6. Find the Vo using superposition.

Q: An important difference between the open- and closed-loop control systems is that the   Question 9…

A:

Q: An ideal dc generator has regulation of 40% O 20% 30% O Zero

A:

Q: 1. When the inputs to an exclusive-OR circuit are alike, the output is binary 2. An exclusive-NOR…

A:

Q: Consider a uniformly charged solid cylinder with length L and radius R as shown below. Determine…

A: GIVEN DATA: A uniformly charged solid cylinder with length L, radius = R, the electric potential…

Q: Calculate the noise current for a diode W/a bias current of 5mA observed over 75Khz bandwidth. also…

A: According to the question, we need to calculate the noise current for a diode with a bias current of…

Q: 3. Determine ₁ and ₂ using current division. 20A (1 10n³ an tilin four plait 200 1522

A: Given: A network with a current source of 20 A and some parallel combination of resistances To do:…

Q: iii) Simplify the expression sin it t-1 8(t-1/2)

A: In this question we need to simplify the given expression .

Q: x(t) = e-3tu(t)

A:

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of…

A:

Q: Synchronous danter А canta J A7 12 A J B T -K B B J T k 217

A:

Q: The sparking at the brushes of a dc generator is due to winding distribution high constant…

A:

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C= 10μfδ = 10∘f = 50 Hz Find: Power Factor Angle(φc)Power Factor cosφc

Q: A SW1 B SW2 2 3 6 8 9 12 10 13 or A 0 0 1 1 11 с Logic function: Boolean equation for output, C =…

A: The output of AND gate is high if all the input is high. The output of OR gate is high if any one of…

Q: Find the power factor and apparent power

A: It is given that: vt=160cos377t+100 V V=160∠100 V  Z=60+j40 Ω

Q: Determine the system function of the discrete system described by difference equation y(n)-1/2…

A: In this question,  We need to determine the system function of the discrete system.  We are solving…

Q: Determine the total charge transferred over the time interval of 0 ≤ t ≤ 10s when i(t) = ½ t A.

A: Given data, Current it=12t A Time(t) 0 s≤t≤10 s

Q: 50. A signal x(t) = sinc (1507t) is sampled at a rate of a) 100 Hz, b) 200 Hz, and c) 300Hz. For…

A: Solution !! Given x(t) = sinc (150πt) The spectrum of the signal x(t) is a rectangular pulse with a…

Q: 10+ -10+ 15+ 10 5- (A) ☆ 10- 5 0 -10- 5V (B) R1 1k 10- 0 -5 -10+ (C)

A: This is a problem of analysis of diode. The detailed solution is given in the next step.

Q: If the unit step response of a network is (1 - e-at), then Find its unit impulse response

A:

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: The power input to a 500 V, 50 Hz. 6-pole. 3-phase induction motor running at 975 RPM is 40 kW. The…

A:

Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…

A: We need to find out power as energy and cost of energy for given current and time and resistance .

Q: Determine Ia,Ib,Ic,Id.

A:

Q: Determine the system function of the discrete system described by difference quation y(n)-1/2…

A: Solution !! y(n)-1/2 y(n-1)+1/4 y(n-2) = x(n)-x(n-1) Taking z-transform,    Y(z) -1/2z-1Y(z) +…

Q: Which of the below statements is NOT True regarding Tidal Power? The primary source for Tidal Power…

A: Given: Tidal Energy

Q: DC series motor has an armature resistance of 0.060 and a series field resistance of 0.080. The…

A:

Q: At what frequency will a 0.016 henry inductor have an inductive reactance of 80 ohms?

A:

Q: SUL A SW2 B 1 2 7486N 3 C Logic function: L1 Record the state in the appropriate space in the Table.…

A:

Q: SW1 0 1 1 0 SW1 SW2 SW3 SW4 LSB O INPUTS SW2 SW3 0 1 0 0 0 1 1 1 Logic circuit function: 1 D 2 SW4 0…

A: Given: A logic circuit with four inputs, four outputs and one control signal A.  Truth table of the…

Q: A transformer works at 7 KVA with primary voltage of 88 V. If the secondary voltage is 230 V, then…

A: Given: A transformer works at, Rated apparent power, S=7 kVA. Primary voltage, V1=88 V. Secondary…

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 resistor…

A: Inductance of coil L = 318.3 mH Resistance R = 200 Ω Voltage V = 240 V Frequency f = 50 Hz

Q: 6S-4 5²-45+16 1- L-1. I need a clear answer by hand, not by keyboard | dybala

A:

Q: Determine ID1= 15 V C 10 ΚΩ D D₁ KH D₂ ID2= E 5kQ www F 10 V ; VD1= VD2=

A: In this question,  We need to determine the current in diodes and voltage across it.  Assume diodes…

Q: 1. When the inputs to an exclusive-OR circuit are alike, the output is binary 2. An exclusive-NOR…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: A)What will be the frequency at C if the clock is 320 kHz? B) What is the modulo of the circuit?…

A: Answer:- A) From the given digital circuit , input to the every JK flip flop is 1. So, J =1 and K=1.…

Q: State Kirchhoff’s Current Law.

A:

Q: 5. Determine the total resistance if each Ris 30. RT M

A:

Q: it is a logic circuit that is known for being time

A: In this question we will write about logic circuit which are time independent.... Note :-as per…

Q: Electrical apprentices must take _______ core hours of training to satisfy the Michigan academic…

A: Electrical Apprenticeship:- An entry-level electrical trainee who is enrolled in an apprenticeship…

Q: The resistance of armature winding depends on length of conductor cross-sectional area of the…

A: Concept- The resistance of the armature winding is the value of the ohmic resistance of the copper…

Q: 14 A circuit of resistance 402 dissipates a power of 16W. Calculate (a) the current flowing through…

A:

Q: Fourier transform X (f²) = X(t) ejzrift if X(t) = 2 cos (B IT ft) find X(f) and plot dt

A:

Q: Voltage across Resistor R1 R2 R3 R4 R5 With R5 Table 1 With R5 Bypassed With R5 Removed

A: Given that: A circuit is shown below. Find: Bypass R5 with a connecting wire and measure the…

Q: inverse Laplace

A: It is given that: F=L-162s-8-3-2s9s2-16+8+6s4s2+9

Q: Problem 10. For the double-beam oscilloscope dis- plays shown in Figure 10.20 determine (a) their…

A:

Q: he no load secondary voltage 1-phase transformer is 232 V and full load secondary voltage is 222 V,…

A: Given, VNL= 232 V VFL= 222 V % regulation = ?

Q: What happens to the Fermi level of an intrinsic semiconductor when the temperature goes up?…

A: Semiconductor- Semiconductor is a material which have value of conductivity is between conductors…

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C = 10 μff = 50 Hzδ = 10∘ Find: Power Factor Angle φcPower Factor cosφc

Q: 8.the letter D on the D flip flop stands for? 9. it is a logic circuit that is known for being time…

A: In this question,  We need to define the D flip flop.  We are discussing about the logic circuit…

Q: Si has 4 valence electrons. ● Truel O False

A:

Current Division Method

The generalized current divider formula is given by the following relation below,