In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance 5H. The circuit breaker interrupts a magnetizing current of 5 A (peak value). Arrangement shown in figure V-79 kV L-SH mon R=790 www CB C10.02FFIC Fault (F)

In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance 5H. The circuit breaker interrupts a magnetizing current of 5 A (peak value). Arrangement shown in figure V-79 kV L-SH mon R=790 www CB C10.02FFIC Fault (F)

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Figure 3: For questions 6-7 R1 = 20 R3=60 R2 =40 6. What is the total circuit resistance? a) 0.9…

A: Given figure:

Q: Using Euler's equation, show that-: z {in (KØ) } } z sin Ø z² - 2zCos 0 +1

Q: What is the disadvantage of slip ring induction motor...?

A: Slip rings are mechanical devices that enable electrical power and signal transfer from a fixed…

Q: Given a rectangular wave below, obtain the value of the coefficient of the 9th harmonic of its…

Q: 5V 2 ΚΩ Μ I 7 kΩ Ι', ΚΩ 2 9V

A: Given data : The given circuit is shown below,

Q: 包 2. Find, graphically, the convolution between xit) and hit) -_-_X(t) = sint tho -, h(t) = S(t) _ S…

Q: 14.a. A clothes dryer in a one-family dwelling is rated at 6,000 VA. What's the demand load on the…

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh(st) - 1+jt ans: F(W) = √w-złew 6

Q: The minimum size service disconnect for a single-family dwelling is A. 200 A. B. 100 A. C. 60 A. D.…

A: 4 .a. Based on our load we used the minimum size service disconnected for a single - family dwelling…

Q: (+ -15V 15V U1 VEE 741

A: Given data, Input is given, vi=12V, 6 V, 0 V, -6 V,-12 V Circuit diagram is given as,

Q: A single core underground cable has a conductor of radius, ½ dc and a sheath of radius, ½ ds. The…

Q: 5. Find the F.T. of the following periodic signal 3 -2 2

Q: Mathematical Modelling: State Space Representation of Transfer Function Systems 1. Based on the…

A: By using the concept of state space representation we have calculated transfer function of the given…

Q: 6. a. What is the equivalent resistance between points 1 and 2 of the circuit shown is. b. If at…

Q: 6 Find the convolution between X(t) and hit! AXU 4 h(t) st. # -1 y(t) = x (t) htt), the find yew),…

A: Given, The signal x(t) is given below, The signal h(t) is given below,

Q: 4. An LC circuit consists of a 1-uF capacitor and a 4mH inductor. What is its oscillation frequency…

A: Given data, The capacitor (C) is 1μF The inductor(L) is 4mH

Q: What is the function of MCB. Write two advantage and disadvantage of MCB

A: MCB An MCB is an electromechanical switch that operates automatically and is specifically designed…

Q: 2 Find the F.T. of the following Signals (functions) C. f(t) = 35gn (3t) 1 jt d. f(t) = 1 + cos (6H+…

A: For the given time domain signals we need to calculate their fourier transforms by using the…

Q: Analyse the steady state error of the system ( I correct the question now please solve it )

A: For the given unity negative feedback system we need to calculate steady state error. Note : It is…

Q: transistor uses

A: A unipolar transistor uses the orientation to the one pole.

Q: Two three-phase alternators operate in parallel. The rating of one machine is 50 MW and that of the…

A: Must Condition for parallel operation of the generator The voltage phase sequence should be same…

Q: Given the information provided in Fig. 4.123, determine: a. Rc b. RE. C.Rg. d. V CE e. V. B RB 12 V…

Q: EEL 3004C-CM01 Name: Signed: PW 452 In accordance with The Golden Rule, I have neither given nor…

A: Detailed solution is attached with the notes. Thank you.

Q: vi) Calculate the value of V. Define element.

A: In this problem we apply KCL :

Q: What will be the current density of metal if a current of 30A is passed through a cross- sectional…

Q: What is the real component for the equivalent impedance, Zeq, for the following circuit if = 790…

A: Given data, ω=790 rad/s

Q: A negative-sequence Δ-connected three-phase generator feeds a Δ-balanced load. If the load impedance…

A: Given: Ia=(18.43+j12.91) A=(22.5∠35.01°)AZ=(18+j12)Ω In delta connection, line current is 3 times of…

Q: 4. Write nodal equations for V1, V2, V3, V4. Do not simplify. 50 Vi V3 2H 40 3MCT) 吉。 ov 4 V4 222…

A: For the given electrical circuit we need to write all the nodal analysis equations for the given…

Q: 1. A silicon p-n junction is biased as shown below. Determine the depletion width xn in the unit of…

A: Given circuit, From the circuit, The doping in the P region is NA=1019cm-3 The doping in the P…

Q: The switch in the circuit in Fig. P7.1 has been closed for a long time before opening at t = 0. a)…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: The electron number density in a semiconductor varies from 1020 m-3 to 1012 m-3 linearly over a…

A: Given data, μе = 0.135 m2V-1s-1 , The temperature(T) is 300 K. The distance(x) is 4μm

Q: Find the optimal strategies, P and Q, for the row and column players, respectively. Compute the…

A: Given P,Q are the two strategies for the row and colum players To know expeceted pay off E of the…

Q: A 0.9 mA meter movement with an internal resistance of 90 Ω is to be converted into an ammeter. Its…

Q: A CMOS inverter with minimum sized transistors has K₂ = 100 µA/V², Kp = 50 µA/V² and V™n = |VT|= 0.6…

A: For the given inverter we need to calculate the value of inverter switching threshold voltage.

Q: Find the F.T of the following Signals (functions) C. f(t) = 35gn (3t) 1 jt d. f(t) = 1 + cos (6H+ +…

A: Solution is attached with this notes. Thank you. (I feel there are errors in the final answer…

Q: Given the Fourier transform pair xa(t) → Xa(j). You are given only the following -2π100 27100 sec to…

A: Given, The fourier transform pair xat↔XajΩ is,

Q: Fill-in Questions: 1. A full-wave rectifier passes both of a sine wave. 2. In terms of polarity, the…

A: Full wave rectification

Q: An amplifier is connected to a load by a trans mission line matched to the amplifier. If the SWIF on…

A: Given: SWR=1.5 Required: Percentage of the available power absorbed by the load,

Q: A 6 pole generator with wave wound armature has 50 slots each having 20 conductors. The flux per…

Q: Loads, Service, and Overcurrent Protection 6.a. The general lighting load is based on a _______ per…

Q: D13.5. Determine the wave angles 0m for the first four modes (m= 1, 2, 3, n a parallel-plate guide…

A: Solution- Given, d = 2 cm ∈r' = 1 f = 30 GHz βx2+βz2 =β2=ω2μ∈βz =βsinθm, βx=βcosθm To solve…

Q: Find the E.T. of the following periodic signal. -2 -1 1 2

A: Fourier series is used to analyze the frequency response,Harmonics content and Total Harmonics…

Q: Find the F.T. of the fall wing Signals (functions) e(t) = 3 5gh(3+) - Ast +jt ans: F(W) = 4/3 J 30…

Q: (III) Two 9.4-k2 resistors are placed in series and connected to a battery. A voltmeter of…

A: It is given that: R=9.4kΩS=1000ΩVV=3 VVR=1.9 V

Q: Indicate a way to increase the electron concentration and hole concentration in Si crystal.

A: To increase the electron concentration and hole concentration in Si crystal, the crystal is doped…

Q: Calculate line and Gl. If we have: Zcharge = 8.66 +5.00j and VG = 480v2cos(wt) V

Q: 2. How to solve electric circuit analysis using transform method (series circuit analysis & parallel…

Q: 4.Write 10 Difference between squirrel cage and slip ring with your own words...

A: Construction-wise, induction motors are straightforward and robust. The strength and adaptability of…

Q: List basic elements of a digital control system and show the block diagram representation of such a…

Q: Distinguish between serial and parallel processing.

A: Serial Processing: The processor completes one job at a time during serial processing. The other…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance 5H.
The circuit breaker interrupts a magnetizing current of 5 A (peak value). Arrangement shown in figure
V-79 kV
L-5 H
0000
R-790
www
CB
CH0.32PPC
Fault (F)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step.
Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10 and 15 amperes. Assuming IA to be the reference phasor, IB leads IA by 30°, and IC lags IA by 65°, calculate the total current and the angle it makes with the reference.
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step. Please recheck
1.b. In large power transformers, the unequal voltage distribution caused by voltage surges in the winding isprevented by the use ofA. static shields.B. series capacitors.c. low-voltage arresters.
A 47 ohms load resistor is connected in series with 10uF capacitor. At what frequency will the capacitor have a capacitive reactance 10 times greater than the load resistance?
A capacitor and a resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 40 Ω, and the capacitor has a capacitance of 132.6 µF. What is the total current flow through the circuit? What is the impedance of the circuit?What is the power factor of the circuit? How many degrees out of phase are the current and voltage?
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
Given a single phase inductance Lm, 1 phase 12 mH, what is the mutual = inductance between stator phases? (Answer in mH.) Give me correct answer please
What is total admittance and impedance from source side.
Three identical capacitance, each of 150 microfarad, are connected in delta. The value of capacitance in each phase of the equivalent star connected load would be
An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable resistor R and a capacitive reactance of 15 ohm across 100V , 50 hz supply. a. Solve for the frequency so that the magnitude of the inductive reactance is 2 times the magnitude of capacitive reactance. b. Solve for the value of R so that the total current I will be maximum.