Answered: In a series RLC circuit, the applied…

In a series RLC circuit, the applied voltage is 108V. At resonance, the frequency is 200rad/sec, and the circuit current is 8.38 A. What is the resistance of the circuit (in Ohms)?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 4RQ: An RC series circuit has a total impedance of 84 . The resistor has a value of 32 . What is the...

See similar textbooks

Related questions

Q: A 3-phase, 50 Hz, 1100 V motor has a total load output of 100 hp and a power factor of 0.78 learning…

Q: A three-phase, 460 V, 98hp 1,60 Hz, four-pole induction machine delivers rated output power at a…

Q: What are two ways of reducing Z0? (last part of the question)

A: In this question we have to provide 2 ways of reducing Z0. As we know that Z0 depends on inductance…

Q: Q1.) Using the Karnaugh map, simplify the function F= Σ (0,1,4,5,7,8,9,15). w.x,y,z yz WX

A: Given function, F=∑w,x,y,z0,1,4,5,7,8,9,15

Q: Briefly explain block diagram of electric drives.

A: So ,First we will understand what do we mean by electric drives and a little bit of history of it.…

Q: For step response of an under damped second order system, the settling times are given as: ts1: for…

A: Given for step response of a under damped system Settling time for 1% tolerance band: ts1 Settling…

Q: A signal is sampled at 384 000 samples per second. The samples are encoded as 32-bit words a)…

A: Given data, Signal fs=384000 or 3.84×105 No. of bits n=32

Q: n which year did 3D printing first become available to the public?

A: The idea of 3D printer was pitched in 1981 by Hideo Kodama of the Nagoya Municipal Industrial…

Q: Write the equivalent voltages in the table below: Peak voltage Average Voltage 170 V 108.29 V 339.36…

Q: A 6-pole motor turns at 1080 rpm when connected to a 60 Hz voltage source. Most nearly, what is the…

A: Step-1--> We have motor speed(Ne)=1080 rpm f=60Hz We know , synchronous…

Q: 3. A load of 40+j55 ohm is connected across a 120-Volt source. Determine the value of the reactive…

A: Given parameters: Load resistance, RL = 40 + j55 ohm Source voltage, Vs = 120 V To find: Reactive…

Q: The total power in an Amplitude Modulated signal if the carrier of an AM transmitter 800 W and it is…

A: Pt = 900 ( W )

Q: Find lo lo = Blank 1 Α 10 V (+ 8 Ω www 1ο 3Ω 6Ω

Q: 18. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12…

Q: 3) For the region of the diode curve greater than the diode's barrier potential, (a) the curve is…

Q: As indicated in the diagram, a 4-bit D/A converter is coupled to a free-running 3-bit up counter: ww…

Q: 3. Find the current value, V₁, V₂, and V.. Vin = 10 V R₂ = 4.7 KQ W M -5V -O V R₂= 2.2 KQ

Q: 3. Clipper and Clamper Circuits 3.1 A diode clipper Diodes may be used in a number of ways to change…

A: Given: A clipper circuit diagram and input output wave forms. we have to discuss about the result…

Q: For the circuit shown in the figure, in which the capacitor is initially fully discharged. If the…

Q: What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is modulated…

A: Given information: The carrier frequency is fc=100 MHz The modulating frequency is fm=1 kHz The…

Q: A 0 0 1 1 A B 0 1 0 1 NAND B C 1 1 1 0 C Using negative logic, convert the data in Table into 1's…

A: Logic Gates:- Logic gates, which carry out the many logical operations needed by every digital…

Q: Some linear system has a transfer function 1(s+6)/(s+7). Determine the Bode plot gain (dB) and phase…

Q: 1. A standard TTL gate performs what logic function for positive logic? 2. If all inputs of a TTL…

A: TTL GATE: TTL(Transistor- Transistor logic), is mainly built up from a Bipolar junction transistor…

Q: What is the equivalent capacitance in nF if three capacitors of 6 nF, 1.9 nF, and 7.4 nF are…

Q: When a second-order system is subjected to a unit step input, the values of = 0.5 and wn = 6…

A: Given: A second order system is subjected to a unit step input with ζ=0.5ωn=6 rad/s

Q: Two wattmeter method is applied to a balanced 3 phase load. Two wattmeter indicate 84.5 KW and 64.7…

A: Given data, Power is given, P1=84.5 KW, P2=64.7 KW

Q: A three phase load is connected in star and connected to a supply of 400 V, 3 Φ 50 Hz. A 250 mH…

Q: draw a multiplier circuit that can calculate upto 32. (urgent)

A: Array Multiplier The multiplier circuit is based on the add shift algorithm. The main advantage of…

Q: An unmodulated AM signal produces a current of 5.4 A. If the modulation is 100 percent, calculate:…

A: Given information: The current corresponding to an unmodulated AM signal is Ic=5.4 A. The depth of…

Q: 3 (a) Determine and sketch the linear convolution y(n) of the following signals both by graphical…

A: Linear Convolution : The fundamental aspect of the linear convolution is to determine the outcome…

Q: TCO4 A resistor R is in series with a parallel LC circuit as shown in the figure. The individual…

A: The equivalent impedance of the circuit is, ZT=XL||XC+RZT=j50×-j25j50+-j25+100…

Q: What is the magnitude of a point charge that would create an electric field of 5 V/m at points 1 m…

A: We need to find out value of charge particle.

Q: a) Inductance is a measure of how much opposition a loop offers to a change in the current in the…

A: (a) Inductance is the property of the material which opposes the change in current it also generate…

Q: What is the natural frequency of the system with the following transfer function? a) On = 2 b) @₁ =…

A: Given system with the transfer function, XsFs=322s2+4s+32

Q: A 1 mA meter D'Arsonval movement with an internal resistance of 100 2 is to be converted into 0-100…

Q: The manufacturer’s manual for a fan motor states that the motor draws astarting current that is 6.2…

A: The starting current of the motor is 6.2 times larger than its running current. Is=6.2Ir The…

Q: the standing wave ratio.

A: Given: lossless transmission line having Za=50Ωlength=4.334mkr=0.4∠45°λ=2m if Vs='100V find 1)The…

Q: The current through the 4.0-kN resistor in Fig. 19–77 is 3.10 mA. What is the 4.0 k2 terminal…

A: It is given that:

Q: 3. A Pure Inductance Of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V…

Q: An unmodulated AM signal produces a current of 5.4 A. If the modulation is 100 percent, calculate:…

A: Given information: The depth of modulation for the amplitude modulation scheme is 100% and the…

Q: The audio signal having frequency 500Hz and voltage 2.6V, shows a deviation of 5.2KHz in a Frequency…

A: We need to find out new deviation for given modulation and

Q: e = v2 40 sin (10*t + 20°) %3D (i) Determine the currents i1 and iz. (ii) Calculate the current is.…

A: The given circuit diagram is shown below: It is given that: e=2×40 sin104t+20° Vor, e=56.568 ∠20° V

Q: 2. For a 0.5μm process technology, for which tox= 15 nm & n = 550 cm²/s- Find Cox, Kn and over drive…

A: Solution !!

Q: Figure 2.2 shows a DMM that can be connected across a power supply to measure its voltage. Assume…

A: Voltage, current, and resistance are just a few of the electrical stimulation that a digital…

Q: A series RL circuit is connected to a 110-V ac source. If the voltage across the resistor is 14 V,…

A: Given data, Source voltage Vs=110 V Voltage across resistor VR=14 V

Q: If R2= 50k ohms, find the values of R1 and C to create a gain of 30 and a cutoff frequency of 15 Hz.…

Q: You construct an L-C circuit that contains a 30.0 mH inductor and a 655 mF capacitor. At t = 0 the…

A: Given data, Inductance L=30 μH or 30×10-6 H Capacitance C=655 μF or 655×10-6 F Charge q=0.4 mC

Q: Answer: 2.49 Answer: R₁ Check R₂ This question will check your understanding of Lecture 4 -…

A: We need to find out voltage across resistor .

Q: 5. Use Karnough maps to find minimal forms for the expressions ry'z + ry'z' + r'y' z' + x'y'z.

A: Given Boolean expression, f=xy'z+xy'z'+x'y'z'+x'y'z

Q: Find the energy stored in the inductor: 24V 1H fig1 60 www + VR

Question

In a series RLC circuit, the applied voltage is 108V. At
resonance, the frequency is 200rad/sec, and the
circuit current is 8.38 A. What is the resistance of the
circuit (in Ohms)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit has a total impedance of 84 . The resistor has a value of 32 . What is the capacitive reactance of the capacitor? XC=Z2R2
A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277 V is connected to the circuit. What is the total circuit current at the resonant frequency?
In an RLC parallel circuit, the resistor has a resistance of 60 , the inductor has a reactance of 180 , and the capacitor has a reactance of 80 . Find the circuit power factor.
You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
An ac source of voltage amplitude 100 V and variable frequency f drives an RLC series circuit with R = 10 Ω , L = 2.0 mH , and C = 25μF. (a) Plot the current through the resistor as a function of the frequency f. (b) Use the plotto determine the resonant frequency of the circuit.
A series RLC circuit contains a resistor with a true power of 18 watts, an inductor with a reactive power of 24 VARS, and a capacitor with a reac- tive power of 34 VARS. What is the circuit power factor?
An RLC parallel circuit has R= 56Ω, XL= 74Ω, XC= 32Ω. What is the value of Impedance?
A series RLC circuit has a resonant frequency of 6 KHz. When it is driven at 8 KHz, it has an impedance of 1 k? and a phase constant of 450. What are (a) R, (b) L, and (c) C for this circuit?
Describe what happens to the current in this RC series circuit as the frequency increases. Explain in general terms why the observed change should occur. (5 sentences)
A series RLC is connected to an AC source. The effective voltages across the circuit components are VR = 10 V, VL = 14 V and VC = 20 V. What is the phase angle (in degrees) in the circuit? Round-off your answer to the nearest ones digit.
Get the phase difference of the two signals. Only the absolute value of the angle is needed.
Find out the cut off frequency f0 and gain H from the circuit Vi, Vo, R1=R2=R, C1=C2=C