In a 2-wattmeter method power measured was 30kW at 0.7 pf lagging. Find the reading of each wattmeter.

Q: carrier signal is centered at 4.5 GHz, if the Bandwidth is 5 MHz, determine the lower sideband…

A: We need to find out side band frequency for given bandwidth and center frequency .

Q: 2. You are employed in a large industrial plant. A 480-V, 5000-W heater is used to melt lead in a…

A: Since question (2) is asked so we are answering question (2) only. Given that in a large industrial…

Q: A SW1 B SW2 2 3 6 8 9 12 10 13 or A 0 0 1 1 11 с Logic function: Boolean equation for output, C =…

A: The output of AND gate is high if all the input is high. The output of OR gate is high if any one of…

Q: 3. Solve Ix and all the mesh currents using mesh analysis. lov 15V (+ 2√2 N 1₁ 65 N 13 Me 752 1052 8…

A: In the given questions we need to calculate the current Ix by mesh analysis. The given circuit is

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A:

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t= 850 ms is: a. 36.22…

A: We need to find out the stored energy in capacitor first we will find out voltage across capacitor .

Q: frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and the…

A: We need to find out characteristics impedance for given transmission line for given open circuit and…

Q: 4. Determine the node voltages. 80 W W 1275 100 n 20A 18V (115A

A:

Q: Draw a block diagram for a negative-feedback system that might be used to control the level of light…

A: It is asked to draw the block diagram  for a negative-feedback system which can be used to control…

Q: Example 14.52. An inductor of resistance 10 and inductance 100 mH is in parallel with a 10 nF…

A: Given: An inductor coil of Resistance : R=10 ohm  and L=100 mH=0.1 H is in parallel with a 10nF…

Q: The impulse function is :denoted by S(t) O u(t) O h(t) O u(t) or 8(t)

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: H(z) -1 1 - 지 (1 − ¼z−¹)(1 + ¼z−¹)

A:

Q: 4 thyristors rated 200 V in series. The operating voltage of the string is 600 V. Derating factor of…

A: Given, Total number of thyristor, n = 4. Thyristor rated voltage = 200 V. Operating voltage = 600 V.

Q: V 1 R Im k ka Ta 1 Jea eq Ö 1 S @m

A:

Q: SW1 0 1 1 0 SW1 O SW2 SW3 O SW4 LSB INPUTS SW2 SW3 0 1 0 0 0 1 1 1 Logic circuit function: SW4 0 1 0…

A: SOLUTION GIVEN                   4 XOR Gates                  TRUTH…

Q: 6. Find the Vo using superposition.

A: It is given that:

Q: In the circuit shown in the given figure, a current of 5A flows from the supply source. Switch S is…

A:

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A:

Q: 4. Use source transformation to find Vx. 20V + 42 W ·10₂ (1) 32 M + Vx 5A 80 81 (1) ЗА

A:

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: A 1-phase transformer has, No load secondary voltage, V2nl=235 V. Full load secondary…

Q: what is the output after 738 pulses?

A: An asynchronous circuit is a sequential digital logic circuit that synchronizes its components…

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given, Ammeter reading, I=6.25 A Voltmeter reading, V=36.5 V

Q: The Laplace's equation in Cartesian coordinate is equal to (a^2 V)/(x^2)+(3^2 V)/(y^2)+(3^2 V)/(dz^2…

A: We need to tell about Laplace equation , whether the given statement is true or false

Q: Write a matrix equation that determines the loop currents. 2023 31V- 39 V + 692 392 452 16 V -10V…

A:

Q: Determine the total resistance at points a and b of the circuit shown below. a www 6Ω ww 3Ω www 292…

A:

Q: 1) GO ↑ (0 ܪܚ 10 10 101 10 no curent มน no current 101110 10-52 Co A to RT- 2500000 I+= 2.4000 A & S…

A:

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. .025 sec.…

A: We need to find out time constant of given circuit , it is a RC circuit .

Q: 3. Find the node voltages v₁, v₂, and v². 1 4Q www 20 www 30 V 2 Hi 202 www. 15 A www Supe 3 802

A:

Q: Question- Find the maximum power delivered by 1500 kW, 3-phase, star-connected, 4 kV, 48 pole, 50 Hz…

A:

Q: Obtain the Fourier transform of the "switched-on" exponential function shown in Fig. 18.7. f(t) 0…

A: Given:

Q: 13.For an active low RS FLIP FLOP with a HIGH normal output, the value of its S and R inputs,…

A: The Flip-Flop is a device that stores a bit of information. The Flip-Flop changes its state during…

Q: Hand calculate the phasor voltage for VR and Vc1 using the 50 source resistance. Compare the hand…

A:

Q: +10V +3V +10 V 2.7k2 100k2 ㅐㅂ -390 k2 2.2k2 (b) The BJTs in the two circuits have B=100 and |VBE| =…

A:

Q: Output expression of the logic diagram is, A B OA+ AB' OA+ A'B OA' + AB OA+ A'B'

A: The given logic circuit,

Q: The segment of a waveform below the zero reference line is the negative or the negative

A: Waveform- The term waveform is define as the graphical or diagrammatic representation of the…

Q: 9 = B(-1-j2.829) (-1-j2.829 + 1-j2.829) 9 = B(-1-j2.829) (-j5.658) 9 = B(-16 + j0.1768) B =…

A: This is a basic problem of complex equation. The detailed explanation is given in the next step.

Q: Example 12.36. A capacitor of capacitance 10 uF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C =10 μfδ = 10∘f = 50 Hz Find:. Power Factor Angle φcPower Factor cosφc

Q: Example 14.52. An inductor of resistance 10 and inductance 100 mH is in parallel with a 10 nF…

A: Given, Resistance, R=10 Ω. Inductance, L=100 mH. Capacitance, C=10 nF.

Q: Perform the following computation (3.7 -1.2j) +2e/4 and show the result in rectangular form. Script…

A: Given: An expression (3.7-1.2j)+2ejπ/4 To do: Perform the above computation using MATLAB and show…

Q: 7.it is an Level triggered digital circuit whose basic function is memory and is capable of storing…

A:

Q: 8A + Vo61=45 R₂= SS ↓ SA Рђе 20л

A: We need to find out the current for given circuit , we will find out the node voltage then we will…

Q: Write a matrix equation that determines the loop currents shown to the right.

A: It is given that:

Q: 2. Find 1₁, 12, 13, and 14. 6A 4₁ 20 (2 10 (2 3A 4052 4022 14 2A

A:

Q: MESH ANALYSIS 4. Find the currents i₁, i2, and i3. 12 V 4Ω www 12 www 632 10 V www 202

A:

Q: For the op-amp shown in the following figure, if R1 = 100 2 and Rf 1 k2, the overall voltage gain is…

A:

Q: In AM modulation, if the modulating signal amplitude is of 3.08V and carrier amplitude is of 11.54V,…

A: We need to find out the modulation index

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: a. 36.22…

A: Given data: C=2 mFV=524 cos20tt=850 ms

Q: The angle between vector A (2i+3j+k) and ? vector B (i-2j+2k) is 1100 1000 100 2100

A:

Q: 5A V3 O a. 5v1 Ob. 201 www O c. 5v₁ - 492 202 w www Pi V2 2v3 = -2 5v₂ + 2V3 ww = V2 - 2v3 = 4 Od.…

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.