In a certain non-concurrent force system, it is found that EX = -80lb, EY = +160lb, and E Mo = 480lb - ft in a counterclockwise sense. Determine the point at which the resultant %3D %3D intersects the X axis.

Q: 1) Replace the 800-lb force acting at point A by a force- couple system at (a) point 0 and tb) point...

A:

Q: Shown in the following figure is a foldable table loaded by weight “W”. The contact points, B, D, an...

A:

Q: ches and length 4.25 feet transmits 75 HP from an electric motor to a compressor. The allowable shea...

A:

Q: A diver is 21m below the free surface of the sea. The barometric pressure is 101.000 kPa and SG is e...

A: Answer: The pressure exerted on the diver at this depth is 45.185 psi.  

Q: A diverging tube discharges water from a reservoir at depth of 10m below the water surface. The diam...

A:

Q: olve it by matlab software or handwritten solution. 5x -5y 10 z extra stress tensor for Newtonian fl...

A:

Q: A pilot makes an instrument approach into a field at 1200 ft above sea level. The pressure corrected...

A:

Q: Q16. As shown in the image below, a baseball hits a fixed rigid wall at a speed of v1 = 30 ft/s at t...

A:

Q: A diver is 34m below the free surface of the sea. The barometric pressure is 101.000 kPa and SG is e...

A:

Q: Two random particles X and Y were being studied by a bored individual. Upon observing, he defined th...

A: Given Data aX=(5.2t-5.2) m/s2 aY=(11t2-22) m/s2

Q: lever is used to lift a heavy load. When a 25 N force pushes one end of the lever down 1.8 m, the lo...

A:

Q: A steady flow of water (p = 1000 kg/m') is flowing through a reducing pipe bend at 20 kg/s to atmosp...

A:

Q: Determine the ideal air-fuel ratio of an engine wh

A: an octane rating, or octane number ,is  a standerd measure of a fuel s ability to to withstandard  c...

Q: Superheated steam at 90 bar, 625 °C (State 1) undergoes a 3-step process: (i.) First, it is throttle...

A:

Q: An object is to be measured using a basic barometer. If the reading at the top is 725.54 mm and at t...

A:

Q: 1. Steam at 228 °C and with a specific entropy of 6.1351 kg-K kJ undergoes a poly tropic process wit...

A:

Q: Determine the force, in kN, due to water acting on one side of the parabolic gate. Round your answer...

A: Answer: The force due to water acting on one side of the parabolic gate is 141.26 kN.  

Q: Replace the two forces acting on the rectangular solid by a wrench. Write the force R and moment Mas...

A:

Q: A pilot makes an instrument approach into a field at 1200 ft above sea level. The pressure corrected...

A: The pressure at any point in the fluid can be obtained using the formula given below as- P=ρgh where...

Q: refrigerant 22 vapor compression system includes a liquid-to-suction heat exchanger in the system. ...

A:

Q: 5. Two bars are used to support a load. When unloaded, AB is 5 in. Iong, AC is 8 in. long, and the r...

A: The elongation of the A in the downward direction can be calculated using the formula given below as...

Q: What effect does the end shape of the tungsten have on its own welding performance?

A:

Q: 1.6 Homework, 1) What is the weight in newtons of an object that has a mass of (a) 8 kg, (b) 0.04 kg...

A:

Q: Determine the indices for the following crystallographic direction. Must show complete solution foll...

A:

Q: A pilot makes an instrument approach into a field at 1200 ft above sea level. The pressure corrected...

A: Given data Barometer Reading = 30.05 inHg Pilot setting = 29.85 inHg SSL Barometer = 29.92 inHg

Q: In traveling a distance of 3.5 km between points A and D, a car is driven at 87 km/h from A to B for...

A: Acc is found for B to C and separate distances are calculated, added and equated to 3.5 km.

Q: Cold water (cp = 4180 J/kg·K) enters the tubes of a heat exchanger with 2-shell passes and 12-tube p...

A: The main objective of this ε-NTU method is to obtain both the exit temperatures of hot and cold flui...

Q: The structure shown below consists of a brass core inserted into a steel tube of cross section squar...

A:

Q: A thin-plate orifice is used to measure water flow rate. The water temperature is 27 C and a mass fl...

A:

Q: A 3T Diameteð O is 93 mm Diametex ® is 53 mm G, 4니 GPa %3D 610 mm 321 mm Giz 75 GPa twist c/A = 0-27...

A:

Q: if a weldment is heated to correct distort from welding, the maximum localized he

A: if a weldment is heated to correct distortion from welding, the maximum localized heat shall not exc...

Q: 3. Based from the pump performance curve below, calculate the following: a) Specific speed b) Suctio...

A: Given data pump performance curve  Specific speed and Suction Specific speed is to be calculated.

Q: 1. Determine the internal normal force, shear force, and bending moment at point c in the beam. 5 kN...

A:

Q: 1 m 2 m D 3m 3 AN O AN 10 kN a) Draw where you would make a cut to solve for the forces in members F...

A:

Q: 9 m, find: a) The angular speed in rad/s; b) The angle in radians turned by the Ferris wheel in whic...

A:

Q: A steel pipe 150mm external diameter conveys steam at a temperature of 260°C and is covered by two l...

A:

Q: Assume a horizontal shaft handling water at 65 deg C (Pv=2.503 KPa, Density=980.5 m3/kg). The suctio...

A:

Q: The composite shaft shown in the figure is manufacturedby shrink-fitting a steel sleeve over a brass...

A: because of two bar are in parallel angle of twist for both will be same-angle of twist Q= TLGJwhere-...

Q: Situation 02. A ball is thrown at an initial height of 1.26 m, with V, = 32“, measured 30° with the ...

A:

Q: he properties of this Organic Rankine Cycle are as follows:  • Turbine feed: P = 24.49 bar, T = 272....

A: Given that, P1=P2=24.49 bar,T2=272.19 °C,P3=P4=2 bar,T3=203 °C,ηp=65 %   Calculate the volume at sta...

Q: The acceleration of a particle is given by a = 8t - 36, where a is in meters per second squared and ...

A:

Q: Find roller support reaction

A: Given data : The value Point Load =3 KN The value Point Load =22 KN The value Point Load =6 KN   Req...

Q: 2.) a.) Draw the shear and moment diagrams using the area method. b.) label the degree of the curves...

A:

Q: A particle travels along the x-axis whose acceleration is described by the a – x graph, as shown bel...

A: The acceleration-position graph of the particle is given below:

Q: Boeing 767-400ER model airplane has two engines. Each engine can have a maximum thrust (mechanical f...

A:

Q: Describe the environmental impacts of wind power systems and explain how the negative impacts of win...

A:     Solar energy comes in the form of wind. The method of generating electricity with wind energy (o...

Q: Given data : Force=5 N Mass of object=3 kg Determine acceleration

A: Given data : The value of mass of object m=3 kg The value of force F=5 N   To find : Acceleration

Q: Ten cu ft of air at 30 psi and 400°F is cooled to 140°F at constant volume. What is the change in en...

A: Given Data V=10 ft3 p1=30 psi T1=400°F=859.67°R T2=140°F=599.67°R

Q: A steel [E= 30,000 ksi] pipe column with a cross-sectional area of A1=5.60 in 2 is connected at flan...

A: Given: The modulus of elasticity of steel, Es = 30,000 ksi The cross-sectional area of pipe 1, A = 5...

Q: Describe how Foilsim calculates lift and drag.

A: