(iii) A fly-back converter has primary to secondary turns ratio of 15:1. The input voltage is constant at 200 volts and the output voltage is maintained at 18 volts. What should be the snubber capacitor voltage under steady state? (a) More than 270 volts. (b) More than 200 volts but less than 270 volts. (c) Less than 18 volts. (d) Not related to input or output voltage.

(iii) A fly-back converter has primary to secondary turns ratio of 15:1. The input voltage is constant at 200 volts and the output voltage is maintained at 18 volts. What should be the snubber capacitor voltage under steady state? (a) More than 270 volts. (b) More than 200 volts but less than 270 volts. (c) Less than 18 volts. (d) Not related to input or output voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.2P

See similar textbooks

Similar questions

Discuss about Power Thyristor's DC and Ac switching.(with Diagram)
What is the ripple factor and what causes it? Discuss and explain how this factor can be used as a metric to improve the quality of the designed AC to DC converting system
Single phase half wave AC-AC converter has a resistance of R = 50 ohms. Input voltage is given as 230 Vrms. Transformer conversion ratio is 1:1. If T1 thyristor is triggered at 60 degrees; a)Rms output voltage? b)Output power? c)RMS load current and average load current? d)Input power factor? e)Average and RMS thyristor current?
Power Electronics a) A Flyback Converter with an ideal turns ratio of 1: 1 feeds a 10 Ohm load resistance with a voltage of 10 Volts. Calculate the welding voltage since duty ratio is given as D = 0.2. b) A Flyback Converter with ideal turns ratio of 1: 1 feeds a load resistance of 5 Ohm with a voltage of 40 Volts. If the welding voltage is 30 Volts, calculate the D coefficient, which gives the relationship between the output voltage and the welding voltage.
give an example of AC to DC converter diagram
How does a buck-boost converter operates?
What do you think the upsides and downsides of a buck converter system with a duty cycle that can fluctuate dramatically (fast system response) are?What do you think the benefits and drawbacks of a buck converter system with slow duty cycle changes (slow system response) are?
Suppose line voltage may be as low as 105 Vrms or as high as 125 Vrms in a half-wave rectifier. With a 5;1 step-down transformer, the minimum peak load voltage is closest to___
Q5:- Adjust a fire angle for a three-phase fullwave semi-controlled converter to feed the separately exciter DC motor to get a load torque that can be reached to 730 rpm. When the supply voltage of converter is 160 volts per-phase and the absorbed current through the armature 40A with resistance 0.2 and a constant back emf 0.4v/rpm. Then find the maximum speed for motor assume the previous parameters values are a constant.
How do I calculate the duty cycle of a full bridge DC bidirectional converter operating in bipolar mode?
2. Consider buck-boost converter with the following parameters: Vin=40 V, V0 =60 V, R=20 Ω, andL=750 µH. Determine the duty cycle? is this converter operates as a buck or a boost converter ?and Calculate IL,min and IL,max. Note: Switching period T= 200 micro-second
Power electronics. Describe different control schemes of AC regulators and derive the expressions of average and effective values of output voltage.