(III) (a) What is the rms current in an RC circuit if R= 6.60 KΩ and C= 1.80μF and the rms applied voltage is 120 V at 60.0 Hz? (b) What is the phase angle between voltage and current? (c) What are the voltmeter readingsacross R and C?

(III) (a) What is the rms current in an RC circuit if R= 6.60 KΩ and C= 1.80μF and the rms applied voltage is 120 V at 60.0 Hz? (b) What is the phase angle between voltage and current? (c) What are the voltmeter readingsacross R and C?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 12CQ: When the current in the RL circuit of Figure 14.12(b) reaches its final value /R, what is the...

See similar textbooks

Related questions

Q: In an RLC series circuit, if the AC frequency is increased to a very large value. Does the phase…

A: Reactance due to inductor = 2πfL Reactance due to inductor increases when frequency increases…

Q: How would you place two identical flat coils in contact so that they had the greatest mutual…

A: Given: Two coils

Q: Can the instantaneous power output of an ac source ever be negative? Can the average power output be…

Q: How much resistance must be added to a pure LC circuit L = 320 mH , C = 1800 pF to change the…

Q: In a purely capacitive circuit, voltage and current are in phase Select one: O True O False

Q: What will happen to the current in this purely capacitive circuit as frequency increases? 5 V RMS…

A: We know that, in a purely capacitive circuit if frequency increases the current also increases.…

Q: Does the time required for the current in an RL circuit to reach any fraction of its steady-state…

A: In a DC-RL-circuit, as shown in the circuit diagram below, the battery voltage is V, the resistor…

Q: When a 5.0-µF capacitor is connected to a generator whose rms output is 31 V, the current in the…

Q: An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4…

Q: The average power at resonance (when Vmax=100 V , R=100 ohm) is: a-99.49W b-45.98W c-49.98W…

A: The expression for the maximum power dissipated at resonance will be,

Q: An RL circuit with a 1-2 resistor and a 0.01-H inductor carries a current of 1 A at t=0, at which…

Q: The phase angle in a certain RL circuit is 68° at a frequencyof 60.0 Hz. If R = 2.1 Ω for this…

A: Using the equation for phase angle in RL circuit, θ=tan-1XLRtanθ=XLRXL=R tanθ

Q: Can a circuit element have both capacitance and inductance?

A: No, it is not possible that a circuit element has both capacitance and inductance.

Q: When alone in an AC circuit, inductors, capacitors, and resistors all impede current. How do they…

A: Every element has its own characteristics for the applied AC supply. For resistor, current is in…

Q: An alternating current in a circuit is given by, I = 20 sin (100 al + 0.05x)A. What is the rms value…

Q: (II) For a 120-V rms 60-Hz voltage, an rms current of 70 mApassing through the human body for 1.0 s…

A: Given data: RMS voltage, Vrms=120 V Frequency, f=60 Hz RMS current, Irms=70 mA=70×10-3A Time taken,…

Q: •• Find the average power consumed by an RC circuit connected toa 60.0-Hz generator with an rms…

Q: Calculate the inductance in the given circuit if impedance is 52 and angular frequency is 500 rad/s.…

Q: (6) If a circuit has inductance L = 8 henrys, resistanceR = a voltage source E(t) = 17 cos(2t).…

A: Given The inductance of the inductor is L = 8 H. The resistance of the circuit is R=16 Ω. The…

Q: When an ac generator with a frequency of 180 Hz and an rmsvoltage of 36 V is connected to an RC…

A: Find the impedance of the circuit. Z=vrmsIrms=36 V0.28 A=128.6 Ω

Q: The peak value of an alternating current in a 1900-WW device is 4.2 AA . What is the rms voltage…

Q: A 10.0-0 resistor, 10.0-mH inductor, and 10.0-uF capacitor are connected in series with a 10.0-kHz…

Q: Can you measure power in an ac circuit by using an ammeter and voltmeter? If No, why? If yes, how?…

A: D.C voltmeter and ammeter are based on the magnetic effect of current . It reads the average value…

Q: Determine the frequency and the phase angle between the two voltages v¡(t) = 12 sin (1000t + 60°) V…

Q: . In an LRC circuit, can the rms voltage across (a) aninductor, (b) a capacitor, be greater than the…

A: Yes, the rms voltage across an inductor and capacitor is greater than the rms voltage of the AC…

Q: Consider a series RLC circuit, with R = 120 N, C = = 510 mH. If an 330 µ F and L alternating…

A: Given: The resistance of the circuit is 120 Ω. The capacitance of the circuit is 330 μF. The…

Q: The emf of an ac source is given byv(t) = V0sin ωt, where V0 = 100 V andω = 200π rad/s. Calculate…

A: Given: The emf of an AC source is v(t) = V0sin ωt. The voltage is V0=100 V. The angular velocity is…

Q: . When electric lights are operated on low-frequency ac (say,5 Hz), they flicker noticeably. Why?

A: The formula for measuring the time period is given as the reciprocal of the frequency. If the…

Q: Calculate the rms currents for an ac source is given by v(t) = V0 sin ωt, where V0 = 100 V and ω =…

A: Given data: AC source, Vt=V0sinωt Peak voltage, V0=100 V Angular frequency, ω=200π rad/s…

Q: For a 120-V, 60-Hz voltage, a current of 70 mA passing through the body for 1.0 s could be lethal.…

A: Given data: voltage of source, V = 120 V Current, I = 70 mA = 0.07 A

Q: A series circuit contains a 3.00 - H inductor, a 3.00 - mF capacitor,and a 30.0 - V resistor…

A: (a). the imprudence of the circuit at resonance Frequency is

Q: Consider an initially passive LC circuit (no resistance) with a battery supplying eo volts. (b) If L…

A: Write the circuit equation, and solve for LC circuit. The potential of the battery is e0. The switch…

Q: The voltage in an AC ckt varies harmonically with time with a maximum of 180V. At what angle in its…

Q: 32.9 ohms, an inductor with an inductance 1.76 H, and a capacitive reactance of 6.75 Ohms. If the…

A: Given, R=32.9 ohms L=1.76 H V=160V XC=6.75 ohms Vrms=160 V

Q: In an L-R-C series circuit, can the instantaneous voltage across the capacitor exceed the source…

A: Yes, the instantaneous voltage across the capacitor exceeds the source voltage because the voltage…

Q: why does the voltage in and out become 0 when the voltage source was changed from DC with 5V to AC…

Q: Discuss why it is relatively easy to change the amplitude of an AC voltage to a higher or lower…

A: (AC) the movement of electric charge which was in repeatedly in opposite direction AC voltage:…

Q: . A pair of power transmission lines each have a 0.95Ωresistance and carry 740 A over 9.0 km. If the…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: In a purely inductive circuit if the supply frequency is reduced to 1/2, the current will

A: The Reactance of inductive circuit can be given as, XL = ωL XL = 2πfL

Q: What effect does changing the frequency of the input signal to the current in the resistor in a…

A: Resistance is affected by frequency. The cause for this is the'skin effect.' Only a small area of a…

Question

(III) (a) What is the rms current in an RC circuit if R= 6.60 KΩ and C= 1.80μF
and the rms applied voltage is 120 V at 60.0 Hz? (b) What is the phase angle between voltage and current? (c) What are the voltmeter readings
across R and C?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
Check Your Understanding What happens to the resonant frequency of an RLC series circuit when the following quantities are increased by a factor of 4: (a) the capacitance, (b) the self-inductance, and (c) the resistance?
Check Your Understanding Repeat Example 15.1 for an ac source of amplitude 20 V and frequency 100 Hz.
For a 120-V, 60-Hz voltage, a current of 70 mA passing through the body for 1.0 s could be lethal. What must be the impedance of the body for this to occur?
. When electric lights are operated on low-frequency ac (say,5 Hz), they flicker noticeably. Why?
An ideal transformer produces an output voltage that is 500% larger (e.g. a 6-fold increase) than the input voltage. 1)If the input current is 13 A (rms), what is the output current? (Express your answer to two significant figures.)
The primary winding of an ideal transformer is wound with 550 turns and is connected to a 220 V rms supply. If the secondary voltage is 20V rms, calculate to find the number of turns on the secondary winding.
Check Your Understanding An ac voltmeter attached across the terminals of a 45-Hz ac generator reads 7.07 V Write an expression for the emf of the generator.
When the current in the RL circuit of Figure 14.12(b) reaches its final value /R, what is the voltage across the inductor? Across the resistor?
Check Your Understanding The resonant angular frequency of an RLC series circuit is 4.0102 rad/s. An ac source operating at this frequency transfers an average power of 2.0102W to the circuit. The resistance of the circuit Is 0.50 Q. Write an expression for the emf of the source.
Check Your Understanding Find the voltages across the resistor, the capacitor, and the inductor in the circuit of Figure 15.11using v(t)=v0sint asthe output of the ac generator.
Can a circuit e1eent have both capacitance and inductance?