Question
If we want to have a Q+ state of 0, which of the following input
combinations would work for a DFF with active high SR?
A) S-0, R-0, Clk LE, D-1
L. B) S=0, R=1, Clk-LE, D-O
C) S-0, R-0, Clk TE, D-0
D) S-1, R-0, Clk-TE, D-1
Expand
Transcribed Image Text

If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF with active high SR? A) S-0, R-0, Clk LE, D-1 L. B) S=0, R=1, Clk-LE, D-O C) S-0, R-0, Clk TE, D-0 D) S-1, R-0, Clk-TE, D-1

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

Q: 8- In the following circuit find i() 2Ω 0

A: From the circuit, write the expression for io(t) as follows:

Q: 1. Assuming ideal diode models, find status of diodes D1 and D2 (on or off) D2 Di +12 29

A: In ideal case, all forward biased diodes are in on state, and all reverse biased diodes are in off s...

Q: The figure attached to this question shows the 1 line diagram of a simple three bus power system wit...

A: Convert the line impedances into admittances, using Y=1/Z 

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

Q: In the following circuit, use two different methods (Nodal Analysis, Mesh Analysis, or using Theveni...

A: Let us find the Nortons's Current (Isc) :

Q: 2. Assuming ideal diode models, find status of diodes Di and D2 (on or off) D2 + 15V 10% +

A: First, assume both diodes are on,

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

Q: A 3-phase line 3 km long delivers 3000 kW at a p.f. 0·8 lagging to a load. The resistance and reacta...

A: Click to see the answer

Q: 12- Find i(t) and v(t) in the following circuit. You may employ any method you wish. 24"φ

A: When t < 0, the inductor acts as a short circuit.So, at time t=0, we will get :

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...

Q: Find i(t) and v(t) for t >0 in the circuit in the figure attached.

A: Write the general expression for unit step function,

Q: A single phase transmission line has two parallel conductors 1·5 metres apart, the diameter of each ...

A: Given,The spacing between the two parallel conductors is,

Q: Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diamet...

A: The capacitance of each conductor to neutral per 100 km of the line should be calculated as: -

Q: Q1: a) Discuss the effect of earth on the capacitance of a line : b) Derive in expression for the ca...

A: (a) The earth can be considered as a conducting infinite equipotential plane. The electric flux line...

Q: 10- Find i, (t) in the following circuit. You may employ any method you wish. 12 V(+ за

A: The general expression to find the complete response of voltage for the RC circuit.

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: please help with question 45. thank you

A: The values of Z0, Z1, Z2 and Z3 as a function of A, B, C and D should be obtained by the following s...

Q: SO dependent youpe sunce Tx o.S 22V 54

A: Consider the Two nodes V1 and V2 as shown;

Q: 4. Find the current I assuming ideal diod es 1.2k2 10V (+ 15%4 12V+ 3V

A: The given is redrawn as shown in Figure 1.

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.18

A: (a). Numerator part of the gain:b(s) = b1sn-1 + b2sn-2 + …………+ bn…………………… (1)Denominator part of the...

Q: At which times will Q be high? clk A) T1, T2, T3, T4 B) T2, T5 C)ll times C) D) T1 , T3, T4 Ti T23T4...

A: 1) JK flip flop truth table is given as:JKQ+00Q(no change)01010111Q’

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: Q3. By using the method of images, prove that the capacitance between conductor and earth, taking in...

A: From the diagram shown below, we can say that:

Q: 2 A 8Ω 4Ω 12 V 6Ω 6Ω HI- Figure 3.46 For Review Questions 3.1 and 3.2. 3.2 In the circuit of Fig. 3....

A: The purely resistive circuit provided in the question can be solved by applying Kirchoff's Voltage L...

Q: Ql: a) A set of reading obtained in an experiment is 49.7. 50.1, 50.2, 49.6, 49.7 determined: 1- Ari...

A: As this question has many sub parts, so I will be answering the first five sub-parts of Q1. a.   In ...

Q: 3.31 Find the node voltages for the circuit in Fig. 3.80. C, ML 1S2 4lo 2v V1 V2 11o 4 92 4Ω 1S2 ÷) ...

A: Nodal analysis primarily depends on the application of Kirchoff\'s Current Law (KCL) to various esse...

Q: The ABCD constants of a three-phase, 345-kV transmission line are:A = D = 0.98182 + j0.0012447.B = 4...

A: Since, the given ABCD parameters for the 345 kV transmission lines are:A = D = 0.98182 + j0.0012447B...

Q: Attempt five questions only Q1.) a) Derive the basic S.I units, then write the basic dimensions for ...

A: Hii there!! Since there are two different questions in the image, I will be solving the first one. I...

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: Show that the system shown in the figure below oscillates at a frequency of 1 rad/sec.

A: This is a unity negative feedback system. For this system to oscillate at some frequency, we need tw...

Q: Can someone help me with question 2 please? Derive  Vout(t) expression for the circuit in figure 1 a...

A: Part (A) (For circuit in Figure 1):Notice that, the value of resistance and input frequency are chan...

Q: uunection current 0.5mA is to be used. 02: a) Derive the equations of balance for Hay bridge to dete...

A: Hay bridge is a modified version of Maxwell\'s bridge and the circuit diagram is given below 

Q: What is the time constant for a 47 H inductor in series with a 470 Ω resistor? Part 1. (a) What is ...

A: Given Data: The value of inductor (L) is 47 H.The value of resistance of a resistor (R) is 470 ohms....

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: please help me with the question 8M

A: We can start with the truth table for input. The ASCII code corresponding to each letter from A to J...

Q: Done 2 of 6 answer. You are allowed a simple calculato Answer: A Problem: Find Io in the following c...

A: The circuit Diagram is shown on the board:At node B, the two 6Ω resistors connected are in parallel ...

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: Find in e rut 3 2 12A T.F

A: Since, the given circuit diagram is as shown in the figure 1:

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: A (medium) single phase transmission line 100 km long has the following constants: Resistance/km/pha...

A: As per the norms, we answer three parts of a question. Since your question contains four parts, we s...

Q: 3.45 Find current i in the circuit of Fig. 3.91. ML 492 8 92 4 A 2Ω 6Ω ts 30 V (+ ΙΩ Figure 3.91

A: There is a current source in the given circuit. So , we are applying nodal analysis.

Q: At t=1ms is the i=12(a estimated number)/1=12A or is it i=30/2=15A.

A: From the definition of current i(t), it can be expressed as the time derivative of charge q(t). The ...

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.