In a Brayton cycle based power plant, the air at the inlet is at 27 °C, 0.1 MPa. The pressure ratio is 6.25 and the maximum temperature is 800 °C. Find a. The compressor work per kg of air b. The turbine work per kg or air c. The work ratio d. The heat supplied per kg of air e. The cycle efficiency.

In a Brayton cycle based power plant, the air at the inlet is at 27 °C, 0.1 MPa. The pressure ratio is 6.25 and the maximum temperature is 800 °C. Find a. The compressor work per kg of air b. The turbine work per kg or air c. The work ratio d. The heat supplied per kg of air e. The cycle efficiency.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 12RQ: A gas furnace has an output of 60,000 Btu/h. The return air temperature is 72F, and the temperature...

See similar textbooks

Similar questions

In a lenoir cycle, helium is taken in at 87 K with a pressure ratio of 7.73. The ratio of the volume between the start and end of heat rejection is 2.46. Find the cycle efficiency in %. use R= 8.314 kJ/ kmol -K, k=1.667, mw = 4 g/mol
In a lenoir cycle, helium is taken in at 84 K with a pressure ratio of 7.83. The ratio of the volume between the start and end of heat rejection is 1.96. Find the work net in BTU/lb. use R= 8.314 kJ/ kmol -K, k=1.667, mw = 4 g/moll
show complete and step by step solution with ts diagram illustration. REGENERATIVE CYCLE AN ENGINE
In a gas turbine plant working on air standard Brayton cycle, the air at inlet is at 27°C temperature ,0.1 MPa pressure respectively.The pressure is 6.25 and maximum temperature is 800° C the turbine and compressor efficiencies are each 80%. Find per kg of air; i) The compressor work ii)The turbine work iii) The cycle efficiency iv) The turbine exhaust temperature
In Rankine cycle with reheat steam enters the turbine at 40 bar, 400°C, and expands to 5 bar, where it passeS through a reheater, emerging at 400°C. It then expands to the condenser pressure of 30 kPa. For an ideal cycle, compute Work of pump in kl/kg.
In Rankine cycl e with reheat steam enters the turbine at 40 bar, 400°C, and expands to 5 bar, where it passeS through a reheater, emerging at 400°C. It then expands to the condenser pressure of 30 kPa. For an ideal cycle, compute Work of pump in kl/kg. ..
Air enters an ideal gas turbine cycle at 1 bar and 27 C. The maximum temperature in the cycle is 727 C. Find the cycle efficiency for a compression ratio of 10. [Ans.: 0.482].
A power plant uses steam flowing at 75kg/s to perform power cycle. Both the turbine and the pump operate adiabatically and without irreversibilities. a) find quality at the turbine exit b) find mass flow rate (kg/s) of cooling water through the condenser c) find efficiency of the cycle d) plot the cycle on a T-s diagram, indicate the saturation curve and each state of the working fluid.
A Rankine cycle operates with steam between 20 and 100 deg. C for working fluids of water and Refrigerant 12. The turbine has an efficiency of 70 percent, and the pump efficiency is 60 percent. Find the cycle efficiency, and sketch the T-s and h-s diagrams.
Carnot cycle operates between 30°C and 350°C. Find the cycle efficiency.
In a reheat cycle steam at 550°C expands in an h.p. turbine till it is saturated vapour. It is reheated at constant pressure to 450°C and then expands in a I.p. turbine to 40°C. If the maximum moisture content at turbine exhaust is limited to 10%, find (a) the reheat pressure, (b) the boiler pressure, c) the net specific work output,plss give info as much as possible
In an air standard Otto cycle, the clearance volume is 12 % of the displacement volume. What is the thermal efficiency?