IF three different servo motors are connected to the three different channels in TPM0. Which one from the following is correct? O It is possible to generate three different PWM signals with different frequencies to control the three motors. O It is possible to control the position of each motor individually. The configuration is wrong, and it is not possible to connect three servo motors to one TPM. It is not possible to control the position of each motor separately because they are connected to the same TMP. OOO

Q: IF three different servo motors are connected to the three different channels in TPMO. Which one…

A: It is not possible to control the position of each motor separately because they are connected to…

Q: Shareholder A=2 shares, Shareholder B=3 shares, Shareholder C=3 shares, D=2 shares TOTAL=10 There is…

A: It is defined as Input means to provide the program with some data to be used in the program and…

Q: Represent the contents of the five output frames for a synchronous TDM multiplexer that combines…

A: GIVEN DATA: TDM multiplexer with 5 sources and with second source as silent one Source 1 message:…

Q: Given two statements about satellite transponders. Identify which of the options are valid about…

A: identify the valid statements from the given two statements

Q: Which of the following combinational circuit is used for data transmission? a. Comparator O b. 7…

A: The question is on digital logic design. The answer is given in step 2.

Q: Q8/Chose the correct data input for 4-1 multiplexer that used to Design the switching network F* 10=…

A:

Q: If the answer is correct, it will get an upvote; otherwise, it will receive a downvote. Give at…

A: Synchronous TDM :Synchronous time-division multiplexing (STDM), every device which is present in…

Q: 1. Represent the contents of the five output frames for a synchronous TDM multiplexer that combines…

A: 1. Output frames with arbitrary input:-

Q: Given the situation described below, which of the following signal states are correct? [select all…

A: The 8284 that includes the clock generator like that is capable of third of the frequency of the…

Q: In this project, you are required to use MATLAB/Octave/SCILAB software to simulate BPSK modulation…

A: MATLAB is a high-performance language for technical computing. It integrates computation,…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: Given: F(A, B, C, D, E)=(0,1,3,5,8,9,12,15,17,21,24)

Q: Plot the following discrete-time signals over the range -10 sns 10: i. 6(n-31 ii. uln-31 ii. r(n-3)…

A: Matlab code: n = -10:10; unitStep = n>=0; y = (4.*(0.8.^(n)).*cos(0.2.*n.*pi)).*unitStep;…

Q: Q9) Write a VHDL code for a Two Traffic Light (A,B) controller. When the circuit is reset, the…

A: The VHL code for Two Traffic Light (A,B) controller is given below.

Q: How must the Uno be configured to create a traffic light(using three LEDs)? A. 1 pin must be…

A: Ans: The UNO must be configured to create a traffic light using three LEDs is: d) 3 pins must be…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: The required Answer is in Step 2

Q: The term that refers to the phase continues through the boundary of two signal elements is a. non…

A: There  аre  twо  imрlementаtiоns  оf  BFSK:  nоn-соherent  аnd  соherent.

Q: Which input port in the circuit of the Figure below is selected for input operation if the address…

A: answer is  option b   port1 is correct answer

Q: Show connections for two 74138 in order to use it as a 4 x 16 Demultiplexer. Vcc Vcc YO YO 15 Y1 14…

A: since you posted multiple questions, but as per our guidelines we are supposed to solve the first…

Q: Write a program in which the 8051 gets data from P0 and sends it to P1 continuously while incoming…

A: 8051 microcontroller : 8051 microcontroller is an 8-bit microcontroller created in 1981 by Intel…

Q: Which one of the following diagrams shows a Decoder with an Active-Low enable? Select one: Binary…

A: Which one of the following diagrams shows a Decoder with an Active-Low enable?

Q: Write a program using Arduino IDE to read the value of water level sensor connected to pin A0, then…

A: The basic structure of the Arduino programming language is fairly simple and runs in at least two…

Q: 171. When Amplitude Shift Keying (ASK) is implemented using only two levels then it is called a.…

A: Answer: c. Binary ASK

Q: Give out alteast 5 differences of synchronous TDM and statistical TDM

A: The Answer is

Q: consider the following circuit to answer the below questions. C FullAdder C 1 Sum F Which of the…

A: Let's understand step by step :   Full Adder : Full Adder is used to add 3 input values and produce…

Q: b- What is the SNR for the following signal? time 0 1 3 60 8 10 signal 0.1 0.12 1.1 1.12 1.3 0.91…

A:

Q: Show the contents of the six output frames for a synchronous TDM multiplexer that combines five…

A: Given: Show the contents of the six output frames for a synchronous TDM multiplexer that combines…

Q: Consider a circuit-switched network to connect ten telephones in a small area. The communication is…

A: About switching:

Q: Show using diagram the contents of the six output frames for a synchronous TDM multiplexer that…

A: Given:

Q: Which of the following is the canonical SOP for the truth table given below? A BCF o o 0 1 0 0 1 0 0…

A: Answer: SOP stands for SUM OF PRODUCTS form we will write the canonical SOP  form by taking the min…

Q: M-0 and C.-1, what is the output? 3) What are the proper mode-select input signals in ALU to obtain…

A: The answer given as below:

Q: Write a program using Arduino IDE to read the value of water level sensor connected to pin A0, then…

A: The program written using Arduino IDE is  int red = 2;int green = 3; void setup () {  pinMode (red,…

Q: A certain population of ALOHA users manages to generate 70 request/sec. If the time is slotted in…

A: Introduction :

Q: Which of the following problems is resolved by using inverted paging as opposed to normal paging?

A: Inverted Paging: In the inverted paging technique, there is only one page entry for each and every…

Q: QUESTION 3 What is the phase angle between the following two signals s1(t) = -25 sin(wt - 35°) s2(t)…

A: - We need to calculate the phase angle between the two signals given.   - The signals provided :-…

Q: The mode in which each station can send and receive data but not at the same time is called a. Half…

A: The mode in which each station can send and receive data but not at the same time is called a. Half…

Q: Observe the following diagram of Synchronous TDM. What is the drawback of using synchronous TDM? 5…

A: In Time division multiplexing all signals operate at the same frequency with different time. In this…

Q: consider the following circuit to answer the below questions. M Cot FullAdder C 1 Sum F • Which of…

A: M can be either 0 or 1 Given F is 0 and Cin is 1 If M is 0 F=x+y+Cin 0= x+0+1 So, x must be 1  If M…

Q: Write an 8051 asm program to send a welcome message "Warm Welcome" serially. Whenever the INT1 has a…

A: Solution:- To implement 8051 asm program for displaying the message , "Warm Welcome".   Note: I have…

Q: Build a 2-to-4 decoder with Enable and provide a picture or snapshot of the circuit here.  ii)…

A: Below i have given:

Q: One of these statements is false in terms of the I/O channels types: a.selector channel transfer…

A: Selector channel - Handles a number of devices but sends data from only one input or output device…

Q: Which are conditions that can cause a FF to go metastable? (Mark all that apply.) O a. When the…

A: Since you have asked multiple MCQ questions we will answer the first three. If you want any specific…

Q: How many characters per second can be transmitted over a 4800-baud line in each of the following…

A: An asynchronous transmission of data uses the start and stop bit convention to signal the beginning…

Q: How many characters per second can be transmitted over a 9600-baud line in each of the following…

A: Baud rate is the rate at which information is transferred over a communication channel. In the case…

Q: Question: 1 Write an AVR program that read the potentiometer voltage measurements as analog data…

A: Note : As per the policy we can only a question at a time. If you want the solution of the next…

Q: Plot the following discrete-time signals over the range -10 sns 10: i. 6[n-3] ii. u[n-3] iii. r[n-3]…

A: Requirements :- I HAD SOLVED 4 AS YOUR REQUIREMENT . Solution :- please see the matlab code below…

Q: Compute the capacity and input distribution attaining it for the discrete memoryless channel X → Y…

A: Capacity for the discrete memoryless channel is given below

Q: Time Division Multiplexing scheme is implemented in a channel. The multiplexer in TDM used eight…

A: output bit     1. 1kbps =1000bps 500kbps = 500000bps Frame rate=bps/time slot  = 500000/4 =125000…

Q: use line coding scheme so that it will able to send those bits. Sketch the following digital pulse…

A: Data as well as signals that represents data can either be digital or analog. Line coding is the…

Q: Draw the Full Duplex ASK diagram if the bandwidth is 18,000 Hz (500 to 18,500). Also find the…

A: For full duplex ASK the bandwidth for each direction is  BW=18500/2=9250 HZ The carrier frequency…

Q: Which MUX is created when five 4-line to 1-line MUXS are connected?

A: