Answered: In a RC charging circuit, given R = 150…

In a RC charging circuit, given R = 150 Kohm, Supply voltage = 15 V and voltage across the capacitor is 5.6 V after time t = 12 ms. Find the value of the capacitor used.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: 4. Find N-point DFT for the signal h: hy = 8[k – 1] + 1.9 8[k – 6].

Q: Given: 240/120 V , 10 KVA , r1 = 0.13, r2 =0.03 , x1 =0.2 , x 2 = 0.05 ,Pcore= 105 W Required: a. Ef...

Q: Problem 20: Use mesh analysis to find the current through each resistor. Also find the voltage Va. 4...

Q: Q.1. If an RMS current of 5 A at 60 Hz flows through an inductor of 10 mH, what is its average power...

Q: )) The Nyquist Plot of a system G(s) = in a unity feedback loop (Figure 3) is shown in Figure (s+1)²...

A: Answer -

Q: F1 50 V 50 V G 10_AMP D3 D4 T1 V1 220 Vrms 60 Hz 50 v R1 10kQ 50 V 18.33 S1 Key = A Identify the com...

A: GIVEN: A circuit diagram FIND: (1) the components used in the given circuit (2) voltage a...

Q: Given Battery efficiency = 0.80 Average peak hours = 20.16 Peak sun hours/day = 4.5hours Peak ampere...

Q: Determine the state of the diode in the network, then find In and Vp using the simplified model for ...

Q: Prove that the RMS output voltage of Half-wave rectifier with resistive load Vrms = Vs/2

Q: Exercise 3: The current flowing in a pn junction diode at room temperature is 2x10-7A, when the larg...

A: In this question , we have given reverse saturation current of diode ..We have to find out current o...

Q: Consider a discrete-time LTI system with impulse response, h[n] and input signal, x[n] as given belo...

Q: V2 R1 VT 30Vpk SOH2 1. Solve IT, V1, V2, and VT 2. VR, Vc in polar form

Q: 23. Three matched amplifiers are available to amplify a low-level signal. They have the following ch...

A: We need to find out overall noise figure .

Q: 7. Find the Thévenin equivalent resistance Rth between a and b in the circuit shown.

A: The thevenin equivalent resistor can be caluculated by removing the source from the circuit and then...

Q: 4. Find the value of V1, V2 and I from the following circuit. + 12 V - + V - 80 60 V V2 +

A: Given circuit:

Q: RADIO SERIES CIRCUIT V = 2 V Ω %3D V3 = 6 V R3 = 0 I3 = <0 V2 = R2 = 12 = %3D lo = 100 mA Vo = 9 V C...

A: We have given;V3=6VV1=2VIo=100mAVo=9V

Q: 33. a. Find the value of R for maximum power transfer to R for the network of Fig. 9.138 D. b. Deter...

Q: Question 5: You have a 4-bit data input into your cireuit. Your inputs are the data bits d3...d0, wh...

A: The truth table can be formed based on the given condition and the simplified Boolean expression can...

Q: PROBLEMS 1. A six-band resistor has a color code of Red, Blue, Violet, Green, Brown, Black. Determin...

A: This question belongs to basic electrical . It is based on the concept of calculation of resistance ...

Q: Simplify the following functions, and implement them using NAND and NOR gates only: F(A, B, C, D) = ...

Q: A pair of complex-conjugate poles in the s-plane is required to meet the various specifications that...

Q: Ideally, all atoms have the same number of protons and electrons, therefore all atoms are considered...

A: When ideally all the atoms have same number of protons and electrons

Q: = 3.0 x 10-6 C on all points are situated at the corners of a square of Four-point charges bearing q...

Q: Consider a continuous-time LTI system with impulse response, h(t) and input signal, x(t) as given be...

Q: 2Ω 4Ω 3 A( ЗА( 7 A Reference node

Q: Can somebody help me how to read the Voltage of this? Also is this a half-wave? Thank you! We are gi...

Q: 3. When an electrician refers to a voltage as being 1200 V ac, it is understood that he means the ef...

Q: 125

Q: . Determine the principal value of (-j)*. Express the result in polar form.

Q: The American Standard Code for Information Interchange (ASCII) has 128 characters, which are binary-...

Q: +16 V Si Si Si 4,7 k2 4 V

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms. Round y...

Q: Problem 5. Determine the value of Vo 10 42 3Ω 3kN 15V Vo$50 3 ww

Q: Find the line currents in the unbalanced three-phase circuit below and the real power absorbed by th...

A: In this question, Unbalanced load is given. Find the line currents in the unbalanced three-phase cir...

Q: 10. Find Vo in the circuit below using branch current analysis. Vx 12 v(+ 6 V Vo O 2.25 V O 8.25 V O...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Q5. Using the impedance approach, obtain the transfer function Eo(s)/E:(s) of the op-amp circuit sho...

Q: 2) Find the reduce transfer function of the following.

A: This is a basic problem of block diagram reduction The solution is given below

Q: 27. A variable resistor R is connected in parallel with a fixed resistor of 1.25 ohms. The combinati...

Q: 8. Referring to problem 7, find the Thévenin equivalent voltage Vth between a and b. O 14.56 V 9.28 ...

A: (7) To obtain the Thevenin equivalent resistance, the current source is open circuited. Redraw the c...

Q: Question#03: Justify: why electrical isolation and theft prevention are the advantages of non-conduc...

A: 1. The main benefits of non-conductive cable are its isolation from the rest of the system and its r...

Q: What is the probability of error with a PSK system with a bit rate of 20kpbs, BW of 50 kHz, Noise po...

A: The solution is given below

Q: 3) Reduce the block diagram of the system using Mason's Rule. 100 Ris

Q: A 3-phase, slip-ring, induction motor with star-connected rotor has an induced e.m.f. of 120 volts b...

Q: Which term refers to amount of work done equivalent to the energy present in the field of interactio...

A: The Electric Potential Energy, is generally the amount of work done which is equivalent to the fie...

Q: The voltage applied to the circuit in the figure is 1000 V, 50 Hz. Accordingly, calculate a) Circuit...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: 1 Determine the total resistance, current and the voltage across R1 R V 56 N Ω V RT Vs 1.5 1.5 V R2 ...

A: Consider the total resistance of the circuit is, RT=56 Ω+200 Ω200 Ω200 Ω+200 Ω+27 Ω=183 Ω

Q: A three-stage amplifier is to have an overall noise temperature no greater than 70k. The overall gai...

Q: 12. A resistance, inductance and a capacitance of 120uF are connected in series. When the voltage ap...

Q: Plz do all three subparts asap

A: Solution

Q: 85. Find the current in R= 11 2, L= 0•1 H, C= 102 F Connected an RLC- circnit with w hich is to coar...

A: We need to find out current through given circuit

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

In a RC charging circuit, given R = 150 Kohm, Supply voltage = 15 V and voltage across the capacitor is 5.6 V after time t = 12 ms. Find the value of the capacitor used.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
List the five capacitor replacement rules.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC