In a square container, a lab technician carefully pours vinegar 1.049g/mL and palm oil 0.876g/mL The container and the liquids are then cooled to 0°C. A block of ice 0.917g/mL is then placed floating at the interface, as shown in the figure below. Determine the percentage of ice that will be submerged in vinegar, disregarding any melting or dissolution. Problem 3049)and palm oil 0.876).mLIn a square container, a lab technician carefully pours vinegar 1.The container and the liquids are then cooled to 0°C. A block of ice 0.917ML) is then placed floatingat the interface, as shown in the figure below. Determine the percentage of ice that will besubmerged in vinegar, disregarding any melting or dissolution.piP2

According to Archimedes Principle, when a body is submerged in a fluid system either wholly or…

In a square container, a lab technician carefully pours vinegar 1.049g/mL and palm oil 0.876g/mL The container and the liquids are then cooled to 0°C. A block of ice 0.917g/mL is then placed floating at the interface, as shown in the figure below. Determine the percentage of ice that will be submerged in vinegar, disregarding any melting or dissolution.

In a square container, a lab technician carefully pours vinegar 1.049g/mL and palm oil 0.876g/mL The container and the liquids are then cooled to 0°C. A block of ice 0.917g/mL is then placed floating at the interface, as shown in the figure below. Determine the percentage of ice that will be submerged in vinegar, disregarding any melting or dissolution.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.57P

See similar textbooks

Similar questions

9. Carbon Dioxide and Oxygen is placed each inside a 1m3 tank separated by an isolation valve. Initially, Carbon dioxide has the following properties: P = 20kPag & T = 25°C and that Oxygen has the following properties: P = 30kPag & T = 75°C. If heat is being prevented to escape in the outside surroundings, determine the resulting temperature of the mixture if it is found that after opening the isolation valve, the resulting pressure on both tank is 25kPag. Draw a figure or FBD that will support the problem. Explain each step by step formula.
20 kg of foodstuff initially has a water content of 70% (dry basis). This material is dried to a moisture content of 25% (wet basis). determine how much water is removed from the material?
On a hot summer day, you decide to make some iced tea. First, you brew 1.50 L of hot tea and leave it to steep until it has reached a temperature of Ttea = 75.0 ∘C. You then add 0.975 kg of ice taken from the freezer at a temperature of Tice = 0 ∘C. By the time the mix reaches equilibrium, all of the ice has melted. What is the final temperature Tf of the mixture? For the purposes of this problem, assume that the tea has the same thermodynamic properties as plain water. The specific heat of water is c = 4190 J/kg⋅∘C The heat of fusion of ice is Lf = 3.33×105 J/kg The density of the tea is ρ tea = 1.00 kg/L
A spherical balloon filled with H2 gas to a volume of 3.35x10-2 m3 at 17 °C is carefully lowered into the sea to a depth of 50 m, where the seawater temperature is about 12 °C. Assume the gas is always in thermal equilibrium with the surrounding seawater. The atmospheric pressure at the surface is P0 = 1.013 x 105 N/m2 and the specific gravity of the seawater is 1.03. What is the change in thermal energy of the gas from surface to 50 m below?
(a) How much heat transfer is necessary to raise the temperature of a 0.200-g piece of ice from -20.0C to 130C, including the energy needed for phase changes? (b) How much time is required for each stage, assuming a constant 20.0 kJ/s rate of heat transfer? (c) Make a graph of temperature versus time for this process.
A certain gas at 1 atm and 289 K, has a volume of 2.83M cubic centimeters are compressed into a storage vessel of 0.31 cubic meter capacity. Before admission, the vessel contained the gas at initial pressure of 138.7 kPa and 24 0C; after admission, the pressure increased to 1080.375 kPag. What should be the final temperature of the gas in the nearest Rankine?
In a container with a fixed volume of 2 m3, there is saturated liquid vapor mixed water at a pressure of 100 kPa initially. In this case, three-quarters of the total mass is in the liquid phase. Then the electric heater inside the container is operated. Calculate the electrical work required to evaporate all of the liquid in the container in case of a heat loss of 120 kJ / kg from the container to the environment. Plot the process saturation curves and constant pressure curves on the T-v diagram.
Instructions: Show your entire solution. Indicate which table from the steam tables you utilized in your solution. 10. A piston-cylinder assembly contains a two-phase liquid-vapor mixture of water with an initial dryness fraction of 50%. The mass of the piston is 15 kg with a diameter of 10 cm. The surroundings exert a pressure of 1 atm in the piston. Heat is added to the system under the isobaric process until the piston hits the stops. The final condition of the steam is saturated vapor. Determine the work in kW if the mass of the mixture is 15.938 kg/s.
In an industrial process, 300 kJ of work is needed to compress 4 kg of nitrogen. During compression, 270 kJ of heat is rejected to the surrounding air. Determine the change in specific internal energy of nitrogen. Provide complete solution, with diagram
How to find the given biot constants through the interpolation method from the table given.
1. Fruit juice at 30 ° C containing 5% total solids concentrated via a single effect evaporator. The evaporator is operated in a vacuum at an evaporation temperature of 80 ° C, and 85% quality steam is supplied at 169.06 kPa. The desired concentration of the final product is 40% total solids. The rate of concentrated product leaving the evaporator is 1500 kg / hour. The specific heat of fruit juice is 4.05 kJ / (kg ° C), and the concentrated product is 3,175 kJ / (kg ° C). Count a. The required steam rate is = Answerkg / hour. b. Steam economy when the condensate temperature is released at 90 ° C. = Answer (kg of water evaporates / kg of steam)
A 235-g sample of a substance is heated to 320 ∘C and then plunged into a 105-g aluminum calorimeter cup containing 195 g of water and a 17-g glass thermometer at 12.5 ∘C. The final temperature is 35.0∘C. The value of specific heat for aluminium is 900 J/kg⋅C∘ , for glass is 840 J/kg⋅C∘ , and for water is 4186 J/kg⋅C∘. What is the specific heat of the substance? (Assume no water boils away.)