In 1.5 liter of water at 25°C we try to dissolve the below compounds. How much will not dissolve from each compound (Solubility of CaSO4 is 260 mg/100 ml @ 25°C and Solubility of NaCl is 36 g/100 ml @ 25°C) a. 4.1 g of CaSO4 Click or tap here to enter text. b. 580 g of NaCIClick or tap here to enter text.

Q: Air expands adiabatically in a piston-cylinder assembly from an initial state where p₁ = 100…

A: Given that- Air expands adiabatically in a piston-cylinder assembly for which initial states are,…

Q: Aqueous hydrochloric acid (HCI) will react with solid sodium hydroxide (NaOH) to produce aqueous…

A: write balanced reaction NaOH + HCl ----> NaCl + H2O Molar mass of NaOH = 40 g/mol Molar mass of…

Q: You are working for a factory that uses benzene in it process. The effluent flow out of the process…

A: Given data: Composition of benzene in entering air = 20,000 ppm Benzene condensed = 33 % T of air…

Q: Show that Û and Ĥ for superheated steam depend strongly on temperature and relatively slightly on…

A:

Q: what is the intracellular concentration of M-OPO32? F

A:

Q: -0.15 56 115분 - 1 구 , + 분 +16) dt -0.15

A:

Q: Draw the process flow diagram PFD for the following chemical process (show the materials and…

A: The process flow diagram of the process is to be drawn.

Q: A tubular reactor for the isomerization of n-butane to isobutane is to be installed in a dedicated…

A:

Q: Two pound of an ideal gas undergoes an isentropic process from 65.3 psig and a volume of 0.8 ft³ to…

A: Given details: the process is isentropic . Mass of the gas,m=2 lb initial pressure,P1=65.3 psig…

Q: H(ads) H2(g)

A:

Q: Aqueous hydrobromic acid (HBr) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A: The balanced reaction between HBr and NaOH to produce NaBr and H2O is written as, HBr (aq) + NaOH…

Q: A fuel gas containing 80% ethane and 20% oxygen is burnt with 200% excess dry air. Eighty percent of…

A: Basis: 100 kmol fuel gas The number of moles of ethane C2H6 in the fuel gas nC2H6,f = 80 kmol The…

Q: Using the van der Waals equation, find an expression for the derivative:

A:

Q: separation process

A:

Q: Air, 5.37 kg, is compressed in a piston-cylinder device from 95.3 kPa and 61.3 °C to 195.2 kPa in an…

A:

Q: A stock containing 1.526 kg moisture per kg dry solid is dried to 0.099 kg moisture per kg dry solid…

A:

Q: An acetone and water liquid mixture is fed to an evaporator to be partially vapourized. The initial…

A: A mixture of acetone and water is to be partially vaporized.

Q: 2. A stream of toluene vapor (C7Hs) is fed to a condenser at 6.5 mol/s. The toluene enters as…

A: From energy balance heat removed to convert vapor into liquid + heat released when liquid toluene at…

Q: Acrylonitrile is produced in the reaction of propylene, ammonia and oxygen C₂H6 + NH₂ + O₂- C₂H₂N+…

A: Given that- Acrylonitrile production reaction is- C3H6+ NH3+ 32O2→C3H3N + 3H2O Basis feed= 100 mol…

Q: ( Acetylene is produced from methane in the reaction: 2CH4 (g) → C₂H₂ (g) + 3 H₂ (g) An undesired…

A: Write the reaction as follows: 2CH4g → C2H2g +3H2g Two moles of CH4 is decomposed into 1 mole of…

Q: 1. Say we accidentally left the cover off of a test tube containing liquid benzene. The cylindrical…

A: Given data: Length of tube = 10 cm Diameter of tube = 1.5 cm Temperature = 25 0C Pressure = 1 atm…

Q: A process vessel is to be designed for the maximum operating pressure of 500 kN/m². The vessel has…

A:

Q: not used for first order

A: Q.1-  Why Ziegler Nichols method is not used for the first order process? Answer- Ziegler Nicholas…

Q: Q1/ Ideal gas is cooled at constant volume (2.23 m³/kmol) from an initial state of 4°C to final…

A:

Q: Consider 2.5 kg of austentie containing 0.65 wt% °C, cooled to below 727°C a) What is the…

A: a) Ferrite is the pro eutectoid phase since 0.65 wt% C is less than 0.76 wt% C. b) For ferrite,…

Q: An air stream is contaminated by 100 ppm (on a molar basis) of compound X. You wish to remove…

A: C) point corresponds to the temperature of 300K and pressure of 0.0001 atm in the phase diagram…

Q: Develop fuel ratic with: b) 50% e

A:

Q: Oxygen is diffusing through a stagnant layer of methane 10 mm thick. The temperature is 20°C and the…

A:

Q: Butane (C4H10)(C4H10) and dry air are fed to a combustion reactor at a steady rate of 45.9 mol/s45.9…

A: Given that, The molar flow rate of butane in the feed stream nC4H10,F = 45.9 mols The molar flow…

Q: One Ibmol of carbon reacts with 2 lbmol of oxygen (O₂) to form an equilibrium mixture of CO2, CO,…

A: Given that- Carbon (C)= 1 lb.mol Oxygen (O2)=2 lb.mol Temperature, T=52400F Pressure, P= 1 atm The…

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data: Composition of CO2 in the dry stack gas = 15 %

Q: QUESTION 8 Regarding the following reaction CO₂ (g)+H2 (g)→→CO(g)+H₂O (g) ArH=-41.2kJ/mol Using Le…

A:

Q: Question 7. For the Haber process described by the following reaction N2(g) + + 3 H₂(g) 3 2 NH3(g)…

A: The temperature at which the reaction becomes spontaneous is to be calculated.

Q: Problem 2 A building requires 5 x 105 BTU per day to maintain its temperature at 70°F when the…

A:

Q: Write and simplify the closed-system energy balance for each of the following processes, and state…

A:

Q: eprint to print an object la cells and biomaterials, crea

A:

Q: Q/ carbon dioxide (CO2) is compressed in a piston cylinder assembly of PI 0.7 bar. T1 = 280 K to P2…

A: Given data: Initial pressure, P1 = 0.7 bar Initial temperature = 280 K Final pressure, P2 = 11 bar…

Q: For the ethanol dehydrogenation reaction: C2H5OH(v) → CH3CHO(v) + H2 (g) Assume that the reactants…

A: Write the reaction as follows: C2H5OH(v) → CH3CHO(v) + H2 (g)   Take the basis as 1 s Amount of heat…

Q: Problem 5 A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the flue gas…

A: Orsat analysis is analysis without water. But hydrogen react with oxygen to form water that…

Q: Problem 1: Water at 400°C has a specific volume of 0.00700 m³/kg. Determine the pressure of the…

A: given = T = 400^C = 673KV = 0.00700 m3/Kg a) Ideal gas equation   We know that PV=RT Gas…

Q: How many moles of carbon dioxide

A: Given, Mass of substance of CO2 , m = 250 g Molar mass of CO2 , M = 44.01 g/mol We have to calculate…

Q: 11-65 In a textile manufacturing plant, the waste dyeing water (c=4295 J/kg-K) at 80°C is to be used…

A:

Q: 2SO2 + O2 ⇌ 2SO2 equilibrium reaction with 21% SO2, 10% O2 oxygen and the remainder SO3 It is fed…

A: T = 301 0C P = 200 kPa

Q: 1. A carbohydrate (S) decomposes in the presence of an enzyme (E). The reaction follows…

A: Given data: M-M kinetic parameters are, Km= 200 mol/m3 Vmax= 100 mol/m3.min CS0 = 300 mol/m3

Q: The Bradford protein assay is a dye-binding assay based on the differential color change of a dye in…

A: A data between concentration and absorbance is given.

Q: 3. Three Carnot engines each having a power output of 1MW have heat supplied at a temperature of 450…

A: Given details: Power output of each engine=1 MW Temperature at which heat is supplied i..e Source…

Q: Match the following terms to the correct definition. Sublimation Dipole-dipole attraction Adhesive…

A: The given terms are to be matched with the respective correct definitions.

Q: Problem 3: A heat pump operating at steady state maintains a dwelling at 22°C on a day when the…

A: COP=Q/Win

Q: What are the critical Re for internal external and cross. 2 why using Te for reading air Properties.

A: Given : we have to tell critical Reynolds number and why we are taking Tf for reading air property

Q: A client has an airstream that is 150 ºC and at 1 atm of pressure that contains 50,000 ppm of…

A: Given data: Concentration of heptane in air stream = 50,000 ppm Heptane removed = 40 %