If the object has a mass of 1135 g and the volume of the water displaced is 250 cc, what is the object made of?materialdensity (g/cc)Aluminum2.70Titanium4.54Nickel8.90Copper8.96Steel7.87Ausenitic stainless steel 7.8-8.0Ferric stainless steel7.7-7.8Martensitic stainless steel 7.9-8.1O SteelO NickelO TitaniumO Aluminum

The volume of the object is same as the volume of the displaced water, so the expression for the…

If the object has a mass of 1135 g and the volume of the water displaced is 250 cc, what is the object made of? density (g/cc) 2.70 material Aluminum Titanium 4.54 Nickel 8.90 Copper Steel 8.96 7.87 Ausenitic stainless steel 7.8-8.0 Ferric stainless steel 7.7-7.8 Martensitic stainless steel 7.9-8.1 O Steel O Nickel O Titanium O Aluminum

If the object has a mass of 1135 g and the volume of the water displaced is 250 cc, what is the object made of? density (g/cc) 2.70 material Aluminum Titanium 4.54 Nickel 8.90 Copper Steel 8.96 7.87 Ausenitic stainless steel 7.8-8.0 Ferric stainless steel 7.7-7.8 Martensitic stainless steel 7.9-8.1 O Steel O Nickel O Titanium O Aluminum

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter4: Physics Of Matter

Section: Chapter Questions

Problem 9C

See similar textbooks

Similar questions

A twin-sized air mattress used for camping has dimensions of 100 cm by 200 cm by 15 cm when blown up. The weight of the mattress is 2 kg. How heavy a person could the air mattress hold if it is placed in freshwater?
At what flow rate might turbulence begin to develop in a water main with a 0.200-m diameter? Assume a 20° C temperature.
What fluid is in the device shown in Figure 11.29 if the force is 3.16103 N and the length of the wire is 2.50 cm? Calculate the surface tension and find a likely match from Table 11.3. Figure 11.29 Sliding wire device used for measuring surface tension; the device exerts a force to reduce the film's surface area. The force needed to hold the wire in place is F=L=(2l) , since there are two liquid surfaces attached to the wire. This force remains nearly constant as the film is stretched, until the film approaches its breaking point.
. A certain part of an aircraft engine has a volume of 1.3 Ft3, (a) Find the weight of the piece when it is made of iron. (b) If the same piece is made of aluminum, what is its weight? Determine how much weight is saved by using aluminum instead of iron.
, Water flows straight down from an open faucet (Figure 4.55). The cross-sectional area of the faucet is 1.8 10-4 ma, and the speed of the water as it leaves me faucet is 0.85 m/s. Ignoring air resistance, find the cross-sectional area of the water stream at a point 0.10 m below the faucet opening.
What are two reasons why mercury rather than water is used in barometers?
A piece of unpainted porous wood barely floats in an open container partly filled with water. The container is then sealed and pressurized above atmospheric pies-sure. What happens to the wood? (a) It rises in the water, (b) It sinks lower in the water, (c) It remains at the same level.
The average human has a density of 945 kg/m3 after in haling and 1 020 kg/m3 after exhaling. (a) Without making any swimming movements, what percentage of the human body would be above the surface in the Dead Sea (a body of water with a density of about 1 230 kg/m3) in each of these cases? (b) Given that bone and muscle are denser than fat, what physical characteristics differentiate sinkers (those who tend to sink in water) from floaters (those who readily float)?
A fire hose has an inside diameter of 6.40 cm. Suppose such a hose carries a flow of 40.0 LIS starting at a gauge pressure of 1.62106 N/m2. The hose goes 10.0 m up a ladder to a nozzle having an inside diameter of 3.00 cm. Calculate the Reynolds numbers for flow in the fire hose and nozzle to show that the flow in each must be turbulent.
Spherical panicles of a protein of density 1.8 g/cm3 are shaken up in a solution of 20C water. The solution is allowed to stand for 1.0 h. If the depth of water in the tube is 5.0 cm, find the radius of the largest particles that remain in solution at the end of the hour.
You observe two helium balloons floating next to each other at the ends of strings secured to a table. The facing surfaces of the balloons are separated by 1-2 cm. You blow through the opening between the balloons. What happens to the balloons? (a) They move toward each other. (b) They move away from each other. (c) They are unaffected.
An ice cube whose edges measure 20.0 mm is floating in a glass of ice-cold water, and one of the ice cube's faces is parallel to the waters surface, (a) How far below the water surface is the bottom face of the block? (b) Ice-cold ethyl alcohol is gently poured onto the water surface to form a layer 5.00 mm thick above the water. The alcohol does not mix with the water. When the ice cube again attains hydrostatic equilibrium, what is the distance from the top of the water to the bottom face of the block? (c) Additional cold ethyl alcohol is poured onto the waters surface until the top surface of the alcohol coincides with the top surface of the ice cube (in hydrostatic equilibrium). How thick is the required layer of ethyl alcohol?