IL 300 mH 101A + 100 Q 60 Ω ww TA 1. Determine the Thevenin equivalent circuit seen by the inductor
Q: Q36. A resistor with a current of 3 A through it converts 500 J of electrical energy to heat energy…
A:
Q: Evaluate the steady state response of a series RC, where R=20 ohm and C=0.10 uF if the input voltage…
A:
Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…
A: In this question we have to find the value of base current, static value of resistance and dynamic…
Q: frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and the…
A: We need to find out characteristics impedance for given transmission line for given open circuit and…
Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…
A: Given: A 1-phase transformer has, No load secondary voltage, V2nl=235 V. Full load secondary…
Q: What is the impedance of the circuit? + V₂ 317V 1.5 kHz R₁10 kn ₁0.01 μF -00000² 3 H
A: Solution !! The impedance z=""R^2+(Xl-Xc)^2.R=10000ohms,Xl=2πfl=2*3.142*1500*3=28278ohms.
Q: 1. For the motor load, torque -speed curve shown below, solve the following questions. R 2. T (N-m)…
A:
Q: Find the power factor and apparent power unla cun v(t)=160 cos (377 t+10 grados) nos cuando se le…
A:
Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…
A: Given data, Current I=6.25 A Voltage V=36.5 V Limit of error=2 %
Q: Consider a uniformly charged solid cylinder with length L and radius R as shown below. Determine…
A: GIVEN DATA: A uniformly charged solid cylinder with length L, radius = R, the electric potential…
Q: The kVA and kW inputs of 3-phase star connected system are 52 and 25 respectively. The KVAR input is
A: Given: In a 3-phase star connected system, The apparent power, S=52 kVA. The real power, P=25 kW.
Q: Calculate the resistance of a load that takes 1,600 watts from a 220 volts source.
A:
Q: Calculate the Resistance, if the RTD temperature 3.1 °C/ohm is 2559.1 °C and Sensitivity is O a.…
A: Given: In a RTD the temperature is, T=2559.1°C. And sensitivity is S=3.1°C/ohm.
Q: Q3: A// Use Boolean Algebra techniques to simplify. (Answer 1 or 2). 1-Y =[AB (C+BD) + ABJC 2-Y AB+…
A:
Q: 4. Determine the node voltages. 80 W ह125 100 n 20A 18V (115A
A:
Q: SW1 SUZ d B T 2 A 0 0 1 1 5 Output expression C = Logic function: A 9 10 13 B 0 1 0 1 12 For each…
A:
Q: ST 1A Figure 8.3 10 Q2 6 V 222 See Figure 8.3. What is the value of the voltage Vs?
A: Given
Q: What is the equivalent resistance (in 0) seen at the terminal of the 7.5V voltage source? (up to 2…
A: According to KCL, the sum of current entering a node is equal to sum of current leaving the node
Q: 1. Design a clamper to perform the function indicated. Determine the proper value of VDC Calculate…
A: We need to find out the average value and swing for output voltage and we need to design the given…
Q: The terminal p.d. of a d.c. source is 22.5V when supplying a load current of 10 A. If the emf is 24V…
A:
Q: A SW1 B SW2 2 3 6 8 9 12 10 13 or A 0 0 1 1 11 с Logic function: Boolean equation for output, C =…
A: The output of AND gate is high if all the input is high. The output of OR gate is high if any one of…
Q: 3. Determine V, and I. 40V(+ 82 M Io M 202 50 W + Vo -+ 18V M 652 400
A:
Q: If the unit step response of a network is (1 - e-at), then Find its unit impulse response
A:
Q: SW1 SW2. 4 B L 2 A 0 0 1 1 5 Output expression C = Logic function: 9 10 13 B 0 1 0 1 12 For each set…
A: Given: A logic circuit with two inputs and one output To do: - complete the truth table - find the…
Q: Question- Find the maximum power delivered by 1500 kW, 3-phase, star-connected, 4 kV, 48 pole, 50 Hz…
A:
Q: Determine the total resistance at points a and b of the circuit shown below. a www 60Ω 12Ω 30Ω 26Ω…
A:
Q: Given shows the mutual characteristic for a junction gate field effect transistor. When the…
A: Gate source voltage VGS = -2.5V
Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…
A: Given: Ammeter Measurement range : 0-10A Voltmeter Measurement range : 0-50V Ammeter Reading =…
Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…
A: In this question, DC Generator , Number of pole P= 8, Number of conductors Z= 240 Flux = 0.04wb…
Q: 3 .it is a logic circuit whose output depends both on the present value of the input and the…
A: Logic circuit: Logic circuit are the combination of logic gates. There are mainly 6 basic types of…
Q: 1. Two resistors (R1, R2) are connect in parallel, prove that R₁ = R₁ R2 R₁ + R₂
A:
Q: +10V +3V +10 V 2.7k2 100k2 ㅐㅂ -390 k2 2.2k2 (b) The BJTs in the two circuits have B=100 and |VBE| =…
A:
Q: MESH ANALYSIS 4. Find the currents i₁, i2, and i3. 12 V 4Ω www 12 www 632 10 V www 202
A:
Q: Program The first number 98H is placed in the memory location 2501 H. The second number 87H is…
A: Solution !!
Q: • 1. Determine Iz using current division. lov (+ 52 N Iz $32 ≥6.2 65 392
A: We need to find out the current by using of current Division rule .
Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…
A:
Q: 6. Find the Vo using superposition.
A: It is given that:
Q: 2. Determine lx. 10A (↑ It iz $2.0 → Ix |↑ Ix $82 lla 452
A: We need to find out current for given circuit , we apply nodal analysis to find out node voltage…
Q: The external load characteristic of a DC generator at rated speed is assumed to be linear and is as…
A: Given characteristics of a DC generator. Load current IL = 50A Asked to find the load circuit…
Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…
A: We need to find out power as energy and cost of energy for given current and time and resistance .
Q: Consider a silicon diode with ideality factor n = 2 and starting at room temperature. Show that the…
A:
Q: 2. If I¸ is equal to 2A, find I. X Ix Me 20₁2 $4₂2 38₁ to 1652
A:
Q: R₁ = 52 દે 1₁ род ↑ Vab Va R₂= гол 4 A
A:
Q: standard form.
A:
Q: viii) For the signal x (t) = tu(t-1), Find the expression for the signal obtained by performing (a)…
A:
Q: 3. Determine Vx. 60V/ 25. M 400 1252 M +V+- 24.0 ში. :240 =240 ÚJA
A:
Q: 4. Determine the total resistance across a-b. 452 62 1052 24025 W 122 150 7522 mob 182 322
A: The given problem is from circuits. The solution is given in the next step
Q: Consider the magnetic circuit of with the dimensions of Problem 1.1. Assuming infinite core…
A: The magnetic circuit is shown below,
Q: Given shows the mutual characteristic for a junction gate field effect transistor. When the…
A: The only given parameter to us is gate to source voltage = -2.5 V
Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…
A:
Do what is indicated.
Step by step
Solved in 4 steps with 3 images
- Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L[13/04, 7:52 pm] Sankar: Consider the following series RLC circuit. The switch is closed at time t=0. (You may assume the inductor and capacitor have been fully discharged at t=0.) Find the capacitor voltage ?? (?) for ? ≥ 0.12. 7.12 In the circuit , let Ig represent the dc current source, σrepresent the fraction of initial energy stored in the inductor that isdissipated in to seconds, and L represent the inductance. 1. a) Show thatR=Lln[1/(1−σ)]2to
- Capacitance= 10uF , t≈65 μs, Vfinal=4VPlot capacitor current and voltage graphs. NOTE: if you want you can use falstad online circuit simulator.The capacitor of external defibrillator must be loaded at 1500V, in order to generate a two-phase wave of 150 J.Considering a transthoracic impedance is 80ohms and a capacitance of 30 000 uF. 3- What is the energy of the capacitor?4- What is the internal impedance of the defibrillator in the previous cases?A 200 Ω resistor, 0.900 H inductor, and 6.00 µF capacitor are connected in series across a voltage source that has voltage amplitude 30.0 V and an angular frequency of 250 rad/s. (a) What are v, vR, vL, and vC at t = 20.0 ms? Compare vR + vL + vC to v at this instant. (b) What are VR, VL, and VC? Compare V to VR + VL + VC. Explain why these two quantities are not equal.
- The voltage across a capacitor C is equal to v(t) = 8 cos(1000t) V. Determine the current i(t) through the capacitor at time t. C=100mu,F and t=817. Suppose we have a RC circuit with an alternating voltage V(t) = V_{m} * cos(5t) If the initial voltage is 4V and the resistor has a resistance of 8 ohm and the capacitor is of capacitance 2F then the charge for the circuit is?For the circuit shown, determine the energy stored in the inductor. The component values are VS = 11 V, R1 = 9 Ω, R2 = 4 Ω, R3 = 8 Ω, C = 0.161 F, L = 0.01
- For t < 0, the capacitor in the given figure is completely discharged. Assume that the switch is thrown at t = 0. Let VS = 15 V, R = 200 Ω, L = 20 mH, and C = 0.1 μF.A given RLC circuit (Resistor-Inductor-Capacitor) has the following components: R = 4.1 Ohms L = 0.0099 H C = 0.00011 F If this system is driven by an oscillating current with frequency f = 2,594 Hz, what is the Inductive Reactance (XL) of this system?A 160 μF capacitor is connected in series with a 10 Ω resistor. Write the equation of the current when the voltage is 220 Vp? a. 11.4 sin (377t + 59) b. 8.9 sin (377t – 46) c. 9.8 sin (377t + 52) d. 7.2 sin (377t + 46)