Answered: In an AC circuit, the power factor is…

In an AC circuit, the power factor is the factor by which the apparent power is multiplied to obtain the O reactive power O wattful power O apparent power O wattless power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.24P: A source supplies power to the following three loads connected in parallel: (1) a lighting load...

See similar textbooks

Related questions

Q: The effective value of the sinusoidal voltage across a certain network is 32 V rms and the peak…

A: Given data, Ip = 24 mA. Vrms = 32 V. P = 0.48 W.

Q: Consider the following circuit, supplied by a 10VRMS voltage source with a 0° phase shift (i.e.…

A: Consider the following circuit, supplied by a 10VRMS voltage source with a 0° phase shift (i.e.…

Q: The power factor is the cosine of the phase difference between voltage and current: pf = cos(0, 0;)…

A: We need to prove that power factor is the cosine of the phase difference between voltage and…

Q: 6) In the circuit below, what is the complex power supplied by the source and the power factor of…

A: Given that VL = 480 vrms P1 40kw at 0.84 lag S2 = 40Kva at 0.9lead

Q: Calculate the value of reactive power (in VAR) of a circuit having power factor of 0.8, when the…

A: Given, Reactive power, S= 200 VA Power factor, cosϕ=0.8 So, ϕ=cos-10.8=36.8690

Q: Estimate the power factor and the apparent power of a load whose impedance is Z = 60 + j40 Ω when…

A: The solution can be achieved as follows.

Q: What should be the kVA rating of a capacitor which would raise the power factor of load of 100 kW…

A: Answer for the question is below

Q: Load of 400 kW is operating at 0.68 leading power factor. The apparent power of the load is…

A: Here i have derived the apparent power from the information given.

Q: 11.46 For the following voltage and current phasors, calculate the complex power, apparent power,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 9. The effective voltage across a circuit element is (20 + j10)V and the effective current through…

Q: Given an AC source having a voltage v(t)=5sin(178t + 43°) V, find the frequency of the voltage…

Q: For the circuit shown in figure beside, find the total average power delivered to the circuit? * J5…

Q: In an AC circuit, V = (200 + j40) V and I = (30 – j10) A. The active and reactive power of the…

A: Given an ac circuit having, Voltage, V=200+j40 V Current, I=30-j10 A

Q: 4. From the following circuit calculate the total: (a) apparent power, (b) reactive power and (c)…

A: The given circuit is a simple parallel circuit in which we will first calculate value of I1 and I2.…

Q: 1. v(t) = 150 cos(50t) V and i(t) = -20 sin (50t – 30) Calculate the following a. Average power b.…

Q: 4) Determine the real power, reactive power, apparent power, and complex power absorbed by each…

Q: Find the source voltage Vs. the apparent power, complex power, average power, reactive power, and…

A: In this question we will find source voltage , power produced by source and capacitance connected in…

Q: The values of the elements for the given circuit are given below. The maximum average power that can…

A: The given circuit is shown below. We need to calculate the maximum power transferred to the load…

Q: In a Y-connected ac generator, each phase voltage has a magnitude of 135 VRMS, then the magnitude of…

A: Given: A Y-connected ac generator has, Phase voltage, Vph=135 V.

Q: Given an AC source having a voltage v(t)=28sin(305t + 30°) V, find the frequency of the voltage…

A: we need to find out frequency of the voltage waveform.

Q: he Thevenin impedance of a source is 7Th = 101+ j 58, while the Thevenin voltage is VTh = 264 + j365…

Q: The input of an AC circuit having power factor of 0.8 lagging is 40 kVA. The power drawn by the…

A: Given S = 40 KVA PF = 0.8 LAG

Q: Find ZL. And Find the maximum average power transferred to the load. L=j1Ω Both R=7Ω

A: Above given circuit is a R-L circuit. In ac circuits having energy storage elements like L and C…

Q: For the circuit shown in figure Calculate (a) the power factor (b) the average power delivered…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Example: Find the rms value for the voltage waveform given by v(t)=50+30 Sin 0.

A: Voltage wave form is given by v(t)=50+30sinθ

Q: A load with true power of 500kW is driven by a 4kV source. The power factor is 0.6 lagging. A…

A: In this question , we will find change in current due to adding capacitor for power factor…

Q: For the entire circuit in Figure, calculate: (a) the power factor (b) the average power delivered by…

Q: Problem #4: For the circuit shown below determine the average power delivered to R1 and R2, if the…

A: Given that Electrical network as follows

Q: Q3) Determine the value of impedance Zo for transferring the maximum power. Calculate the average…

Q: Calculate the average (P) and reactive (Q). Consider, v(t)=3.5 cos(600t−120∘) V and i(t)=2.3…

Q: Calculate the apparent power, real power, and reactive power for the circuit shown in Figure. Draw…

A: The circuit diagram is, a). f = 50 Hz, Determining the total impedance of the circuit,

Q: 22 -/5 Q J6Ω. 50/50° V (+ 10 Ω 8Ω

A: Concept: 1) Power factor VIcos∅VI=cos∅ 2) Active power =VIcos∅ watts 3) Reactive power= VIsin∅ VAR…

Q: If a Load absorbs an average power of 8 kW at a lagging power factor of 0.8, then the complex power…

Q: a) What load impedance ZL will draw the maximum average power from the source shown in the following…

A: The given AC circuit is,

Q: Find the average power, the reactive power, and the apparent power absorbed by the load in the…

Q: 4. In a system with P = 80 kW and Q = 30 KVAR. Determine the power factor.

A: given p and q

Q: Determine the average power supplied by the dependent source in the following circuit. 20 3 N 20/0°…

A: Given

Q: Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW and 50…

Q: Determine the power factor of the entire circuit of as seen by the source. Calculate the average…

A: Given circuit is -

Q: RE VR v, = Vm sin(m1) L + *I +

A: Given data The rms voltage is Vrms = 140 V Frequency is f = 50 Hz Resistance is R = 100 ohm…

Q: Calculate the real power P, reactive power Q and apparent power S, include units and show…

Q: Question 1/13 Answer is mandatory A load Z draws 12 kW at a power factor of 0.707 lagging from a 230…

A: The solution for given problem is as follows.

Q: Problem 6 (AC Power Analysis) Find the complex power (S), apparent power (S), real power (P),…

A: In this question, In this circuit, find the complex power, apparent power S, real power P and…

Q: An AC source of RMS voltage 20 V with internal impedance Z, = (1+2j) Q feeds a load of impedance Z,…

A: Given circuit is -

Q: Calculate the apparent power, real power, andreactive power for the circuit shown in Figure.Draw the…

A: From the given circuit,

Q: INSTANTANEOUS AND AVERAGE POWER In the circuit of figure below, calculate the average power absorbed…

A: We need to find out power for given circuit.

Q: calculate the current (I) flows for each passive element in polar form. compute the average power…

A: given: source current =7sin(377t+70) resistance ,R=20 ohm inductance,L=180mH capacitance ,C=85micro…

Q: e. Verify Kirchhoff's voltage law around the closed loop. f. Find the average power delivered to the…

A: To find the voltage across all elements and verify the Kirchhoff's voltage law

Q: A sinusoidal voltage source V = 46 /115° Vms feeds an impedance with a current I = 2 /52° Ams- The…

A: Given Vrms=46∠115 Volt Irms=2 ∠52 Amp θv=115 θi=52

Q: Which of the following AC power parameters is the closest equivalent to the DC power drawn by the…

A: ac power parameters is closest equivalent to the dc power drawn by the circuit=?

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

In an AC circuit, the power factor is the factor by which the apparent power is multiplied to obtain the
O reactive power
wattful power
O apparent power
O wattless power

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

solve for the total complex, apparent, average, and reactive power. sketch the power triangle
Power Electronics A sinusoidal voltage source v(t) = 240 sqrt(2) sin(2pi60t) V is applied to a non-linear load, giving rise to a current i(t)= 10sin(2pi60t) + 5 sin(4pi60t) A. Determine: (a) the power absorbed by the load
An AC series circuit has R=300 ohms, L=0.90H, and C=2.0microfarad with a generator of 50V andw= 1000 rad/sec. Find: a). The overall power factor( indicate if leading or lagging) b). The total voltage drop across the resistor, the capacitor and inductor c). The total power dissipated by the circuit
A series generator delivers a power of 6.25kW and a load resistance of25Ω. If RA=0.05Ω and RS=0.025Ω, calculate the generated emf.
Determine the total complex, apparent, average, and reactive power. Sketch the power triangle
The total reactive power of an AC circuit having power factor of 0.85 leading is 40kVAR. The true power drawn by the circuit is: PS: please write in detailed solution.
Calculate the value of reactive power (in VAR) of a circuit having power factor of 0.8, when the apparent power of the circuit is 200 VA.
A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° ohms. Find the capacitance of a parallel capacitor that will correct the overall power factor to 0.9 lagging.
What is the power factor in a system if the source voltage and current have the following values v(t) = 120 sin (377t + 20degrees) and i = 60 sin(377t - 45 degrees) 0.423 leaeding 0.423 lagging 0.906 Lagging 0.906 leading
The power factor is a ratio of apparent power to the real power Select one: True False
A voltage v = 120 sin 377t V is applied across a pure capacitance of 100μF, Determine average power supplied by the source from t=0 to t=0.01 sec
When can an ac-voltage, v = 120 sin120πt reach its first peak? a. 4.167 μs b. 8.334 μs c. 4.167 ms d. 8.334 ms