If the impedance of a series RC circuit is given as ( 10+j15) ohms and is connected to an ac source of 200v,50HZ, then the value of capacitive reactance is Select one: a. 5 Ohm b. 3 Ohm c. 2 Ohm d. None of these

If the impedance of a series RC circuit is given as ( 10+j15) ohms and is connected to an ac source of 200v,50HZ, then the value of capacitive reactance is Select one: a. 5 Ohm b. 3 Ohm c. 2 Ohm d. None of these

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.18P: Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of...

See similar textbooks

Related questions

Q: Figure P9.78 5Ω 45 N j20 N 425 /0° V (rms) j5 n3 j125 ) 10.43 Suppose an impedance equal to the…

A: Given circuit shown

Q: Use phasor/frequency domain techniques to find the equation for vc(t) steady state. Start by drawing…

Q: A series RLC circuit having values of ? = 250Ω, ? = 3??, and ? = 4?? is shunted across a sinusoidal…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Consider the circuit below, which is in steady state. The source current, is(t) is given by is(t) =…

Q: 3) Solve the problems in this section with the circuit given below when vi(t)=10cos(10t) V 1.5 H…

Q: When the average real power absorbed by an impedance is zero, then the impedance is: Select one: O…

A: The real power is absorbed by the resistor only when there is a combination of inductor and…

Q: Problem #2: For the circuit below, i, (t) = 5 cos 10t A. a) Use Phasor Analysis and obtain the…

Q: A 480V rms source supplies load that absorbs 100 kW at 0.7 lagging power factor. A capacitor is then…

A: The solution is given below

Q: 14. In the AC circuit shown, the potential difference across the capacitor and the resistor, V3D, is…

A: The solution is given below

Q: A series RLC circuit is connected to an AC power source, as shown in the figure. Given that the…

Q: This circuit has a sinusoidal input voltage V,(t) = 4cos (wt) with w=2,000 rads/sec. Is (t) R=1_N…

A: To find impedance of the circuit diagram it is clearly visible that resistor is in series with…

Q: 17. A fanction is given by a(t) sint + cos 2t. Which of the following is true a 2(t) has frequency…

Q: A voltage is applied across the terminals of an inductor. The voltage is a 2.5 kHz sinusoidal…

A: Given: supply frequency (f)=3 kHz Peak supply voltage (Vm)=5 mV Peak inductor current in…

Q: The inductance and capacity values used in a transmission path are 20 mH and 60 nF, respectively.…

Q: The device is represented in the frequency domain bya Norton equivalent. When a resistor having an…

A: Given: The device is represented in the frequency domain by a Norton equivalent. When a resistor…

Q: A 90 Ω resistor, a 32 mH inductor, and a 5μF capacitor are connected inseries across the terminals…

A: Given: A circuit in which

Q: An AC voltage of the form Av = 65 sin 330t where Av is in volts andt is in seconds, is applied to a…

Q: For an exhibition project you are designing a circuit of signal processor which can be connected to…

A: The circuit of the signal processor consists of an inductor, capacitor, and resistor connected in…

Q: Use phasor/frequency domain techniques to find the equation for vc(t) steady state. Start by drawing…

Q: Problem #2: For the circuit below, i, (t) = 5 cos 10t A. a) Use Phasor Analysis and obtain the…

Q: A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this…

A: Let us revise what will be the impedance provided by passive components A resistor with resistance…

Q: a) Given the sinusoidal voltage source in a linear circuit is V, (1)= 30 sin (20r + 50°) V. Identify…

Q: 1) Given the sinusoidal voltage v(t) = 50 cos(30t + 10°) V, find: (a) the amplituc (c) the frequency…

Q: R-C Series Circuit. In an AC series circuit containing capacitance C and resistance R. Which of the…

A: Use basic electric circuit laws and phase diagram technique. According to kvl sum of the voltages in…

Q: Consider the circuit below and answer the following questions. Vi1 R3 R1 Vo Vi2 R2 a. Determine an…

A: Please find the detailed solution in below images.

Q: 2. At the EPC company that you are currently employed, the Engineering Manager has purchased a new…

Q: 5. The source voltage in the circuit is v, = 50 cos(2000r) V. a) Construct the frequency-domain…

Q: Mathematically, out of phase means that the phase angle of two waves are the different and its phase…

A: In this we will write circuit problems...

Q: 3) Solve the problems in this section with the circuit given below when vi(t)=10cos(10t) V 1.5 H…

Q: An AC voltage of the form Av = 65 sin 330t where Av is in volts and t is in seconds, is applied to a…

Q: If the impedance of a series RC circuit is given as ( 10+j15 ) ohms and is connected to an ac source…

A: Given Z=10+j15 ohm, Vs=200 V

Q: A 90-ohm resistor, a 32 mH inductor, and a 5 uF capacitor are connected in series across the…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

A: The solution is given below.

Q: For the circuit shown in the Figure, if w = 10 rad/s, the thevenin impedance as seen by the…

A: In a linear active bilateral network consisting no. of energy sources, Impedances etc with open…

Q: The sinusoidal signal x(t) = 3 cos(200t + m/6) is passed through a square-law device defined by the…

Q: What is the real component for the equivalent impedance, Zeq, for the following circuit if = 790…

A: Given data, ω=790 rad/s

Q: f(t) 3 8. f(t) = ao + an cos nwt + b, sin nwt n=1 b) 00 f(t) = Co + > Cn cos( nwt + 0n) n=1 4+ 2.

A: Fourier series

Q: An RLC series circuit constructed with R=1002, L= 2 H, C= 1 mf, for an AC source with angular…

A: For the given series RC circuit we need to find a equivalent impedance of the circuit.

Q: 1) For the circuit shown blow， calculate ?_out assuming that ?_1 = 5?Ω ?_2 = 15?Ω and ?_in 12V .…

A: It is given that: R1=5ΩR2=15ΩVin=12 V

Q: Problem 1 • A sinusoidal current of 10Arms at a 60Hz fundamental frequency is contaminated with a…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: VR), magnitude of the voltage across inductance (VL) and capacitance (Vc the following RLC series…

A: In this question we will find voltage source value and active power consumption with given data....

Q: 2.5 H 2 18 2 12cos10r V 4 mF 0.8 H 3 5 mF

Q: The AC voltage source energizes the series R-L-C circuit. What should be the operating angular…

Q: The device depicted in the figure below, is represented in the frequency domain by a Thevenin…

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A: Given: Series RLC circuit with,R=8ΩL=32mHC=800μFe=120sin125t

Q: Consider the circuit shown in figure Q1. let vs (t) =120 Cos (314t -50°) V. (a) Construct the…

A: given values of R,L and C and asked the frequency domain circuit and steady state current

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

Question

If the impedance of a series RC circuit is given as ( 10+j15) ohms and is connected to an ac source of
200v,50HZ, then the value of capacitive reactance is
Select one:
a. 5 Ohm
b. 3 Ohm
c. 2 Ohm
d. None of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
Determine the time-domain expressions for the line-to-line voltages vAB, vBC, and vCA. Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees
A series circuit of RLC with following parameters, R=15 ohm, L=20 m H & C=100 micro Farad. VT=169.7 sin (337t-30) Volt. Find the following: Zt, , It, Voltage across each element, Power factor, apparent power, real or average power and reactive power and the total phasor diagram and power phasor diagram
10.1 Sketch and fully label the impedance diagram (also show the exact value for the magnitude and phase angle of Zt) for the following expression: Zt = 20 – j455 ohm.
assume that the voltage drop across the resistor, ER, is 78v, that the voltage drop across the inductor, EL is 104v and the circuit has a toatl impedance Z of 20 ohmas. the frequency of the ac voltage is 60HZ,
A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A SOURCE OF EMF HAVING THE EQUATION e = 340sin 754 VOLTS. CALCULATE, (A) THE VALUE OF Z, R, AND XC, (B) CAPACITANCE, AND (C) AVERAGE POWER.
The impedance ZL in the circuit is adjusted for maximum average power transfer to ZL. The internal impedance of the sinusoidal voltage source is 4+j7 Ω. 1. a) What is the maximum average power delivered to ZL?2. b) What percentage of the average power delivered to the lineartransformer is delivered to ZL?
4 Sinusoidal voltage source of us(t) = [100 cos ωt]V , (ω = 20Mrad s ) voltage is connected to the input of a transmission line of h = 10m length. The wawe parameters of the line and the impedance of the loading two-pole connected to the output at ω angular frequency are: Z0 = (49, 5 - j2)Ω, γ = (0, 5 + j40)km-1, and Z2 = Z0. Find the voltage amplitude at the nearest point to the source where the voltage phase angle is 0! a) U = 100V b) U = 92, 4V c) U = 36, 8V d) U = 50V
Three branches having impedances of 3+j4 Ω, 16−j12 Ω, and−j4 Ω, respectively, are connected in parallel. What are the equivalent(a) admittance, (b) conductance, and (c) susceptance of the parallelconnection in millisiemens? (d) If the parallel branches are excited froma sinusoidal current source where i=8 cosωt A, what is the maximumamplitude of the current in the purely capacitive branch?
For the frequency-domain circuit , calculate: 1. a) the rms magnitude of Vo;2. b) the average power dissipated in the 9 Ω resistor;3. c) the percentage of the average power generated by the idealvoltage source that is delivered to the 9 Ω load resistor.
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the period of ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit? What is the rms value of the circuit current?
In the circuit below, find the value of the load impedance ZL, which must be connected to the output of the circuit for MAXIMUM POWER TRANSFER. If this load impedance you found is connected, the amplitude of the current that will pass through the circuit, the phase angle and the angular frequency of the circuit are given in which option correctly. AB=61 AB=16 Answers I need: current= ?? angular frequency = ?? phase angle = ??