If you do not heat your crucible strongly enough to remove all volatile impurities when you heat thecrucible empty, what will be the result if those impurities are completely volatilized when heatingyour sample?O your sample will weigh more than it is supposed to after heating , causing the mass of water to be less thanit is supposed to beO your sample will weigh less than it is supposed to after heating, causing the mass of water to be higher thanit is supposed to beO the loss of water happening during the initial heating or during the second heating isn't relevant

The loss of water happening during the inital heating or during the second heating is not relevant

If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the crucible empty, what will be the result if those impurities are completely volatilized when heating your sample?

If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the crucible empty, what will be the result if those impurities are completely volatilized when heating your sample?

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter11: Intermolecular Forces And Liquids

Section: Chapter Questions

Problem 41IL

See similar textbooks

Related questions

Q: How will you demonstrate the purity of your final product (crude or recrystallized)?

A: To demonstrate the purity of the final product

Q: Which would affect the accuracy of a melting point determination? Using a thermometer that has not…

A: Melting point is the temperature at which solid converts into liquid.

Q: Will the molecular weight of the sample be more or less than the correct molecular weight if the…

Q: 7. After completing Part 1 of the experiment, you take the melting point of your recovered benzoic…

A: Melting point represents the span of the temperature at which the crystals or the sample first start…

Q: When checking the melting point of your impure sample, what temperature should you set as the…

A: In the event that the inexact temperature at which your sample should melt is known, the sample can…

Q: In the preparation of acetylsalicyclic acid, the crude crystals can be recrystallized with an…

A: Our correct answer is True.

Q: What is each cycle of a simple distillation called? Theoretical plate Distillate…

A: Simple distillation is process of separation.

Q: Give some reasons that would lead you to purify a liquid by using vacuum distillation rather than by…

A: Distillation under reduced pressure is called vacuum distillation and is generally employed for…

Q: If the melting point range obtained from the unknown sample is 121-122 degrees Celsius, can we say…

A: Please find your solution below : Melting point of a substance is defined as a temperature at which…

Q: What is the effect of weighing a recrystallized organic solid which is not completely dried to the…

A: Percentage yield is calculated by dividing actual yield to theoretical yield and multiplying it by…

Q: Write the dispersion medium and dispersed phase in milk.

A: Phase of solution in which colloidal particles are present termed as dispersed phase. The phase in…

Q: Why is recrystallization not applicable to samples which contain large amount of impurities?

Q: i) What two criteria should you ensure about your melting point sample before you fill the melting…

A: Since you have posted multiple questions, but we will solve first question for you. For remaining…

Q: Add an excess of methanol to 8.0g of benzoic acid followed by a few drops of concentrated sulfuric…

A: Benzoic acid on reaction with methanol in presence of catalytic amount of H+ produces methyl…

Q: What is an effective way of preventing irregular ebullition or bumping of the mixture during…

A: The question is based on the concept of experimental chemistry. we have to suggest an effective way…

Q: 3.Why is it dangerous to perform distillation on a closed (airtight) system?

A: The process distillation involves the conversion of a liquid into vapour that is subsequently…

Q: You measured the melting point of the recrystallized product Ttal=142,2-145,5°C. Based on this…

A: Given that, Melting point of recrystallized product = 142.2℃ to 145.5℃ .

Q: If you did not completely dry the Erlenmeyer flask before weighing the result, how would that affect…

A: Given : You did not completely dry the Erlenmeyer flask before weighing the result.

Q: When you prepare your sample to run through the column chromatography , what is the first proper…

A: For the column chromatography the sample should be properly dissolved in an appropriate solvent

Q: Is the separation 100% complete after evaporation process? Explain.

A: Evaporation is a process by which a compound changes its phase from liquid state to gaseous state…

Q: What are the criteria for a good recrystallization solvent?

A: Recrystallization refers to the phenomenon where solid compounds are purified. In the…

Q: Why do you have to keep all the equipment hot when removing carbon in recrystallization?

A: Recrystallization is technique used to purify solid compounds.

Q: The density of the first fraction collected would be expected to be close to a value of ______.…

Q: Q2. What does “crude” product mean? Q3. What is the advantage of using Buchner filtration in…

A: “Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: You have completed your recrystallization process, but you did not get any crystals back after you…

A: Recrystallization is a process which is used to purify the compounds. The principle behind…

Q: A student recrystallized some impure benzoic acid and isolated it by filtration. He scraped the…

A: Re-crystallization is the most commonly used technique for purifying a solid compound. In the…

Q: The reagent that is used in the preparation the sample and does not contain the analyte is called

A: The reagent blank is a solution that contains all the same components as in sample solution but no…

Q: What effect would the incomplete drying of a sample (e.g., the incomplete removal of a…

A: The melting point will be lowered and broadened.

Q: What is the effect of an insoluble impurity, such as charcoal, on the observed melting point of a…

Q: 1. Did the sugar dissolve faster in the hot water or the cold water? 2. What would be another…

A: Sugar dissolves faster in hot water than in cold water. Because hot water has more energy. When…

Q: In a simple or fraction distillation, When would you prefer to use an air cooled condenser with no…

Q: Use an apparatus similar to that shown and assume that the round-bottom flask holds 10 mL and that…

A: Given information: Volume of holdup = 12ml Pressure = 760 mmHg = 1 atm Boiling point = 100°C =…

Q: Outline three differences in the experimental set up between fractional distillation and steam…

A: Steam and Fractional distillation have different their principal and boiling point

Q: While determining the pressure during the Dumas experiment, if the barometric pressure reported were…

A: Given: The barometric pressure reported was lower than the actual vapour pressure in the Dumas…

Q: What parameters should be considered when choosing between distillation methods? Are there any…

A: Distillation is refining method of refining by alternating evaporation and condensation to remove…

Q: Describe the errors which may cause an observed melting point range of a PURE sample to be: higher…

A: Ans 1) If you used very large a sample size and Using uncalibrated thermometer . Packing a…

Q: Recrystallization and Melting Points Why do you need to heat a sample slowly when taking a melting…

A: Interpretation: We need to tell why we heat sample slowly during determination of melting point.

Q: Cite one factor that affects percent yield during recrystalization.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What do you notice about the compounds under the melting point column that have negative values?

A: We are given the melting and boiling point of different compounds in the table.

Q: What is the aim of (solids:recrystallization and melting points) experiment?

A: What is the aim of (solids:recrystallization and melting points) experiment?

Q: While performing a crystallization, you obtain a light tan solution after dissolving your crude…

A: It is observed that a light tan solution is obtained and because of this, it is better to filter it…

Q: What is different about steam distillation

Q: what is the purpose of steam distillation? and what are the factors involved ?

A: Steam distillation is a separation process which purifies isolate temperature-sensitive materials,…

Q: 5. For the same solid compound as the question above, if the 1 mm sample was heated at 60° per…

A: (4) Heating rate = Temperature/time Heating rate = 200 oC/1 oC/min Heating rate = 200 min (5) 1 mm…

Q: What might happen to your melting points if you do not cool the MelTemp between runs? The melting…

A: The temperature at which the solid becomes liquid is called melting point. Melting point is a…

Q: 2) determine the identity of an unknown solid. Briefly explain why the experimental technique of…

A: The Temperature at which the solid state compound transform into liquid state without changing its…

Q: 1. Pure compounds have higher (and sharper) melting points than compounds that contain impurities.…

A: Melting point depends on the intermolecular forces of attraction to a greater extent. Pure crystal…

Q: Filter paper is usually a poor material on which to powder a solid sample before introducing it…

A: Filter paper is not used as material on which substance can be powdered before its addition into…

Q: 1. Why does the solid need to be finely ground and then tightly packed in a melting point capillary…

A: The temperature at which the solid melts and starts converting into liquid is called as melting…

Q: Describe the procedure of how to collect and dry your newly recrystallized compound.

A: Recrystallization is the method that is used to purify the organic compounds. It involves the…

Question

If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the
crucible empty, what will be the result if those impurities are completely volatilized when heating
your sample?
O your sample will weigh more than it is supposed to after heating , causing the mass of water to be less than
it is supposed to be
O your sample will weigh less than it is supposed to after heating, causing the mass of water to be higher than
it is supposed to be
O the loss of water happening during the initial heating or during the second heating isn't relevant

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Cloth can be waterproofed by coating it with a silicone layer. This is done by exposing the cloth to (CH3)2SiCl2 vapor. The silicon compound reacts with OH groups on the doth to form a waterproofing film (density = 1.0 g/cm3) of [(CH3)2SiO]n, where n is a large integer number. n (CH3)2SiCl2 + 2n OH 2n Cl + n H2O + [(CH3)2SiO]n The coating is added layer by layer, with each layer of [(CH3)2SiO]n being 0.60 nm thick. Suppose you want to waterproof a piece of doth that is 3.00 square meters, and you want 250 layers of waterproofing compound on the cloth. What mass of (CH3)2SiCl2 do you need?
Suppose that you are closing a cabin in the north woods for the winter and you do not want the water in the toilet tank to freeze. You know that the temperature might get as low as 30. C, and you want to protect about 4.0 L water in the toilet tank from freezing. Calculate the volume of ethylene glycol (density = 1.113 g/mL; molar mass = 62.1 g/mol) you should add to the 4.0 L water.
If one needs to cleanly separate two compounds with boiling points at 154°C, and 167°C at one atmosphere, how many plates will be required for the collection of the pure compounds, assuming ≥ 95 mol% purity? A. 15 B. 7 C. 50 D. 30
General formula of a polymer is-(CH2CHCHCN)n-, where n is typically greater than 10,000. Then take a sample of this polymer weighs 755.9 g and contains 3.112 x 1020 molecules of -(CH2CHCHCN)n-, so calculate n?
Can paper chromatographt be used to separate and identify very volatile substances? Explain.
20 cm3 of a gaseous hydrocarbon required 90 cm3 of oxygen for complete combustion. Both volumes were measured under the same conditions.The hydrocarbon must be?
State the effects that cause bulk and nanoscale materials to have different magnetic properties.
1. Why should solid NaOH be weighed on a watch glass and not on a paper?
what is the correct sig figs?
1. Which of the following is not a step in preparing a water sample container?a. All sample containers must be dark in colorb. The type of sample container and the level of cleaning required depend on the type of sample to be takenc. All sample containers must be thoroughly cleaned in the laboratory before sampling is carried outd. The number of containers prepared must always be in excess of what is needed, for quality assurance, quality control and reserves 2. The purpose of environmental sample analysis is..a. To determine the origin and concentration of chemicals in the environmentb. To determine the origin, concentration of chemicals and/or pollutants in the environmentc. To determine the concentration of a chemical in the environmentd. To determine the cause and concentration of pollutants in the environment
Explain the following briefly a.) Why is ‘‘distillation’’ a purifying technique? Cite evidences
It is a type of mixture with particles evenly scattered in a dispersed medium without settling down