Show plz the solution with the setting of components II. Using Multisim, simulate a single phase ACcontroller with pure resistive load and get thefollowing:The supply voltage waveform.b. The output voltage waveform.c. The output current waveform.d. The thyristorl current.e. The thyristorl voltage.с.

In this problem we need to simulate asingle phase AC controller having resistive load..then find of…

II. Using Multisim, simulate a single phase AC controller with pure resistive load and get the following: a. The supply voltage waveform. b. The output voltage waveform. c. The output current waveform. The thyristor l current. The thyristor1 voltage. d. е.

II. Using Multisim, simulate a single phase AC controller with pure resistive load and get the following: a. The supply voltage waveform. b. The output voltage waveform. c. The output current waveform. The thyristor l current. The thyristor1 voltage. d. е.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.23P: A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the...

See similar textbooks

Related questions

Q: Which of the following is used to reduce the compounding of a DC generator? Inverter Diverter…

A: DC generator is a device which converts the Mechanical energy into the electrical energy

Q: At an electrical rotor position of 7/2, the flux linkage equations of a 2-phase machine are 2ab =…

A: Given λab =2005 iab and Ksr =0-110

Q: Q 1 (a) Define voltage regulation of a generator. How its voltage regulation may be found by MMF…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Discuss about the performance characteristics of wind turbine

A: Introduction - Wind turbines use aerodynamic force by the propeller blades to convert wind energy…

Q: 4) For a motor output power is given by . .

A: The output power for a motor is given by:

Q: b) Briefly explain TWO (2) disadvantages of low power factor.

A: 1. Increases the conductor size For Three Phase AC Circuit the power = P = √3 V x I CosФ So…

Q: In a DC generator, if the core loss constant and the copper loss is increasing, then the efficiency…

A: The given statement is False. The explanation is provided below.

Q: a) Primary transmission Secondary transmission b) c) Primary distribution d) Secondary distribution

A: Primary transmission : In primary transmission voltage is transmitted at 132 KV to the transformer…

Q: A3-phase, F--connected, 2-pole alternator nuns at 3,600 rp.m. If there are 500 conductors per phase…

A: 3ϕ,Y = 2 pole . #600 rpm , 500 conductors/phase ϕ = 0.1 , f= ? , Emf/phase = ? Ns = 120fPf= NsxP120…

Q: Discuss the application of the following Flexible AC Transmission Systems (FACTS) devices: a)Shunt…

A: In this question we discuss the application of shunt and series compensator.

Q: Give Some application-s of motor,

A: A brief about DC Series Motor DC Series Motors have high starting torque and their speed…

Q: O What is the difference between AC and DC coupling?

A: Coupling is the process where we are giving the supply to the any electric circuit may be amplifier…

Q: A.C generator.

A: AC Generator AC generator is a device that converts mechanical energy given as input to the shaft…

Q: A shunt generator supplies 16A at a Terminal votage of 200 vots. The armature nd shunt field…

A: Given that Vt=200VIL=96Ara=0.5 ohmRsh=50 ohmPi+Pf=2500W (a)…

Q: ZAP O * Asiacell ll. docs.google.com Q-From the figure below, select the capital letter representing…

A: From the given curve For DC differential compund genrator Ans . A For DC shunt Genrator Ans. B…

Q: (=28[Ohm])+L(=30 [mH]) seri bağlı yüke sahip tristör kullanılarak tasarlanan tek faz a.a kıy er bir…

Q: A single-phase alternator connected to 6,600-V bus-bars has a synchronous impedance of 10Ω and a…

Q: Explain binary cycle power plant (using figure). Compare its performance as compared to other…

A: The binary cycle power plant details are shown below; Binary cycle power plant is a form of…

Q: Q#5a) What is electric traction system, explain its major components. b) What are the Merits and…

A: (a) Electric traction system - The system which is used to drive the vehicle using electrical energy…

Q: A 6600V, 3-ph, Y-connected alternator has a synchronous impedance of (0.4+j6) ohm per phase.…

Q: 6. A 3-phase AC generator is supplying power to a load of 3200kW at 2300V and a power factor of 60%.…

Q: Draw the circuit diagram of self excited DC compound short shunt generator, mark all current and…

A: Self excited machines are the ones whose field magnets are excited by the currents supplied by…

Q: The single-phase AC voltage controller of Figure 2.1 has a 120 Vms source and a load resistance of…

A: Given circuit for single phase AC voltage controller is shown above. We need to calculate the rms…

Q: H.W/ a- What is the voltage regulation coefficient. b- What is the importance of knowing the voltage…

A: a) voltage regulation : It is a ratio of change in terminal voltage to the rated terminal voltage…

Q: Select the variable loss of a DC Series Generator, in the given list. a. Mechanical Loss b. Copper…

A: Given state ment is variable loss of a DC Series Generator, in the given list.

Q: root locus

A: to find the open loop transfer function of this root locus we need to identified the zeros nd poles…

Q: Calculate the unit step input steady state error (e_ss) for the control system below.

Q: Plot the external and internal characteristics of shunt generator

A: To plot the internal and external characteristics of the DC shunt generator. The external…

Q: Q) A P-Pole three-phase induction machine with spatial distribution of stator windings is assumed to…

A: We will find that the , two cycles of emf is produced in one complete revolution of conductor.…

Q: 1-Plot the External, Internal and No-load characteristics curves of a de series generator.

A: You have posted multiple questions, so I am solving the 1st questions for you 1) Based on the given…

Q: Open circuit characteristic of a d.c. generator gives relation between * V and If E and la V and la…

Q: Single phase half wave AC-AC converter has a resistance of R = 50 ohms. Input voltage is given as…

A: Given in the question: Load resistance: RL = 50 Ohms Input voltage, V = 230V Firing angle, α=600…

Q: The suitable turbine types used for a depends on many influencing parameters, with two primary…

A: The answer is hydropower plant

Q: Explain the power flow diagram of a de generator. Q1/

Q: - Comment on the possible industrial application of cumulatin compound generator types, series,…

A: Application of various DC Generator for the industrial applications. DC series generator,…

Q: A power company is planning to replace a 30-year-old thermal power generator with a capacity of 200…

A: Take Capacity =Q Cost =C Cost capacity factor as x Given: Q1=200MW Q2=1000MW C1=300 million Dollar…

Q: What is voltage stability? How is reactive power linked with the voltage stability in the power…

A: Voltage stability is characterized as the capacity of the power system to support fixed passable…

Q: onstruction, o

A: AC GENERATOR: AC generator is an electric generator that converts mechanical energy to electrical…

Q: If, in a 3-4 alternator, a field current of 50 A produces a full-load armature current of 200 A on…

A: Given, A 3-φ alternator has, Field current of 50 A Open circuit line voltage, Vocline=1730 V Open…

Q: 1. Define Pitch Factor /Distribution Factor and present the formula to calculate. 2. Draw the

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A dc shunt generator has a shunt field winding resistance of 100 ohms. It supplies a load of 5 kW at…

A: Given : In the given circuit the they have mentioned a DC shunt generator circuit. They want to…

Q: Briefly explain TWO (2) disadvantages of low power factor.

A: Power factor angle (φ) is the angle between the voltage (V) and the current (I)

Q: Find the Dynamic Equations of a synchronous generator when the stator transients and phase…

A: Here it is asking to find dynamic equations of a synchronous generator when the stator transients…

Q: please write introduction of Power and Power factor in AC Circuits

A: We need to tell about the power and power factor in ac circuit

Q: If, in a 3-φ alternator, a field current of 50Aproduces a full-load armature current of 200 Aon…

Q: the single-phase ac voltage controller has a 240 V rms 50 Hz source. The load resistance is 20002…

Q: A critical factor in the section of a generation of a generator for a particular application is that…

A: From a customer point of view, the important factors that customer look for while purchasing the…

Q: : A short-shunt d.c. compound generator supplies 200 A at 100 V. The resistance of armature, series…

Q: 1. Compare between closed loop system and open loop system of mechanical and exciter of synchronous…

A: Open Loop System: Because they do not offer feedback from the machine movement to the controller,…

Question

Show plz the solution with the setting of components

II. Using Multisim, simulate a single phase AC
controller with pure resistive load and get the
following:
The supply voltage waveform.
b. The output voltage waveform.
c. The output current waveform.
d. The thyristorl current.
e. The thyristorl voltage.
с.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Write a report on the Star connection for three phase load experiment using the data/results from the experiment.
n 3-phase alternator, the change of terminal voltage from no load to full load is more in case of leading power factor as compared to unity power factor. Select one: True False
Power Transmission and Distribution Discuss the advantages and disadvantages of single-phase and three-phase system
Q9-b) Sketch the connection of 3-phase source to 3-phase load using 3–phase 4 wire complete with labels.
- Define the parts and functions of AC Generator - Define the working principle of AC Generator. - Define WYE and DELTA connection in AC Generator.
A single phase, unity power factor load takes 90 Amps at 10 kV. Using a base voltage of 65 kV and base kilovolt amperes of 4475 kVA. Find the base current, base impedance, base power, per unit current and per unit voltage of the load.
The voltage v(t)=359.3cos(t)volts is applied to a load consisting of a 10 resistor in parallel with a capacitive reactance XC=25. Calculate (a) the instantaneous power absorbed by the resistor, (b) the instantaneous power absorbed by the capacitor. (c) the real power absorbed by the resistor, (d) the reactive power delivered by the capacitor, and (e) the load power factor.
The three-phase source line-to-neutral voltages are given by Ean=100,Ebh=10+240, and Ecn=10240volts. Is the source balanced? (a) Yes (b) No
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
The total instantaneous power absorbed by a three-phase motor (under balanced steady-state conditions) as well as a balanced three-phase impedance load is (a) A constant (b) A function of time