Answered: If we replace the segment marked with…

If we replace the segment marked with an "S" in Figure above with a 100 uf capacitor, the total capacitance is approximately 82.5 ut. True O False

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 14RQ: A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow,...

See similar textbooks

Related questions

Q: In the circuit , the voltage across the 4 ohm resistor in volts is ___ The circuit is equivalent to...

Q: The closed-loop transfer function of a rocket launcher system is given by O(s) s³ +4s+2 R(s) s'+2s* ...

Q: For the Circuit shown below, tetal gain Gr) = 6o dB ; A = l6 , Bw= 5 KHZ; f=AMHZ %3D %3D %3D ; Ri= I...

A: For the amplifier circuit,GT=60dBA=105BW=5kHzRi=1MΩRo=70Ω

Q: Two alternators A and B delivers 100 and 150 A, respectively to a load. If these currents are out of...

A: Use pythagoras theorem to find current current drawn load.

Q: Region 1 (y 0) contains dielectric medium with e, = 6 to and uz = 2.75 Ho- Draw a figure which defi...

A: "According to the Company's policy, we will solve only the first part of the question since the seco...

Q: In an AC circuit, the load has a supply voltage of 240 cos(800πt + 60) volts and a current of 120cos...

Q: What is the Voltage per Phase? O 4340 Volts O 4430 Volts O 4530 Volts O 4360 Volts

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm? at temperature of 0°C...

A: (1) It is given that: L=15.6 mA=12 mm2=12×10-6 m2V=240 VI0=7.9 A (At 0°C)

Q: Three equal charges of +3C are arranged in a straight line in the sequence of Q1, Q2 and Q3. The dis...

A: This question belongs to electro magnetic field theory . It is about calculation of electric field a...

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: EQUIVALENT RESISTANCE Equivalent resistance is the sum of the resistance connected either in ser...

Q: Deep-sea exploration is a challenging task in a petroleum industry. High pressure, huge area and une...

Q: In an ideal pn junction with an ideality factor of 1 at T = 300 K, the magnitude of the reverse-bias...

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: In this question, What is type of the system? What is impedance? And value of X? What is rms curr...

Q: PROBLEM SOLVING: Solve for what is being asked given the circuit below. Show complete, neat and orde...

Q: Design an analog Butterworul

Q: 4. Refer to the graphics appendix. What is the voltage across R1? 200 V 400 V 92 V 120 V

Q: A current of 10 A and a power factor of 0.8 lagging is taken from a single phase 250 volt supply. Th...

Q: V3 A R1 R3 R5 10 V1 12 R2 R4 V2 20 Reference Node 12

A: The given circuit diagram is shown below:

Q: A What is the resulting expression of Y?

A: CMOS- Complementary metal oxide semiconductor. It is a semiconductor used in transistor to manufactu...

Q: 5. For the given circuit below, determine (a) the voltage across each capacitor and (b) the energy s...

A: Here, we have given an electrical circuit having, no. of capacitor connected in series and parallel ...

Q: Question 3 What are the main differences between a capacitor and an inductor? Discuss FIVE of them.

Q: The armature of a two-pole generator is rotating at 3600 r/min. The armature has a simplex lap windi...

A: Generated emf = ((flux× speed× no. Of armature conductors)/60)×(poles/ parallel paths).

Q: It is the ratio of the units of electricity generated per year to the capacity of the plant installe...

A: The ratio of the units of electricity generated per year to the capacity of the plant installed in t...

Q: An electric field of 3.6 x 10° N/C passes through an area of 4.1 cm? perpendicular to the surface. D...

Q: Which statement is wrong ? High load factor of a generating equipment Ogives more profit to owner le...

A: LOAD FACTOR :- The Load Factor is defined as a ratio of the average load ...

Q: You need to posters on the wall has O clean O put O

A: Given sentence, You need to _________ posters on the wall. Always use the first form of the verb a...

Q: Find the Output response (Impulse, Step, Ramp, Parabolic) for each of the systems below and time con...

A: "As per our guidelines, we are supposed to answer only first three subparts. Kindly repost the ...

Q: 7. Refer to the graphics appendix. What is the total resistance of the circuit? 1500 Ohms 400 Ohms 3...

Q: The following vectors are given: M=-10ax+4ay-8az and N=8ax+7ay-2az. Find the unit vector in the dire...

Q: 2. Refer to the graphics appendix. What current is most near the current through R2? .200 A .046 A ....

Q: (t) is defined by the convolution g(t) = 5II(t/2) * [8(t +1) + 8(t)] ere II(t) and d(t) are the unit...

Q: V3 12 4 8. A В R1 R3 R5 10 V1 12 R2 6. R4 8. V2 Reference Node 20

A: The given circuit diagram is shown below:

Q: 6. Given the following resistance R, = 100, R2 = 50, and R, = 50, and voltage V; = 20V and V, = 12V,...

Q: C Vi O 20 V Ideal R 5 V -20 V

Q: short hollow, cast iron cylinder with wall thickness o 0 mm is to carry compressive load of 100 kN o...

A: Given that P=100kN=105Nσ=80N/mm2=80×106N/m2t=10mm=.01m

Q: The following vectors are given : M=-10ax+4ay-8az and N=8ax+7ay-2az. Find the magnitude of 5ax+N-3M

Q: T (s) = s+2 s2+9

A: "As per our guidelines, we are supposed to answer only three subparts. Kindly repost the other subpa...

Q: resistance wire

A: Resistance- The opposition caused by the body to the flow of current is termed as it's resistance.

Q: In a series RC circuit, the voltage across the capacitor and the resistor are 60 and 80 volt respect...

A: Let us take current (I) as reference phasor. The voltage across the resistor(vR) is in phase with th...

Q: A resistance of 100 and a capacitance of 100 µF is connected in series to the parallel combination o...

Q: What are the main differences between a capacitor and an inductor? Discuss FIVE of them.

A: The inductor is a coil which stores energy in the magnetic field and the capacitor is an element tha...

Q: What is the value of Kd

A: This question belongs to electrical machine. It is based on calculation of distribution winding fact...

Q: Determine the output (M) for the J-K flip-flop and the inputs shown in Figure 3. [Tentukan output (M...

Q: What will happen if you increase VDD after constant current area region?

A: CONSTANT CURRENT SOURCE Constant current source is a power device source which provides a constant ...

Q: How many different 3-bit binary state encodings are possible in a controller with 4 states? How many...

Q: Question # 03: Apply the knowledge gained from the DC biasing of E-MOSFET to select appropriate valu...

A: Here, we have given a circuit, for which we have to determine the values of VDD and RD. We will cons...

Q: Q5/ Using Kirchhoff Laws for the circuit below determine the value and the direction of the current ...

A: Kirchhoff's Law Kirchhoff's Current LawSum of entering current = Sum of Leaving current Kirchhoff's ...

Q: 3. Draw the circuit for the following output. Show your complete analysis. ", - +E

A: The solution is given below

Q: Question 1 R1 R2 What is the equivalent resistance of the circuit shown above if R1 = 9.0 Q and R2 =...

A: Given circuit, Where, R1=9 ΩR2=6 Ω

Q: A singer voice is sampled for 8 second by an 8-bit ADC at a sampling frequency of 20 kHz. The sample...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

ESmnmetn t
OFF
ON
S
470uf
AK
If we replace the segment marked with an "S" in Figure above with a 100 uf capacitor, the total capacitance is approximately 82.5 ut.
True
False
all answers.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841