In a low voltage network with mixed loads fed with equal voltage from two sides as shown below, find the location and value of maximum voltage drop in the line with a cross-sectional area of q = 25 mm2. Copper conductors are used in the line with a conductivity of Cu = 56 m/ohm.mm2 and a current density of j = 0.7 A/m

In a low voltage network with mixed loads fed with equal voltage from two sides as shown below, find the location and value of maximum voltage drop in the line with a cross-sectional area of q = 25 mm2. Copper conductors are used in the line with a conductivity of Cu = 56 m/ohm.mm2 and a current density of j = 0.7 A/m

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 10PP: Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of...

See similar textbooks

Similar questions

(b) A 3-phase, 50 Hz, 132 kV overhead line of length 150 km has conductors placed in ahorizontal plane. The diameter of the conductors is 20 mm and assume completetransposition arrangement is applied. (i) Analyse the charging current per phase when the conductors spacing are set at 4 m (ii) Investigate the range of conductor spacing that should be chosen in order to reducethe magnitude of the charging current per phase in Q2 (b)(i) by 5% or more.
A 2-wire d.c. distributor, 500 m long is fed at one of its ends. The cross-sectional area of each conductoris 3·4 cm2 and the resistivity of copper is 1·7μΩcm. The distributor supplies 200 A at a distance of300m from the feeding point and 100 A at the terminus. Calculate the voltage at the feeding end if thevoltage at the terminus is to be 230 V.
A No. 12AWG copper conductor with a two-way length of 500ft is carrying a load of 10A on a 270V, two-wire circuit. Approximate the voltage drop in the conductor. Hint: No. 12AWG has a resistance of 1.62ohms/1000 ft.
A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mii need 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.
A solid cylindrical aluminum conductor 25 km long has an area of 336,400 circular mils. Obtain the conductor resistance at 20C and 50C. Find the AC resistance per Km of the cable at 50C. Assume a skin-effect correction factor of 1.02 at 50 Hz. The resistivity of aluminum at 20C is 2.8x10-8 Ωm
Dont copy paste need new SOLUTIONs.solve with diagrams with clean Handwriting or understanding solutions A single-phase 60-Hz power line is supported on a horizontal crossarm. The spacing between conductors is 8 ft. A telephone line is supported on a horizontal crossarm 6 ft below the power line. The conductors of the telephone line are AWG No. 14 solid copper (d = 1.6277 mm) spaced 2 ft between centers. The conductors of the power line are AWG No. 2 solid copper (d = 0.2576 in). Find the mutual inductance between the circuits and the voltage per mile induced in the telephone line if the current in the power line is 150 A.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC= 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals. [0·0091 μF/km]
What is the maximum length in km for a 3 phase T.L having copper conductor of 0.775 cm2 crass section over which 200 KW at unity power factor and at 3300 V are to be delivered, the efficiency if T.L is 90%, take specific resistance as 1.725 μΩ cm
Determine the ampacity of a No. 12 AWG copper conductor with THHN insulation that will be used in a 277 V, two-wire circuit in an environment with an average ambient air temperature of no greater than 86°F (30°C). Neglect temperature and bundling correction factors.
Q4: A: A string of 3 insulators and the ratio of Ce / C = 0.15 , if the string is connected to 3-0 line voltage of 33 kv: 1- Find the voltage distribution over the unit of the string 2- Find the voltage distribution when the string supplied by a guard ring which capacitance of 0.2 C, 0.15 C respectively to the nearest to the conductor 3- Compare between the efficiency in 1&2 (before and after adding the guard ring) add two air
A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mi. can you tell me what the 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)