If the resultant force acting on the bracket is to be Fr= 800j N. Determine the magnitude and coordinate direction angles of F.30F 750 N

Write the force F in cartesian vector form. Write the force F1 in cartesian vector form.

Answered: If the resultant force acting on the…

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter1: Introduction And Vectors

Section: Chapter Questions

Problem 59P

See similar textbooks

Similar questions

If the resultant force acting on the bracket is to be directed along the positive x-axis, determine the magnitude of Force F.
If the resultant force acting on the bracket is to be directed along the positive x-axis, determine the direction of the force F. F1 = 400N F2 = 675N FR =933N θ two = 45° Direction of Force F = ____ °
Good day, can you please help me with this question. The magnitude of the resultant force acting on the bracket is to be 400 N. Determine the magnitudeof F1 if θ = 30°.
The resultant of three parallel loads is 300N acting at 7m to the right of A. Compute the magnitude and position (distance d from left support) of the unknown load F.
Determine the angle theta at which the tension in the thread is equal to zero? Please hand write notes.
A 30 kN horizontal force and 40 kN vertical force is directed 53 degrees wrt x axis to the upper right, at what angle (in degrees) will forces of the same magnitude be directed to the lower left to produce equilibrium?
Two forces are applied to an eye bolt fastened to a beam. Use the cosine rule and the sine rule to determine the magnitude and direction of their resultant force
In the figure below, the CG of the pole held by the pole vaulter is 2.04 m from the left hand, and the hands are 0.713 m apart. (Assume the vaulting pole has a mass of 2.52 kg.) Calculate the force (in N) exerted by his right hand. (Enter the magnitude.)
A ladder of length 3.00m and mass 25.00 kg leans against a smooth vertical wall so that the angle between the horizontal ground and the ladder is 52.50°. Find the magnitudes of the friction and the normal reaction forces that act on the ladder if it's in equilibrium
A trapeze artist, with swing, weighs 800 N; he is momentarily held to one side by his partner so that the swing ropes make an angle of 30.0° with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?
A bolt has a requirement of being tightened to 38Nm. You pull on the end of a 25cm wrench at an angle of 120 degrees.To the radial arm line. What is force of the pull needed?
A force of 500 nt is measured with a possible error of 1 nt. Its component in adirection 60◦ away from its line of action is required, where the angle is subject to an error of 0.5◦. What is (approximately) the largest possible error in the component?

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

SEE MORE TEXTBOOKS

If the resultant force acting on the bracket is to be Fr= 800j N . Determine the magnitude and coordinate direction angles of F. 45 30 V F = 750 N