In abalanced Three Phase System The Source is balanced Wye With an abc – Phase Sequence and Vab = 215 250 Vrms The Load is balanced Wye paralle with ablaned delta . the phase impedance of Wye is 9 + j3 and the phase impedance of the delta is find the line impedance 1+ j0.8 Q find the line currents and phase currents in load .

In abalanced Three Phase System The Source is balanced Wye With an abc – Phase Sequence and Vab = 215 250 Vrms The Load is balanced Wye paralle with ablaned delta . the phase impedance of Wye is 9 + j3 and the phase impedance of the delta is find the line impedance 1+ j0.8 Q find the line currents and phase currents in load .

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Given: A balanced-Y load is in parallel with a balanced-D-connected capacitor bank. The Y load has an impedance ZY=(3+j4) Ω per phase, and Its neutral is grounded through an inductive reactance Xn = 2 Ω. The capacitor bank has a reactance XC = 30 Ω per phase.Draw: the sequence networks for this load and calculate the load-sequence impedances.
A balanced positive-sequence three-phase source hasvan(t)=100 cos(377t+90°) V a. Find the frequency of this source in Hz. b. Give expressions for vbn(t) and vcn(t) c. Repeat part (b) for a negative-sequence source.
Given a balanced three-phase system - Δ-connected load with an impedance of 12 + j9 Ω/ϕ - Y-connected source - with an acb sequence - source voltage in the b-phase: 240∠-50⁰ - line impedance: 1 + j1 Ω/ϕ Determine the current in the a-phase of the load IaA BLANK A (rms) EXPRESS YOUR ANSWER IN POLAR FORM
In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 150 ∠35° V. The line impedance per phase is 0.8 + j2.5 Ω, while the per-phase impedance of the load is 8 + j12 Ω . There is post followeing this question
Star connected source with 3-phase balanced positive phase sequence feeds the delta connected system. The source phase voltage is given as Van=120∠80Vrms. If the line impedance is given as RL=0.2+j0.5 and the impedance of each phase of the balanced load is Z=6+j8 a) Find the amplitude of the current in the delta load? b) Find the amplitude of the voltage VA? c) Find the angle of voltage VA? d) Write the angle of the IAB current in degrees?
A balanced three-phase source having a line voltage of 208-Vrms is supplying two parallel-connected three-phase loads. The first load is a balanced delta of impedance 21 angle 30° ohms per phase and the second load is a balanced wye of impedance 9 angle -60° ohms per phase. Find the magnitude of the rms line current(in Amperes) and the total average power absorbed by the load(in kW).
In a balanced three-phase wye–delta system, the source hasan abc-phase sequence and Van = 120angle 0° V rms. If the lineimpedance is zero and the line current IaA = 5 angle 20° A rms,find the load impedance per phase in the delta.
A balanced delta connected load having an impedance 20+j15 ohms per phase is connected in parallel with a balanced wye connected load with an impedance of 12-j6 ohms per phase. the two loads are supplied by a 230V, 3 phase source. find the current at line "c" and the total power factor of this system.
Apply single-phase equivalency to determine the line currents in the Y-Δ network in the figure below. The load impedances are Zab = Zbc = Zca = (25 + j5) Ω, and the transmission line impedance is ZTL = 3Ω.
A balanced star-connected source has phase voltage Vab = 416 ∠30o V and a positive phase sequence. If this is connected to a balanced delta-connected load, find the line and phase currents. Take the load impedance per phase as “D” Ω and line impedance per phase as “E” Ω.
In a balance three-phase system, the source has an abc-phase sequence and is connected in delta. The line connecting the source to the loads has an impedance of 1+ j2 ohms per phase. There are two loads connected in parallel. Load 1 is connected in wye, and the phase impedance is 4 + j2 ohms. Load 2 is connected in delta, and the phase impedance is 12 + j9 ohms. The phase current Ib1 in the wye load is 16<45 A. . Find the phase voltages of the source and the line currents. Write your values in polar form.
Can you please solve the d e f parts? Three symmetrical three-phase loads are connected in parallel. Load 1 is connected in Y with an impedance of 400 + j300Ω / φ, load 2 is connected in with with an impedance of 2400 - j1800Ω / φ and load 3 is evaluated at 172.8 + j2203.2 kVA. Loads are supplied from a distribution line with an impedance of 2 + j16Ω / φ. Size of the voltage between the line and the neutral conductor at the end of the charge the line is 24√3 kV. The operating frequency is 50 Hz.(a) Calculate the line currents and the phase currents of the loads.(b) Calculate the total complex power at the receiving end of the system.(c) Calculate the total complex power at the transmitting end of the line.(d) Calculate the values of the compensation capacitors which are connected from the line to the neuron at the load end of the system so that the power factor at the load end reaches pf ≥ 0.98.(e) What if the capacitors are connected from one line to another? What would be the best…