Question

The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC= 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals.  [0·0091 μF/km]

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: The initial voltage across a 7.5F capacitor is 4.5V after 0.5 seconds. If the current is described a...

A: Initial voltage Vo=4.5 VC=7.5FAt 0.5s current is given as:

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: 3.31 Find the node voltages for the circuit in Fig. 3.80. C, ML 1S2 4lo 2v V1 V2 11o 4 92 4Ω 1S2 ÷) ...

A: Nodal analysis primarily depends on the application of Kirchoff\'s Current Law (KCL) to various esse...

Q: SO dependent youpe sunce Tx o.S 22V 54

A: Consider the Two nodes V1 and V2 as shown;

Q: The switch in the circuit seen in fig. p7.52 has been in position a for a long time. At t=0, the swi...

A: Figure 1 shows the modified circuit when t < 0.

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: In the following circuit, use two different methods (Nodal Analysis, Mesh Analysis, or using Theveni...

A: Let us find the Nortons's Current (Isc) :

Q: Done 2 of 6 answer. You are allowed a simple calculato Answer: A Problem: Find Io in the following c...

A: The circuit Diagram is shown on the board:At node B, the two 6Ω resistors connected are in parallel ...

Q: Problem 1: derive an expression for the amplitude of the output voltage as a function of R1, R2, c, ...

A: Problem:1 Since this an Amplifier and its amplification factor is infinite. So, voltage at positive ...

Q: At t=1ms is the i=12(a estimated number)/1=12A or is it i=30/2=15A.

A: From the definition of current i(t), it can be expressed as the time derivative of charge q(t). The ...

Q: For this circuit (attached), find the voltages at points A, B, C, D, and E. You may assume all the t...

A: Given data:Redraw the given circuit as shown in Figure 1.

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: The figure attached to this question shows the 1 line diagram of a simple three bus power system wit...

A: Convert the line impedances into admittances, using Y=1/Z 

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: Find i(t) and v(t) for t >0 in the circuit in the figure attached.

A: Write the general expression for unit step function,

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: 1 99% 7:50 PM l Verizon LTE Done 12- Find i(t) and v(t) in the following circuit. You may employ any...

A: Figure 1 shows the modified circuit when t < 0.

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: Problem 2 question 2

A: In this problem, It is said that the value of R1, R2 and C should be physically realistic value such...

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and receiv...

A: The resistance and reactance of each conductors are,

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: Find the Thevenin's equivalent of the following circuit looking through ab. 2Ω 2Ω 2 A

A: To find the Thevenin voltage across the terminals a-b.The given circuit is redrawn as shown in Figur...

Q: A 230-kV, three-phase transmission line has a per phase series impedance of .... (please see attache...

A: We only answer the first three parts of a question on this platform, unless specified otherwise. Sin...

Q: Use source transformation to find ix in the circuit below. (circuit displayed in attachment)

A: We can transform the current source into equivalent voltage source. The value of voltage source is c...

Q: 6- In the following circuit find io (t) t-0 3 A i, (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: Show that the system shown in the figure below oscillates at a frequency of 1 rad/sec.

A: This is a unity negative feedback system. For this system to oscillate at some frequency, we need tw...

Q: problem 2 question 2

A: The given low pass filter is:

Q: I am having trouble with a Differential Amplifier problem that I attached a photo of. I must "Design...

A: For a single input single output BJT amplifier for the gain of +150 we have to make some changes in ...

Q: A load of 1000 kW at 0·8 p.f. lagging is received at the end of a 3-phase line 20 km long. The resis...

A: Given that:

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: A 3-phase line 3 km long delivers 3000 kW at a p.f. 0·8 lagging to a load. The resistance and reacta...

A: Click to see the answer

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

Q: A 200 km, 3-phase transmission line has its conductors placed at the corners of an equilateral trian...

A: (i)  The line to neutral capacitanceGiven values: -The radius of each conductor is given as r = 1 cm...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: he follo miny Cu nd R omptete ミ? 2 2. /2 レ

A: Click to see the answer

Q: 2Ω 4Ω 1H3%(t)に0 - 2A

A: When t < 0, the inductor acts as a short circuit. Let us say that current through the inductor is...

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: Given,The length is 15 km.The inductive reactance is,

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: .il Verizon LTE 7:42 PM ร์ 100%- Done 3- In the following circuit find vc(t) andi,(t) given; v,(1)-2...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle....

A: The conductors are at the corners of right-angled isosceles triangle. So, the distance between the c...

Q: How to convert the following decimal number to numbers with metric prefixes in following below?29) 5...

A: We need to convert the given numbers to numbers with metric prefixes.

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: Electrical Engineering Question

A: Part (A):Given data,

Q: The circuit in the attached image has voltage gain |VL|/|Vi|=170 What is the voltage gain |VL|/|Vi| ...

A: The voltage gain for given circuit needs to be determined.

Q: How was the value of the capacitor derived?

A: Click to see the answer