(II) A close inspection of an electric circuit reveals thata 480Ω resistor was inadvertently soldered in the placewhere a 350Ω resistor is needed. How can this be fixedwithout removing anything from the existing circuit?

(II) A close inspection of an electric circuit reveals thata 480Ω resistor was inadvertently soldered in the placewhere a 350Ω resistor is needed. How can this be fixedwithout removing anything from the existing circuit?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 3CQ: When working with high-power electric circuits, it is advised that whenever possible, you work...

See similar textbooks

Related questions

Q: نقطة واحدة the fig. below is a second * .order circuit t=0 VR R Vin = E( Vc

Q: 13-15. For the circuit below, i, = 1.4 A. Calculate ix and the total power dissipated by the…

A: io = 1.4 ALet, Ro = 16 Ω, R1 = 8 Ω, R2 = 4 Ω, and R3 = 2 Ω

Q: In the given circuit, R = 4 kQ, R2 = 3 kO, R3 = 8 kN, and R4 = 8 kQ. Find Reg- R, R, R3 ww R4 kQ.…

Q: as n che ngài R- (a) Find the time constant of the circuit. S (b) Find the maximum charge on the…

Q: 10.0 N 20.0 N ww- 60.0 N -ww- 60.0 N 2.00 A 30.0 0 ww 5.0 Ω -5.0 V 10.0 V 15.0 N E 5.00 w - ww 20.0…

Q: Does more current flow out of a battery than into it? Does more current flow into a lightbulb than…

A: Current flows through electrical equipment, such as water flowing through the plumbing circuit of a…

Q: which one of the followings are true in a electric circut 1-ampermeter has a huge inner resistence…

Q: When working with high-power electric circuits, it is advised that whenever possible, you work…

Q: An initially uncharged capacitor is connected as shown. If the switch is closed at t-0, the time it…

Q: When the switch shown in Fig. 19–45 is closed, what willhappen to the voltage across resistor R1 It…

A: When switch is closed, R2 connect parallel in the circuit. Hence, equivalent resistance of the…

Q: (II) The capacitance of a portion of a circuit is to be reducedfrom 2900 pF to 1200 pF. What…

A: C1=2900 pFC=1200 pFx=Capacitor of unknown capacitance

Q: Will current flow more easily through a thick wire or a thin wire of the same material, when…

Q: can you use this question to answer the d. power delivered to each resistor?

A: Power delivered to resistor = I2 R

Q: If two identical resistors are connected in series to a battery,does the battery have to supply more…

A: Here, as given in the problem, R1 =R2 =R Total Resistance = R+R = 2R Electrical Potential = V We…

Q: If the voltage and resistance are doubled in a simple battery-resistor circuit, does thecurrent…

A: Using Ohm's law the relation between voltage, current and resistance is given as follows: V=IRI=VR…

Q: You are told that a certain voltage will be between 3 V and 5 V, and are given a non- autoranging…

Q: (!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION R GIVEN HERE. In the circuit shown in the…

Q: En the eircet epnesented helow he Capaciter starts out fully discharged Goq(Es0.0os)a 0.0ocjo tue…

A: WE KNOW THAT for parallel resistance 1/ R = 1 / R1 + 1 / R2 + 1 / R3 FOR SERIES Resistance R =…

Q: Consider the multi loop circuit shown in Figure 9. Directions of the currents and the numerical…

A: Apply KVL on the left loop. Similarly, apply KVL on the right loop.

Q: (II) Three 1.7 -KΩ resistors can be connected together infour different ways, making combinations of…

A: The first case of the three resistors connected together in series combination. The net resistance…

Q: 054 When the lights of a car are Lights switched on, an ammeter in series with them reads 10.0 A and…

A: The current,

Q: If The pot emtial aliff era ve nce bet wween the t of m electric motor Ls 245V is flowing.hrooth…

A: Given Potential difference between the terminals of electric motor V = 245 V Electric current I =…

Q: (III) Suppose 2.0 MW is to arrive at a large shopping mallover two 0.100Ω lines. Estimate how much…

A: Given data: Input power, P=2 MW =2×106 W Equivalent resistance, R=0.100+0.100=0.200 Ω Voltage,…

Q: In a certain stereo system, each speaker has a resistance of 4.00 Ω. The system is rated at 60.0 W…

Q: For the circuit shown in Fig. 19–46, what happens when the switch S is closed? (a) Nothing. Current…

A: In a series RC circuit, when a DC voltage supply is applied to a discharged capacitor, the capacitor…

Q: Find the Thévenin equivalent of the circuit shown in Fig. 5-18. 10 N 30 V 40 40 N V 100 V을 20 A 90…

Q: (II) Eight 7.0-W Christmas tree lights are connected inseries to each other and to a 120-V source.…

A: Given: The power of each bulb is 7.0 W. The number of bulbs is 8. The voltage is 120 V.

Q: The equation P= V2/R indicates that the power dissipatedin a resistor decreases if the resistance is…

Q: Att= 0 the switch S is closed with the capacitor uncharged. If C = 20 µF, ɛ = 50 V, and R = 5.0 kN,…

Q: How does Ohm's Law relate to a motor?

A: How does Ohm's Law relate to a motor?

Q: (II) How many time constants does it take for thepotential difference across the resistor in an LR…

A: Since, the potential difference across the resistor (V) is proportional to the current (I). So, the…

Q: What is true in general about the voltage (potential) supplied by the battery compared with the drop…

Q: If a current of one- or two-tenths of an ampere were to flow into one of your hands and out the…

A: We know that, according to Ohm's law, current is directly proportional to the voltage across the…

Question

(II) A close inspection of an electric circuit reveals that
a 480Ω resistor was inadvertently soldered in the place
where a 350Ω resistor is needed. How can this be fixed
without removing anything from the existing circuit?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
Check Your Understanding When using Kirchhoff’s laws, you need to decide which loops to use and the direction of current flow through each loop. In analyzing the circuit in Example 10.7, the direction of current flow was chosen to be clockwise, from point a to point b. How would the results change if the direction of the current was chosen to be counterclockwise, from point b to point a?
When the switch shown in Fig. 19–45 is closed, what willhappen to the voltage across resistor R1 It will(a) increase. (b) decrease. (c) stay the same
A close inspection of an electric circuit reveals thata 480 ohm resistor was inadvertently soldered in the placewhere a 350 ohm resistor is needed. How can this be fixedwithout removing anything from the existing circuit?
A person with body resistance between his hands of 10.0 kΩ accidentally grasps the terminals of a 20.0-kV power supply. (Do NOT do this!) What is the power dissipated in his body?
A device (such as a light bulb) experiences a voltage drop of 4.0 V across it while a DC current of 4.0 mA flows through it. How much power does it dissipate? Help me with conceptualizing this question better. It has to do with P = VI
(III) Suppose 2.0 MW is to arrive at a large shopping mallover two 0.100Ω lines. Estimate how much power is savedif the voltage is stepped up from 120 V to 1200 V and thendown again, rather than simply transmitting at 120 V.Assume the transformers are each 99% efficient
(II) The capacitance of a portion of a circuit is to be reducedfrom 2900 pF to 1200 pF. What capacitance can be added tothe circuit to produce this effect without removing existingcircuit elements? Must any existing connections be brokento accomplish this?
There is a voltage across an open switch, such as shown . Why, then, is the power dissipated by the open switch small?
Integrated Concepts Hydroelectric generators (see Figure 20.43) at Hoover Dam produce a maximum current of at 8.00 X 103 A at 250 kV. The water that powers the generators enters and leaves the system at low speed (thus its kinetic energy does not change) but loses 160 m in altitude. How many cubic meters per second are needed, assuming 85.0% efficiency?
For the circuit shown in Fig.a 20.0 Ω resistor is embedded in a large block of ice at 0.00°C, and the battery has negligible internal resistance. At what rate (in g /s) is this circuit melting the ice?
If a current of one- or two-tenths of an ampere were to flow into one of your hands and out the other, you would probably be electrocuted. But if the same current were to flow into your hand and out the elbow above the same hand, you would survive even though the current might be large enough to burn your flesh. Explain.