In a balanced three-phase wye–delta system, the source has an abc-phase sequence and Van = 120angle 0° V rms. If the line impedance is zero and the line current IaA = 5 angle 20° A rms, find the load impedance per phase in the delta

Q: compute the Fourier series of the given functions: P(+) = 5-1 -< <o f(t)= ft f(t) -4/2 4/24 + 4 L…

A: Given, f(t) = 3 cos2(t) , for -π ≤ t ≤ π We need to determine the Fourier series of f(t).

Q: In this ideal op-amp circuit, it is given: R1 = 8 ohms, R2 = 98 ohms, R3 = 6 ohms, R4 = 21 ohms, and…

A: Given: In this question, the given details are, The given ideal op-amp circuit is, The given values…

Q: 6. . The phase voltage of a 3-phase voltage source is 120 V. It is supplied to a star connected load…

A:

Q: Q.2: Point charges q₁ +8.0µC, q2--2.0μC and q3 +7.0μC are placed at the vertices of a right- angle…

A: Given below clear explanation

Q: With a block-diagram, write about “TIE-LINE BIAS CONTROL

A: It is asked to write about Tie-line bias control with a block-diagram.

Q: 8. A 2-pole d.c shunt motor operating from a 200 V supply takes a full-load current of 35 A, the no-…

A:

Q: Determine the Zero-Input Response using the Z-transform, given the system described below and its…

A: Given below clear explanation

Q: A capacitor consists of two metal plates each 500 x 500 mm² and spaced 6 mm apart. The space between…

A: Given: Area of the metal plates of the capacitor, A=500×500 mm2=0.025 m2 Distance between plates,…

Q: Consider the moving average filter with length N = 21. For each of the following input signals f[k],…

A: Please post the remaining subparts in another question. Given data, Length N=21 To find:- a) fk=3 b)…

Q: 1. Apply phasor analysis to evaluate the following: a v= [120 sin(10t +20°) + 120 cos(10t - 121°)] V…

A: Given  v = [120sin(10t+200) + 120cos(10t-1210) ]V i = [20cos(2t+200) - 15sin(2t-300) ]A Asked to…

Q: How to find intervals

A:

Q: Since a 100-gain instrumentation amplifier operating at room temperature amplifies a 10μV signal…

A: Given data, Gain of amplifier = 100. Random noise signal = 600μV.

Q: For the given circuit, find vo(t) when (0) = 6 A and v(t) = 0 V. 252 i(t) 0.4 H m 3Ω The voltage…

A:

Q: Determine the Zero-state Response when x(n) = 0.25nu(n)+0.75nu(n-3) using the Z-transform, given the…

A: Given below clear explanation

Q: d. refer to (b), when the frequency of the test tone is changed to 7 kHz and the percentage of…

A: We need to find out the carrier swing for given modulation .

Q: Question 1 In circuit shown in Figure 1, find a) I(t) and vo for t 0 10V DC 2 ohms M t= 0 Figure 1…

A: We need to find out the current and voltage for given circuit .

Q: 5. Electrical polarity at the brushes may be changed by

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: Unit 3: Self-Excited Shunt Generator Select the correct answer for each of the following statements…

A: given are basic questions on motors and generators

Q: Consider the transformer with the secondary terminated in a load resistance R, as shown. This as a…

A: Given data: The load load resistance is RL. The current in the source side winding is I1 and current…

Q: Determine the simplified Expression Using Map Method [DON'T CARE METHOD] 1 F (A, B, C) (3 {(1,2,4,7)…

A:

Q: 10. If a generator is overcompounded and you want to decrease the degree of compounding, then the…

A: simple straight forward questions on DC machines

Q: 3. An FM transmitter delivers, to a 750 antenna, a signal of v = 1000 sin (10° t + 4 sin 10° t).…

A:

Q: Machines 3 phase generator 0.85 lagging jXs =j 12 razo Synchronous 11) 9 MVA pf V+el = 13.1 KV Fa…

A:

Q: H.W 1. a. Determine the thermal voltage for a diode at a temperature of 20°C. b. For the same diode…

A: What is a Silicon Semiconductor Diode? The diode is the simplest bipolar semiconductor device. It…

Q: For a i got 0.8 micro farads for b i got 0.2H for c i got 1.3mAsin400t

A:

Q: ble 1. Voltages in Volt (V) and Currents in milli Ampere (mA) Parameter VL V₂ V3 IG Computed Values…

A:

Q: Problem 3. Given E(y, t) = 6sin (107t - By)a, +9cos (7107t - By)a V/m compute B(y,t) and H(y,t)…

A:

Q: Q2/1 f(t) = u(t) e Find f^-1 Cos (ut) EI

A: In this question we need to find a Fourier transform of the given signal.

Q: Question 3 A dynamic system is represented by the following equation: 4X(t) + 8 x(t) + 16 x(t) =…

A: The dynamic equation of the given system is represented as,  4x··(t)+8x·(t)+16x(t)=sin(5t) The…

Q: ww R1 R=10 Ohm V1 U=150 V. S1- b. What is the current through R₁7 4. Finally the switch is…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: Semiconductor fabrication Consider a wafer of Si crystal which has a uniform boron (B) doping of 1 x…

A: Given: In this question, the given details are, A wafer of Si crystal which has a uniform boron (B)…

Q: 6. If a superheterodyne receiver is tuned to a desired signal at 1000 kHz and its conversion (local)…

A: We need to find out the image frequency of the given receiver .

Q: A capacitor consists of two metal plates each 500 x 500 mm² and spaced 6 mm apart. The space between…

A: Given data, Constant ε0=8.85×10-12 F/m Dimensions 500×500 mm2 or 0.5×0.5 m2 Distance , d1=2 mm=0.002…

Q: 36 V 30 Vo 60 69 6 V In the circuit shown, the voltage Vo is most nearly V21 C V 30 ( V60

A: It is given that:- V0 = ?

Q: Calculate the capacitance of the device shown below where &r1 = 1.5, &r2 = 2.5, &r3 = 3.5, Er4 =…

A: We need to find out the equivalent capacitance for the given diagram .

Q: Q1 using the curves of Fig. 1: a. Determine the voltage across Si diode at a current of 2 mA. b.…

A: The diode voltage can be obtained from the graph based on the diode current. A line is projected…

Q: A germanium P N diode has the following properties: Tp = Tn = 10 μs, N₁ = 10¹⁹ cm³, ND = 10¹6 cm³,…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: A glass isosceles prism is used to change the path of a light ray, as shown in Fig.. If the index of…

A:

Q: For the circuit shown in the figure below, calculate the following quantities. (Assume & = 4.50 V…

A:

Q: On no-load, a shunt motor takes 5 A at 250 V, the resistances of the field and armature circuits are…

A: The current is 5 A The voltage is 250 VThe resistance is 250 ohm and ohm in field and armature…

Q: 3. Solve the following difference equation using z-transform. y[n] + 3y[n 1] + 2y[n-2] = 2x[n] -…

A: Given: Difference equation,  y[n]+3y[n-1]+2y[n-2]=2x[n]-x[n-1],and x[n]=δ[n], All initial conditions…

Q: A balanced, symmetrical, 3-phase, ABC sequence source serves a balanced, symmetrical 3-phase load of…

A:

Q: Find the transfer function, G(s)=0,(s)/T(s), for the rotational mechanical system shown below.

A: The mechanical system can be drawn as

Q: Y(S) = 1 1.551x10-5s+1

A:

Q: A load on 3-wire d.c. system with 500 V between the outers consists of 1500 A on the positive side…

A: Given data: The positive current = 1500 A The negative current = 1300 A The motor connected across…

Q: Find the voltage across the capacitors in the given circuit under dc conditions, where R₁ = 67 Q and…

A:

Q: a) An alternating voltage is given by v = 50 sin (90лt - 0.10), find i) ii) iii) iv) v) vi) vii)…

A: Given      V = 50 sin(90πt - 0.10)

Q: RB 9 Vcc IB B + Rc VBE Vcc E Ic + VCE - Fig.4 A loadline is drawn on the BJT transistor…

A:

Q: Question 01: Derive the circuit of an 8-to-3 priority encoder.

A:

Q: What is the current through R₂? VS1 15V R1 68 22 A. 3.19 A B. 319 mA C. 1.73 A D. 173 MA VA R2 30 22…

A: We need to find out the current through given resistor for given circuit .

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.