Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10 and 15 amperes. Assuming IA to be the reference phasor, IB leads IA by 30°, and IC lags IA by 65°, calculate the total current and the angle it makes with the reference

Q: What is a short circuit explain simply for a dummy? What is an open circuit explain simply for a…

A: Short circuit means we have current flowing in the circuit in unintended path Open circuit means we…

Q: Ri Find transfer function (1/Ei) The transfer function between current and input voltage.

A:

Q: 5-7. Determine the equivalent (total) resistance in the complex circuit below. Show your solution on…

A:

Q: A total current of 60 A is divided among 3 parallel branches having resistances of 10, 6, and 12…

A:

Q: Illustrate a complete timing diagram (i.e., one entire cycle back to the starting states) for a 4…

A: 4-bit ripple counter using T flip-flops with negative edge clock triggers:

Q: 1) Design the bias of MOSFET such that the Q-point is in middle of saturation region. ssume Vtn =lv,…

A:

Q: Determine Vo for the circuit. - 5 V Vo Si 2.2 kN

A: The solution is given below  It's basic problem of diode only.  The Vo= -4.3 V

Q: For the emitter-biased circuit shown, Please solve all subparts aligned in the guidelines: Base…

A: In this question we will find emitter current ,base current and collector current...

Q: Create Karnaugh Map Input Output E Inputs: - $1: (A) $2: (B) - S3: (C) - S4: (D) 0 000 0 0 00 1 0…

A: In this question we need to create k map for given truth table.

Q: r(t) + s + 2 y(t) k s(s – 1)(s + 4) - - Determine the range of k for stability.

A:

Q: A balanced delta loads 5kW at a 0.7 lagging power factor. Find the delta phase impedance if the…

A:

Q: 3- The complex envelope of an AM signal is given by p(t) =Ac (1+m(t)); where m(t)--0.2 + 0.6 sin…

A: Brief description : In communication system modulation is used to vary the carrier signal components…

Q: Use nodal method to find the branch currents l1, l2, 13, l4 and Is in the network shown below.

A: The circuit is as shown below, We have to find the currents I1, I2, I3, I4, and I5.

Q: Question 18 Determine base voltage Vg 10 V 4.3 k2 Vị I B = 100 390 k2 Z +10 V A 0.7 V В) 9.3V 10 V…

A:

Q: Calculate IR drop across 1.2 kohms resistor 30 V Si 120 0 Vour 12= 100 1.2 ko Va= 10v Veg = 0.7 V…

A: In this question,  We need to choose the voltage across the 1.2k ohm resistance.  Assume forward…

Q: L{cosh 2t cos 2t} O 2s /(s^4 16) O 4s /(s^4 + 16) O 2s /(s^4 + 16) O 4s /(s^4 16)

A: Given 12L{cosh 2t-cos 2t}

Q: Question 11: Sketelh a eircuit that uses three full-adders and three NOT gates to calculate the 2's…

A:

Q: write only the option  The electrical power is delivered to the users through five distribution…

A: Some statements are given. We need to choose the correct option regarding to each of the statements…

Q: SELECTOR SWITCH PUSHBUTTON SWITCH R, 250 DISCHARGE PATH CHARGE PATH 24V Ca10pF R=25KO Charge time =…

A: Brief description : Capacitor is an electrical element which is used to store the charges in the…

Q: 3 2 + V2 is v5 70 24 V + Vi

A: We need to find out current and voltage and power for given circuit

Q: An LTI system has frequency response H(2) = 1+72n 1+70.512 a. Plot |H(N)| and /H(2) b. Is this…

A: Given,

Q: L{2 sin(t) cos(t)} s2+4 1 s2+4 s2+1

A: We need to find out Laplace transform of given signal

Q: Q1/b: the inverter always produce: Q1/c: SVPWM have Q1/d : the binary number of the sectors…

A: As per the guidelines given to us, we can only provide the solution to the three subparts of the…

Q: A balanced abc-sequence Y-connected source with Van = 100430°V is connected to a A-connected…

A: In this question, we will find phase and line currents for given star connected source and delta…

Q: A load impedance ZL = 25 – j50 N is connected to a 50 Q transmission line. Insert a shunt capacitor…

A: Transmission Line: A transmission line is a specialised cable or other structure used in electrical…

Q: The rotor of a 4-pole, 50 Hz, 3-phase slip-ring induction motor has a resistance of 0.252/phase and…

A:

Q: An inductive coil with a resistance R and inductance L is connected in parallel with a 30-ohm…

A: The solution is given below

Q: If the current through x ohm resistance in the circuit is 5A, find the value of x. x ohm 12 ohm 135…

A: In this question we need to find a value of x.

Q: Problem No.4 21 3] show that A - 2A? - 9A = 0 but A? - 2A - 91+ 0 A= 1 -1 2 1 2 1

A: The solution is given below

Q: what is the cutting line of a series clipper (biased and unbiased)?

A:

Q: For an AM envelope with a maximum peak voltage of 52 V and a minimum peak to peak voltage of 24 V,…

A: For an AM envelope with a maximum peak voltage of 52 V and a minimum peak to peak voltage of 24 V,…

Q: 5. How many kWh of energy does a 550W toaster use in the morning if it is in operation for a total…

A: This problem is from electrical power generation

Q: An impedance coil draws an apparent power factor of 50 volt ampere and as active pwoer of 40 W.…

A:

Q: 10121 9. D) Fuid V,,Vz- 24 IV/ 40 1.21 ن یي

A: We will apply the nodal analysis technique to solve the question. We assume the voltage at node c to…

Q: V, volts 12 3, metros <-5 12

A: We need to find electric field for given potential

Q: A Phase modulator has a carrier signal of ec = 100 cos [2t(735 x 103)t] and phase deviation constant…

A: According to the signal, for the given phase modulation, we need to find a. The effective voltage of…

Q: r(t) + s+ 2 y(t) k s(s – 1)(s + 4) - Determine the range of k for stability.

A: Given:

Q: a coil with resistance Rl and reactance Xl is connected in series R supplied by a 250 V 60 hz…

A:

Q: Problem Solving: Solve the following word problems showing detailed solution (with equatio and…

A: In this question,  We need to determine the calculate the equivalent resistance R as shown in the…

Q: Z1 = 55+ j902, I, = 25230°A, R2 Let V, = 302- 20°V, %3D = 902, R3 = 852, X2 = -402, N1 = 3, and N2 =…

A: The given circuit diagram is shown below. Given values of parameters are, Is=25&lt;30° A.…

Q: 1. What is the function of Circuit Breaker? List different types of circuit breaker for High Voltage…

A: Circuit breakers:-  Circuit breakers are mechanical (or automatic now a days) devices designed to…

Q: Given a circuit below and values: R = 20 ohms XL = 13 ohms XC = 38 ohms admittance = 7.1141…

A: In this question we need to find the angle and state the phase relation for current &amp; voltage in…

Q: 3. Given the equation: (x² + y² + 1)dx + x(x – 2y)dy = 0 %3D

A:

Q: three impedance Za, Zb and ZC are connected in parallel. If at 60 Hz, Za=0+j8; Zb=0-j2 and Zc=5+j0…

A:

Q: Part A - Calculating the output voltage of a difference op-amp circuit Learning Goal: To analyze…

A: Part A  The given circuit is shown below: The voltage at the node b,  Vb=R2R1+R2VxVx=100 mVR2=100…

Q: The DTFT of x(n) = u(n) 1-ae 10 1-e-ja 1-e-jn 1 1- eln

A:

Q: Use nodal method to find the branch currents Ii, I2. I3. la and Is in the network shown below.

A: Given circuit is as shown below: We need to find the indicated branch currents.

Q: = {3 nC/m³ 1 srs3 0 1>r> 3 2. A volume charge distribution is defined as Pv %3D Determine: E…

A: We will find out electric field and stored energy for given charge distribution

Q: Q1)A 3 phase induction motor is wound for 6 poles and is supplied from 50-Hz system. Calculate 1.…

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: A 3 phase induction motor is wound for 6 poles and is supplied fromn 50-Hz system. Calculate 1) the…

A: Consider the formula for the speed of the rotor as, Ns=120FP

Magnetic Moment

The magnetic moment is defined as the alignment of a magnet and its strength when the magnet is creating a magnetic field. There are number of examples of the magnetic moment, few are a current carrying conductor in the form of coil, elements at microscopic levels like electrons and many more.