so that value of resistance is…

Q: n the circuit shown, 3Ω b + Determine the following: 2 v+ A. Magnitude and direction of the current…

Q: In the circuit below, if the inductance L is large enough to operate in continuous current mode. a)…

Q: QUESTION 3 An inductor with an inductance of .5 henrys (H) is to be connected to a 60 Hz circuit.…

A: Solution of question (3): Given value of the inductance of the inductor is L=0.5 H. Given value of…

Q: A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source.…

Q: 11. The power taken by a resistor coil made of copper wire is 220 w, 110 V at 20 -c.Calculate the…

A: Given, P=220 WV=110VTemperature (T1)=20°CTemperature (T2)=120°CTemperature coeffecient =…

Q: Example Question 1 A dynamometer-type AC ammeter made of moving coils and fixed coils with a shunt…

A: Given: Resistance, R=10 Ω Shunt resistance, Rs=0.004 Ω Full scale deflection, 6.7 A To find: Graph…

Q: 57. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following…

A: This question belongs to circuit theory . It is based on the concept of ac analysis for circuit . It…

Q: Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an…

A: The operating line voltage is given as 11kV then the phase voltage:

Q: potentials across the first and second insulator from the top are 8 kV and 11 kV respectively.…

A: The solution can be achieved as follows.

Q: Given a series circuit comprised of the following element: 90.69-ohm resistor, practical inductor…

Q: Time left 0: IZOA 202- Assuming suitable sign of the complex impedance of the inductor and the…

A: In this question, We need to determine the current through the 6ohm resistance? Real power P…

Q: (A + V2 B Let V2(t) = 0 volt, inductor value be 8 Henry, and current through the inductor i(0) = 2…

Q: Select the false comment about the Alternating Current and Direct Current. A Direct current is…

A: In this question we will find false statement about dc and ac currents...

Q: An alternating current, i = 1.414 Sin (2 π x 50 x t) A, is passed through a series circuit…

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (a) the inductive…

A: As per our guidelines we are supposed to be answer only the first 3 questions. Kindly repost the…

Q: Question 1) Both simulation and theoretical results are expected to be provided. 50 ohm 0.3H 15 uF…

Q: An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following…

A: In this question, A RLC circuit connect with 110V , 50Hz battery. Find the all data as per given…

Q: 0.5x H v(t) i(t) :0.25x F x ohms

A: buo

Q: QUESTION 6 A motor with 15mH of inductance and an unknown internal resistance is connected to a 50V…

Q: In the circuit shown, Determine the following: a) The equivalent reactance and its nature (inductive…

Q: motor with 1mH of inductance and an unknown internal resistance is connected to a 100V RMS 10kHz…

Q: (a) The energy stored in 1400 turns inductor is 10 Joules. If the inductance value is 2 H, Find the…

A: To find the current through the coil And flux linking with the coil in mwb Average induced emf

Q: Q1: What factors change the time constant? Q2 : If you increase the EMF of the used power supply ,…

A: In this question we need answer the following questions.

Q: 17) (a) Find the equivalent capacitance between terminals a and b of the circuit shown below. Ceq =…

Q: A steady current of 3 A is flowing through an inductor with 60 volts across it. Find (a) Inductance…

Q: COURSE: HIGH VOLTAGE TECHNIQUE In an insulating environment consisting of insulating oil (Ɛr1=12.5)…

A: For the given data Ɛr1=12.5 ( Insulating oil ) Ɛr2=2.5 ( Porcelain ) ELectric field strength in…

Q: See the circuit shown below. Write the expression for the current i, and the voltage vi following…

Q: Q4. The equation relating the current in a circuit with time is i=282.1 sin377t, where the current…

Q: H.W.pdf -> University of Technology Department of Electrical Engineering Class: First (B and…

A: In this question we have to find unknown voltage... Note:- due to bartleby policy I will give answer…

Q: 7. The ripple voltage in the d.c. output is small if a) frequency of supply is high b) the filtering…

A: 1. The ripple voltage in the d.c. output is small if: Ripple voltage is given by the following…

Q: A series circuit consist of a resistor R= 20 ohm, an inductor L=0.5 henry, a capacitor C= 0.001…

Q: Two coils A and B are connected in series across a 230V, 60Hz supply. The resistance of A is 5 ohms…

A: In this question we have given two coils with one resistance and one inductance with voltage and…

Q: balance, the observations were the value of the circuit parameters: CN =100 Pf , R3=3180 ohm , R4…

Q: Calculate transient voltage uC(t) after commutation in circuit shown in the figure. Assume: R1=1O,…

Q: Q2: A) If there are two capacitors denoted as C1 and C2 and they have the same parallel plate area…

Q: 14: Which of the following circuit elements will oppose the change in circuit current?…

Q: Calculate the time constant, Trl of the circuit shown in Figure 2. If the function generator…

Q: 7. The ripple voltage in the d.c. output is small if a) frequency of supply is high b) the filtering…

A: Q7 Need to find if ripple voltage small with the given voltage Note : as per rule we have to solve…

Q: An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135…

A: Apply KVL in loop to find diffrential equation defining inductor current. Using diffrential…

Q: Question No. 6 For the network of Figure 6, find the mathematical expressions for the current i, and…

A: We need to find out the current through inductor in RL circuit .

Q: Connect a battery to a solenoid A cylindrical solenoid 40 cm long with a radius of 2 mm has 300…

A: Given Data: l = length of solenoid = 40 cm = 0.40 m r = radius of solenoid = 2 mm = 0.002 m A = area…

Question

Mixing (non reacting fluids), Electric circuits.

Problem:

A. 19.865 A B. 0.135 A

C. 11.013 A D. 8.987 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
Exercise 2: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and (e) Voltage across the resistor for the circuit given.
A coil of inductance 2 Henrys and a resistance of 10 ohms is connected with an emf, E=200sin20t volts, where t is the time in seconds. I=0 when t=0. Find I when t=0.05 second.
Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A: a) find the value of inductive reactance as well as inductance value? B) If θ = 45 then calculate the power dissipation in kW when it is connected in Delta.
An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following series resistances and reactances: R1 = 10 ohm, R2 = 15, R3 = 5 ohms, XL1 = 20 ohms, XL2 = 25 ohms, XC = 40 ohms. Find the following: a.) EQUIVALENT REACTANCE b.) TOTAL IMPEDANCE c.) VOLTAGE DROP ACROSS THE CAPACITOR d.) TOTAL INDUCTANCE IN MILLIHENRY e.) TOTAL CURRENT f.) REACTIVE POWER g.) REAL POWER DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
In the circuit below, if the inductance L is large enough to operate in continuous current mode. a) Draw the waveform of the output voltage and mains current for the 45 degree trigger angle when the switch S is in transmission. b) Average value of output DA voltage VDC1 when switch S is open, output DA when switch S is closed (in transmission) If the average value of the voltage is VDC2, calculate the value of VDC1 / VDC2. Lesson: power electronics please quick
An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (a) the inductive reactance, (b) the current in the circuit, (c) the average power taken by the inductor, (d) the maximum power delivered to the inductor or returned to the source. Write the equations for (e) the current, and (f) the power. Please give the step-by-step solution of all of these. Thank you!
An alternating current, i = 1.414 Sin (2 π x 50 x t) A, is passed through a series circuit consisting of aresistance of 100-ohm and an inductance of 0.31831 henry. Find the expressions for the instantaneous values of the voltages across (a.) the resistance(b.) the inductance and(c.) the combination.
i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A determine the capacitance of each of the capacitors. If the θ = 600 then calculate the power dissipation in kW when it is connected in STAR? ii) Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A, find the value of inductive reactance as well as inductance value. If θ = 450 then calculate the power dissipation in kW when it is connected in Delta?
A supply of 250 V, 80 Hz is connected across an inductive load and the power consumed is 2 kW, when the supply current is 10 A. Determine the following: (a) The resistance of the circuit in ohm. (b) The inductance of the circuit in mH. ) (c) The power factor of the circuit.
Identify the characteristics of AC and DC voltage. Runs at a higher temperature Answer 1Choose...DCAC More dangerous to transfer Answer 2Choose...DCAC Easy to produce Answer 3Choose...DCAC Easier to transform voltages Answer 4Choose...DCAC Voltage remains at a constant value Answer 5Choose...DCAC Cheaper to produce