If the endpoints you reached during standardization of your NaOH solution were very precise (relative average deviation if 0.03%) but were all overshot (meaning too much NaOH was added an you passedyour equivalence point), is the reported molar concentration of the acid solution from this experiment greater than , less than or equal to the true concentration? Explain.

If the endpoints you reached during standardization of your NaOH solution were very precise (relative average deviation if 0.03%) but were all overshot (meaning too much NaOH was added an you passedyour equivalence point), is the reported molar concentration of the acid solution from this experiment greater than , less than or equal to the true concentration? Explain.

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter4: Least-squares And Calibration Methods

Section: Chapter Questions

Problem 10P

See similar textbooks

Similar questions

sing the pictures please help me with these questions.-Volume of unknown acid___-Average molarity of NaOH from above__-mL of NaOH at equivalence point__-molarity of unknown acid__(there was only one trial so average molarity and standard deviation are not required)
25 ml of pickled brine was taken from an apple pickled with vinegar and diluted to 500 ml, 25 ml of this was taken and acidity was determined with 0.2 N (Factor: 1.05) NaOH. In the main trials, 6.3 ml - 6.5 ml - 6.9 ml, respectively, 0.1 ml base was used in the analysis without using the sample.For example, how many ppm is its acidity?
Using a balance with a sensitivity of 4 mg, an acceptable weighing error of 5%, and cherry syrup asthe solvent for tartar emetic, how could you obtain the correct quantity of tartar emetic to fill theprescription?
To quantify the amount of ethanol in a beverage, a technician prepared the first solution which contained 4.90 grams unknown, 1.00 grams acetonitrile, and 4.10 grams water. After the GC analysis which reported the peak areas of 5,742 for ethanol and 3,829 for acetonitrile, the technician added 0.20 grams ethanol to the first solution and ran the GC analysis again. This time, the peak areas of 6,382 for ethanol and 3,709 for acetonitrile for solution 2 were obtained. What was the percent by mass ethanol in the original beverage?
Vitamin C Analysis, a student accidentally puts 1.0 g of sodium bicarbonate (NaHCO3) solid into the vitamin sample solution for trial #1 instead of 0.5 g as the procedure instructs. How does this procedural change impact the calculated milligrams of ascorbic acid in the sample?
Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.
Tim is interested in analyzing for Pyraclostrobin (pesticide) in strawberries using QuECHers method for extraction and clean up before analysis with HPLC-uv. The concentration of the Pyraclostrobin in the fruits that he sampled is thought to be between 1-10 ng pesticide per g fruit fresh weight. The HPLC-uv instrument he is using has a LoQ of 5 ppb for Pyraclostrobin. Tim is starting out with 500 mg of the sliced fruit
assignment 3. an exhibit shows a peak at 2.4 minutes in a gas chromatogram. a sample of known heroin also has a retention time of 2.4 minutes using the same instrument under the same conditions. the fact that both the unknown and the known have the same retention time is indicative of their being the same substance, but it does not prove this relationship. discuss?
a sample of butyl benzoate is prepared to use as an internal standard. The results of a preliminary run, which used a solution known to contain 1.53 mg/mL of methyl benzoate (peak A) and1.68 mg/mL of butyl benzoate (peak B), are shown. The area of peak A is determined to be 352 and the area of peak B is determined to be 416 measured in arbitrary units by the computer. To measure the sample, 1.00 mL of a standard sample of butyl benzoate containing 2.19 mg/mL is mixed with 1.00 mL of the plant stream material. Analysis of the mixture gave a peak area of 449 for peak A and 411 for peak B. What is the concentration of methyl benzoate in the plant stream? concentration of methyl benzoate = ____________________ mg/mL
A compound X is to be determined by UV/visible spectrophotometry. A calibration curve is constructed from standard solutions of X with the following results: 0.50 ppm, A = 0.24; 1.5 ppm, A = 0.36; 2.5 ppm, A = 0.44; 3.5 ppm, A = 0.59; and 4.5 ppm, A = 0.70. Find the following: 1. slope and intercept of the calibration curve 2. the mean concentration of the solution of unknown X concentration if the absorbance of 3 replicates are A = 0.29, A = 0.30 and A = 0.32. 3. the standard deviation in the concentration of X
Read the detailed procedure of an experiment in your screen. Evaluate each step in the procedure whether it belongs to HOMOGENIZATION, EXTRACTION, PURIFICATION/CONCENTRATION, DATA TREATMENT, or INSTRUMENTAL ANALYSIS step.
Qno1: why there is a need of chromatography and chromatography thecniqs. B) when and where we should use normal and reverse phase chromatography