If you started your measurements just as the ribbon was cut, then x = xo+vzot+at² will simplify to x = axt² you already found that x = 0 m and t = 0 s. Use these values to solve for the acceleration.

If you started your measurements just as the ribbon was cut, then x = xo+vzot+at² will simplify to x = axt² you already found that x = 0 m and t = 0 s. Use these values to solve for the acceleration.

An Introduction to Physical Science

14th Edition

ISBN:9781305079137

Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Publisher:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Chapter9: Atomic Physics

Section: Chapter Questions

Problem 1VC: Visualize the connection for the descriptions of motions in the sections and give answers in the...

See similar textbooks

Related questions

Q: During the Vietnam war. A canon ball is fired directly upward with a velocity of 75 m/s, followed by…

Q: The record for the deepest free-dive (diving without an oxygen tank) is 253 m. What is the absolute…

Q: A pendulum of length 1.8m with mass 2.5kg attached to its end oscillates with a period of 9.0s. What…

Q: A tricycle moving at 150 m/s must come to a stop in a distance of 250 meters to avoid hitting a big…

Q: Two springs, with force constants k, and key, are connected in series, as shown in the figure…

Q: (a 3') Sketch magnetic field lines inside and outse in the following horse-shoe magnet. You must…

Q: Suppose you stand on a bathroom scale and get a reading of 700 N. In principle, would the scale read…

A: In the following problem: reading of bathroom scale is 700 N, and we have to figure out the new…

Q: 8. A converging lens (f1 = 12.0 cm) is located 27.3 cm to the left of a diverging lens (f₂ placed…

A: Write the lens equation for the converging lens and substitute the required values. 1f1=1v1+1u1112…

Q: A 200lb log floats in water such that it is half submerged and at rest. What is the magnitude of the…

A: a) Since the object is floating. The net force on the object must be zero. Hence the buoyant force…

Q: A galvanometer coil has a meter shows full scale deflection for a current c 4 mA. How will you…

A: An ammeter is used to measure an electric current. Here, we calculate the given as follow;

Q: The inner core of the Earth is solid. The liquid outer core is at a cooler temperature and yet is…

A: The melting point of iron increases with increase in pressure. So increased pressure in the inner…

Q: Find the velocity and acceleration vectors in terms of u, and up. r=2 cost and 0 = 9t V= -2 sin t)4)…

Q: calculate the electric field from thin ring of radius & and charge Q Baut P (as shown) Find a

Q: 10. The closest distance a book can be read from a pair of reading eyeglasses (Power = 1.82 dp) is…

A: Given data: The lens power P=1.82 dp The distance between book to eye is d=25+3=28 cm=0.28 m

Q: Two cylinders are completely filled with water. Both cylinders have the same height, but the base of…

Q: Consider two pendulums, Pendulum 1 with length L and Pendulum 2 with length 2L. How does the period…

A: Solution:- 1) The time period of oscillation of a simple pendulum is given by T = 2π(L/g)1/2 Here,…

Q: A mass of 308 g was hung from the string and three different harmonics were generated in the string.…

Q: (4₁) you need to construct a 180 pF capacitor for a science project. you plan to cut two L XL metal…

Q: please explain also. Which is correct if a diver curls up on diving to do flips at the top, then…

A: As there is no external torques on the diver during the motion (the force of gravity acts on the…

Q: What is the rms current in the circuit?

Q: When a 9.09-kg mass is placed on top of a vertical spring, the spring compresses 4.18 cm. Find the…

A: We have, mg = kx therefore, k = mg/x k = (9.09x9.8)/(0.0418) k = 2131 N/m

Q: The wave number of the incident radiation in Raman spectrometer is 20623 cm-1. What is the…

Q: toy rocket is launched from the top of a building 71 feet tall at an initial velocity of 223 feet…

Q: Can this equation be used to find the same solution to the question?

A: Yes , this equation will be used to solve the given problem. For your simplicity--- Mass , m = 1.3…

Q: What is the voltage amplitude across the capacitor?

A: Voltage across capacitor= current× reactance of capacitor

Q: In your own word, discuss the interrelationship of heat, temperature, and energy in relation to…

Q: A force is applied to a circular surface with area 70 cm². The surface is parallel to the x-y plane.…

Q: How fast can the 155 A current through a 0.160 H inductor be shut off if the induced emf cannot…

A: For the inductor we have V=LdIdt=L∆I∆t⇒∆t=LV∆I

Q: A small coin is placed on a flat, horizontal turntable. The turntable rotates at a constant rate of…

A: Given, RPM of the turn table, 45 RPM Time is taken for making three rotations, t=4 s Distance by…

Q: Three pucks with masses mA = 25.0 [g], mB = 50.0 [g], and mc = 75.0 [g] approach the origin as they…

Q: A 3000-kg satellite orbits the Earth in a circular orbit 11797 km above the Earth's surface (Earth…

Q: yours claim would knock the What do *you* think of this? Would it be possible? Yes, all those people…

A: Nothing. Population of china is 1.357 billion roughly. Average man weight about 50kg. Let's say a…

Q: A ceiling fan with 100.0 cm diameter blades is turning at 55.0 rpm. Suppose the fan coasts to a stop…

Q: The average bulk resistivity of the human body (apart from surface resistance of the skin) is about…

Q: The greatest ocean depths on the Earth are found in the Marianas Trench near the Philippines, where…

Q: The piano suspended in air is being lowered by ropes from an upper floor of a building to a truck…

A: T1 = 1830 N T2 = 1295 N ∆y = 5 m , in downwards direction FG = 2500 N

Q: Find the quantity of heat needed to change a 1.0-g ice cube at absolute zero (-273° C) to 1.0 g of…

A: A) Write the expression for the heat needed to change the ice to boiling water and substitute the…

Q: Carts A and B in Figure 1 have 5 kg and 10 kg masses, respectively. A force of F = 50 N is applied…

A: Given data: Mass of object A (mA) = 5 kg Mass of object B (mB) = 10 kg Force (F) = 50 N Required:…

Q: For the circuit shown in the figure below, calculate the following quantities. (Assume = 7.50 V and…

A: The above picture can be redrawn.

Q: A vector has a bearing of 56.1° and a magnitude of 729.6. A second vector has a bearing of 315.2°…

Q: Thabo standing at makanye robots hears a frequency of 560 Hz from the siren of an approaching…

Q: What defines the center of gravity of a rigid body, and how is it related to the center of mass?

A: Centre of gravity of a system is that point on which entire weight of the body or system can be…

Q: nair= 1.00 0₁ 0₁ Upper plastic-air boundary 021 nplastic In the picture above, a light ray travels…

Q: An ordinary drinking glass is filled to the brim with 350 mL of water at 100.0 °C. If the…

Q: - A galvanometer coil has a resistance of 15 22 and the deflection for a current o meter shows full…

Q: What is the speed of the block immediately before it goes up the incline? How far, in [cm], along…

Q: An elevator has mass 640 kg, not including passengers. The elevator is designed to ascend, at…

Q: The figure below shows the velocity-versus-time graph before and after the collision of two carts on…

Q: A fire hose ejects a stream of water at an angle of 35° above the horizontal with a speed of 25 m/s.…

A: Given data: Initial velocity (u) = 25 m/s Angle (θ) = 35°, above the horizontal Required: The…

Q: Find the linear speed of the bottom of a test tube in a centrifuge if the centripetal acceleration…

A: Given : Centripetal acceleration= 52000 times the acceleration due to gravity Distance = 7.5 cm =…

Question

If you started your measurements just as the ribbon was cut, then x = xo+vzot+at² will simplify to
x = axt² you already found that x = 0 m and t = 0 s. Use these values to solve for the acceleration.
ready to conduct your in

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A car takes 5.0 s to go from v=0 m/s to v=24 m/s at constant acceleration. If you wish to find the disance traveled using the equation d=1/2at squared, what value should you use for a? Express your answer to two significant figures and includ the appropraite units.
This cannot be hand-written, please type out the solution Use the average time to drop and calculate the distance dropped using the equation given. Then compare this distance to the measured distance. Use Y = 1/2 g t^2, Thus Y= 4.9 t^2 See my attempt attached with the data - teacher indicated my work needed correction, please help Thank you!
Please solve 9c and 9d. Please solve 10 too The acceleration was -1.57 m/s^2.
Hi I am in phyiscs I and it has the problem a runner ran the marathon (approx. 26.1) in 2 hours and 57 min. What was the average speed of the runner in m/s? I understand that I would have to divide the total distance by the total time, but I'm not sure how they changed the miles to meters. Please break it down so I can understand. I tried to solve it how you guys did it but I keep getting another answer. Thank you!
Pp# 2: can you help me solve and understand this practice problem please? A step by step explanation from a-d would be appreciated. Thank you!
Hi I am in phyiscs I and it has the problem a runner ran the marathon (approx. 26.1) in 2 hours and 57 min. What was the average speed of the runner in m/s? I understand that I would have to divide the total distance by the total time, but I'm not sure how they changed the miles to meters. Please detalied steps of how to solve this so I can understand it. Thank you!
The displacement (in meters) of an object moving in a straight line is given by s=2/t where t is measured in seconds. Find the average velocity over the time interval [1,3]. Find the instantaneous rate velocity when t=1. Note: Do not use rules of differentiation.
A particle moves according to a law of motion s = f(t), t ≥ 0, where t is measured in seconds and s in feet. (If an answer does not exist, enter DNE.) f(t) = t3 − 9t2 + 24t 1) Draw a diagram to illustrate the motion of the particle and use it to find the total distance (in ft) traveled during the first 6 seconds. 2) Find the acceleration (in ft/s2) at time t and after 1 second. 3) When is the particle speeding up and slowing down? (Enter your answer using interval notation.)
A ball is thrown into the air by a baby alien on a planet in the system of Alpha Centauri with a velocity of 26 ft/s. Its height in feet after t seconds is given by y=26t−13t^2A. Find the average velocity for the time period beginning when t=1 and lasting .01 s: .005 s: .002 s: .001 s: NOTE: For the above answers, you may have to enter 6 or 7 significant digits if you are using a calculator.Estimate the instanteneous velocity when t=1.
the motion of the particle is described by the equation x(t)=at^3-bt^2. where a is 3.36 in m/s^3 and b is 2.84 in m/s^2. find the instantaneous velocity in m/s of the particle from time t 5.93s. Express your answer rounded off to two decimal places. Do not include the unit.
A bullet is fired vertically upward in a controlled test environment. Its distance S (in ft) above the ground is given by S=2100t−19.2t2 , where t is the time (in s). Find the acceleration of the bullet. (type integer or a decimal.)
A particle moves accordingly to a law of motion s = f(t) = t^2 e^−t, t ≥ 0, where t is measured in seconds and s in feet. a. When is the particle speeding up? b. When is the particle slowing down? Please write clearly and legibly