016 part 1 ofAn uncharged capacitor and a resistor areconnected in series to a source of emf. If the emf is 7.01 V, the capacitance14.6 µF, and the resistance 282 2, find thetime constant of the cireuit.Answer in units of ms.017 (part 2 ofFind the maximum charge on the capacitor.Answer in units of C.018 (part 3 ofFind the charge on the capacitor after onetime constant.Answer in units of uC.

Answered: Image /qna-images/answer/6ffc051a-054d-4a3e-bc38-e2dafccb08ab.jpg

If the emf is 7.01 V, the capacitance 14.6 µF, and the resistance 282 2, find the time constant of the circuit. Answer in units of ms. 017 (part 2 of Find the maximum charge on the capacitor. Answer in units of pC. 018 (part 3 o Find the charge on the capacitor after one time constant. Answer in units of uC.

If the emf is 7.01 V, the capacitance 14.6 µF, and the resistance 282 2, find the time constant of the circuit. Answer in units of ms. 017 (part 2 of Find the maximum charge on the capacitor. Answer in units of pC. 018 (part 3 o Find the charge on the capacitor after one time constant. Answer in units of uC.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 60PE: Camera flashes charge a capacitor to high voltage by switching the current through an inductor on...

See similar textbooks

Similar questions

DC Circuits (Ohm’s Law and power dissipation) During the winter, an electric heater runs for 10 minutes while conducting a charge of 7500C. What is the resistance in the circuit if plugged into a 116-V outlet? How much power is produced by the heater?
A heater is being designed that uses a coil of 14-gauge nichrome wire to generate 300 W using a voltage of y= 110V. How long should the engineer make the wire?
An 1800-W toaster, a 1400-W electric frying pan, and a 75-W lamp are plugged into the same outlet in a 15-A, 120-V circuit. (The three devices are in parallel when plugged into the same socket.). (a) What current is drawn by each device? Will this combination blow the 15-A fuse?
A voltage occurs across an open switch. What is the power dissipated by the open switch?
The temperature in Philadelphia, PA can vary between 68.00F and 100.00F in one summer day. By what percentage will an aluminum wire’s resistance change during the day?
An evacuated tube uses an accelerating voltage of 40 kV to accelerate electrons to hit a copper plate and produce X-rays. Non-relativistic ally, what would be the maximum speed of these electrons?
Nichrome wire is used in some radiative heaters. (a) Find the resistance needed if the average power output is to be 1.00 kW utilizing 120-V AC. (b) What length of Nichrome wire, having a cross-sectional area of 5.00mm2, is needed if the operating temperature is 500°C ? (c) What power will it draw when first switched on?
Integrated Concepts A light-rail commuter train draws 630 A of 650-V DC electricity when accelerating, (a) What is its power consumption rate in kilowatts? (b) How long does it take to reach 20.0 m/s stalling from rest if its loaded mass is 5.30 1()4 kg, assuming 95.0% efficiency and constant power? (c) Find its average acceleration. (d) Discuss how the acceleration you found for the light-rail train compares to what might be typical for an automobile.
There is a voltage across an open switch, such as in Figure 21.43. Why, then, is the power dissipated by the open switch small?
A cassette recorder uses a plug-in transformer to convert 120 V to 12.0 V, with a maximum current output of 200 mA. (a) What is the current input? (b) What is the power input? (c) Is this amount of power reasonable for a small appliance?
Is every emf a potential difference? Is every potential difference an emf? Explain.
Integrated Concepts (a) What is the average power output of a heart defibrillator that dissipates 400 J of energy in 10.0 ms? (b) Considering the high-power output, why doesn’t the defibrillator produce serious burns?