In a typical all wheel drive automatic transaxle, what controls the transfer clutch?a. Transmission control unit operating the pressure regualtor valveb. Engine computer controlling the line pressure to the various clutches in transmissionc. Transmission control unit and the duty solenoidd. Front axle speed sensor and vehicle speed sensor.

In a typical all wheel drive automatic transaxle, what controls the transfer clutch?a. Transmission control unit operating the pressure regualtor valveb. Engine computer controlling the line pressure to the various clutches in transmissionc. Transmission control unit and the duty solenoidd. Front axle speed sensor and vehicle speed sensor.

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter44: Four- And All-wheel Drive

Section: Chapter Questions

Problem 15RQ: Which of the following could cause the 4WD indicators not to operate correctly? a. A faulty control...

See similar textbooks

Similar questions

Technician A says a purpose of a lockup piston clutch is to improve fuel economy. Technician B says a lockup piston clutch is designed with a damper assembly to transmit driving torque and absorb shock. Who is correct?
Technician A says that the clutch-style limited slip differential uses a multi-plate clutch pack between each side gear and the differential case. Technician B says that if the clutch discs are worn, rotating torque will be higher than specifications. Who is correct?
What is the purpose of a clutch in a vehicle transmission system?
the number one cause of clutch disc failure
A clicking noise during transmission/transaxleoperation may be an indication of .
the transfer clutch in the all-wheel-drive automatic transaxle takes the place of the _________? A.Transmission B.reduction gears C.torque converter D.interaxle differential
Which type of transmission uses pulleys to change engine speed? Dual-dutch Manual Continuously varaible Automatic
Which of the following would not cause noise while driving in 2WD under a heavy throttle? a. Faulty ignition switch b. Worn transfer case clutch c. Inoperative locking hubs d. Bad front half shaft
While checking the engine and transmission mounts on a FWD car: Technician A says that any engine movement may change the effective length of the shift and throttle cables and therefore may affect the engagement of the gears. Technician B says that delayed or missed shifts are caused by hydraulic prob lems, not linkage or control problems. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
While diagnosing the cause of TCC shudder: Technician A checks the fluid pressure sent to the clutch. Technician B says that because the shudder occurs only after the clutch is engaged, the problem is the engine, transmission, or another component of the driveline. Who is correct?
when adjusting a heavy-duty pull type manual adjusting clutch what is used to compensate for normal clutch facing wear.
What are the 4 main function of the clutch?