In a graduated cylinder, if the lowest part of the liquid meniscus falls SLIGHTLY BELOW the line for 8.5 mL, and the next line down is at 8.4 mL, which of the following options is the best way to record this volume?

In a graduated cylinder, if the lowest part of the liquid meniscus falls SLIGHTLY BELOW the line for 8.5 mL, and the next line down is at 8.4 mL, which of the following options is the best way to record this volume?

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter3: Matter-properties And Changes

Section: Chapter Questions

Problem 40A

See similar textbooks

Related questions

Q: Part 1 of 2 Calculate the molar mass of Zn(NO3), Round your answer to the hundredths place. g mol -…

A: We have to calculate the molar mass of Zn(NO3)2 and CH3(CH2)3OH.

Q: How many grams of carbon dioxide can form when a mixture of 5.20 g ethylene (C₂H4) and 5.90 g of oxy…

Q: Select all that apply. Which of the following molecules would be extracted into the organic layer…

A: Solvents are classified into two types -- polar and non-polar.Polar : Solvents with permanent dipole…

Q: 12.70a4 Add curved arrow(s) to complete the next step of the mechanism. Modify the given drawing of…

A: The objective is to find the mechanism and the intermediate formed during the reaction. The reaction…

Q: An unknown compound X has the molecular formula C6H14O. Compound X shows a strong peak in its IR…

Q: How many grams of CO are needed to react with 1.64 mol of Fe2O3? Fe2O3+3CO→2Fe+3CO2

A: The objective of the question is to find out the amount of CO in grams required to react with 1.64…

Q: Arsenate is a polyatomic ion with the chemical formula AsO4. If magnesium arsenate has a chemical…

A: Ionic compound: These are those compounds that are formed by the combination of a metal cation and a…

Q: Another extraction procedure involves extracting the acid first. Fill in the following flowchart…

A: Separation of organic acid and base using aqueous extraction:The organic mixture is dissolved in…

Q: Draw an approximate titration curve of glycine. Label the approximate isoelectric point of the…

A: Titration is a chemical analysis technique that involves adding a solution with a known…

Q: ombustion of CH4 and H₂. For 100 g mol of a gas mixture of 75 mol% CH4 and 25 lculate the total heat…

A: Given mixture has 75% methane and 25% Hydrogen mol mixture So, moles of methane= 0.75 Moles of…

Q: 6. Air (consisting mostly of nitrogen (N₂), oxygen (O₂), and argon (Ar)) dissolves in water due to…

A: The attractive or repulsive forces exist between the molecules are called intermolecular forces.We…

Q: Explain why hydrogen fluoride (HF) has a higher boiling temperature than hydrogen chloride (HCI)…

A: Boiling temperature is the temperature at which a substance converts from liquid to gaseous phase.

Q: Draw the product of the reaction shown below. Use dash and/or wedge bonds to indicate…

A: The objective of the qiestion is to predict the product formed when the following given molecule is…

Q: Draw the most stable form of the organic products formed in the reaction of ethyl acetate and ethyl…

A: A nucleophilic substitution reaction of carbonyl is a type of reaction where a nucleophile replaces…

Q: 2. Draw the complete mechanism for the following reactions, showing the formation of each product.…

A: This reaction proceeds addition elimination mechanism.One major product is formed.The reaction with…

Q: Draw the structure(s) of the major organic product(s) of the following reaction. H H + 2 H₂C=PPh3

A: An arrow always depicts from a region of high electron density to low electron density ; that is…

Q: Match the following molecules with their infrared spectrum on the next two pages by placing the…

A: In infrared (IR) spectroscopy, the vibrational modes of a molecule are probed by observing the…

Q: Draw the complex splitting diagram for the indicated hydrogen and determine the expected splitting…

A: Well, in order to draw a splitting pattern we need to look the neighbouring protons which are…

Q: An aqueous stock solution is 72.0% HNO3 by mass and its density is 1.42 g/mL. What volume of this…

A: The objective of the question is to find out the volume of the stock solution required to make a…

Q: Draw the major product from this reaction. Use a dash and/or wedge bond to indicate the…

A: Allkene reacts with bromine (Br2) and water (H2O) to form a bromohydrin which react with strong base…

Q: hot piece of aluminum at 85°C and mass 15.0g and heat capacity C = 0.901 *K is placed in a container…

A: Mass of aluminium= 15 g Heat capacity of aluminium= 0.901JK/g Initial temperature of aluminium= 85°C…

Q: Using the respective line of best fit and the figure shown below, Calculate the concentration of…

A: A question based on analytical chemistry.. Using the given data the respective line of best-fit is…

Q: 8. Predict the major product formed in the following reaction. Draw the mechanism, using good curved…

A: Benzylic bromination is a chemical reaction in which a hydrogen atom on the benzylic carbon of an…

Q: 6. MgO has the same structure as NaCl. If the radii of O²- and Mg²+ ions are 0.14 nm and 0.07 nm,…

A: The objective of this question is to determine the packing factor, and density of material.

Q: Calculate the osmotic pressure of a 0.182 M aqueous solution of sucrose, II = 5.19 Incorrect…

A: Given:molarity = molar concentration = 0.182 M = 0.182 mol/LTemperature,T =37°C=(37+273.15)K…

Q: 9 > Determine the concentrations of BaBr2, Ba2+, and Br in a solution prepared by dissolving 1.35 x…

A: Information about the question

Q: 12.15 Show how a Grignard reaction can be used to make each of the following compounds,starting with…

A: The required reaction to make the compound is-

Q: Fill in the product below for the net ionic equation that occurs when HCI (aq) is added to sodium…

A: In net ionic equation, spectator ions are not shown.Sodium acetate,CH3COONa is salt of strong base…

Q: Which one of the following is expected to have the smallest molecular dipole moment? °℃ °9 °Û

A: A bond will be polar if there is a significant difference in electronegativity between the two atoms…

Q: What is the molar solubility of MgF₂ in a solution that is 0.250 M in NaF. Ksp for MgF₂ is…

A: The objective of this question is to calculate the molar solubility of MgF2 in a solution that is…

Q: In a proton NMR spectrum, indicate the number of peaks and their multiplicity for the following…

Q: An aqueous solution of methylamine has a pH of 10.62. How many grams of methyl amine are there in…

A: An aqueous solution of methylamine ( CH3 ) has a pH of 10.62How many grams of methylamine are there…

Q: In a 1.10 m gas-liquid chromatographic column the following results were obtained: air, 18.0 s;…

A: The objective of the question is to calculate the theoretical number of plates and the plate height…

Q: Starting with appropriate unlabeled organic compounds, show syntheses of each of the following: (a)…

A: starting compound is phenyl acetylene. Phenyl acetylene contains spC-H bond which is deprotonated…

Q: Draw the major product of this reaction. Igh byproducts. Assume that the water side product is…

A: Here we are required to predict the major product of the reaction

Q: redox reactions: did a reaction occur with Cu(NO3)2 and zinc and Ag?

A: The reaction in which oxidation and reduction takes place is called redox reaction.Oxidation: In a…

Q: Show a bonding picture for the molecule given below: 70 a. Show the orbital overlapping forming a…

A: Sigma bond( ) is formed by the head-to-head overlap of atomic orbitals.Pie bond () is formed by the…

Q: a. How many grams of S are present in 4.41 grams of sulfur hexafluoride? Mass= gS b. How many grams…

A: The mass of the atoms of the element can be calculated by using the ratio of the whole number…

Q: After completing each reaction, the chemicals must be properly disposed of. Which solution CANNOT be…

A: The objective of the question is to identify the chemical solution that cannot be disposed of down…

Q: Me Me X Me Me Me Br Me Me Me Nal, NaOCI EtOH, H₂O HNO3 Асон AICI3

A: Given are organic reactions. The reactions are electrophilic aromatic substitution reactions.

Q: Select only individual atoms, and not the bonds between them. A cumulene has double bonds directly…

A: A question based on molecules. For the given organic molecule, the respective molecular geometry is…

Q: Н. H Axial substituent Н H2 Н он Н H2 OH ОН Most stable Н H Equatorial substituent Н. Н н Н Н Н H2 н…

A: Given are different conformations of same molecule.The name of given compound is cyclohexanol.

Q: Each of the three vinylic protons of styrene is split by the other two, and the J values are found…

Q: - C CH3 CH3

Q: For the three molecules whose structures are given below, C is expected to be the most reactive one…

A: In SN2 reaction, nucleophiles will attack to the electrophilic carbon from the back side of the…

Q: Tiny samples of aqueous solutions are sketched below, as if under a microscope so powerful that…

A: Answer:If Qc > Kc , then the system is not at equilibrium.If Qc < Kc, then the system is not…

Q: Which of the melting point capillaries in the picture below is filled to the proper level for taking…

A: The melting point of a substance is defined as the temperature at which the substance changes its…

Q: 2-butanol + NOx + hv (assume the carbon-hydrogen bond on the carbon adjacent to the carbon with the…

A: The stated reaction is a photolysis of 2-butanol in the presence of nitrogen oxide (NOx). Photolysis…

Q: Give the major products for the reaction. Cl₂ (low conc.) Select Draw Templates More /||||||| C cl H…

A: The addition of halogens like bromine and chlorine to an alkene is called halogenation of alkene.

Q: 1. Draw Newman projection and Fischer projection of the following compound and find the…

A: As per rule I should have to answer only first question in case multiple questions. So I am…

Question

AI-Generated Solution

AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.

Unlock instant AI solutions

Tap the button
to generate a solution

Click the button to generate
a solution

SEE SOLUTION

Similar questions

How many square meters will 4.0 L (about 1 gal) of paint cover if it is applied to a uniform thickness of 8.00 102 mm (volume = thickness area)?
In a graduated cylinder, if the lowest part of the liquid meniscus falls SLIGHTLY ABOVE the line for 5.71 mL, and the next line is at 5.72 mL, which of the following options is the best way to record this volume? 5.710 mL 5.71 mL 5.7110 mL 5.7100 mL 5.711 mL
A beaker is marked with 1mL lines for measuring volume. It is then filled with water such that the bottom of the meniscus rests on the 10 mL mark. What measurement will you record for the water?
If one unknown liquid has a volume of 25mL and the other one has a volume of 35mL, are they the same liquid?
What is the most accurate way to measure 50 mL of a liquid? Make sure to mention the process and the correct equipment.
1. What are the classifications of laboratory apparatus?
The usual dose of digoxin for rapid digitalization is a total of 1.0 mg, divide into two or more portions at intervals of 6 to 8 hours. How many milliliters of digoxin elixir containing 50mcg/mL would provide this dose?
The water level of a graduated cylinder is initially at 10.59mL. After placing a metallic necklace into the cylinder, the water level rises to 27.94mL. Provided that the density of the necklace's material is 10.14 g/mL, calculate the weight of the necklace in ounces. A pound is defined as 16 ounces.
When the buret in the example delivers from 0.06 mL to 40.00 mL. What is the real volume delivered?
The mass of a beaker is 5.333 g. After 5.00 mL of a concentrated hydrochloric acid solution is pipetted into the beaker, the combined mass of the beaker and the hydrochloric acid sample is 11.229 g. From the data, what is the measured density of the hydrochloric acid solution?
Which instrument(s) has (have) the greatest precision for measuring volume: 10 mL graduated cylinder, 50 mL graduated cylinder, 50 mL buret, 10 mL volumetric pipet, or 10 mL graduated pipet? Explain why this (these) instrument(s) have the greatest precision. Which of those instruments would be best if you need to deliver a precise volume into a solution but you do not know ahead of time what that volume would be?
At what temperature would 250 mL of water boil? 1000 mL? Is the boiling point an intensive or extensive property? Explain.